Comments, with reply, on `Lyapunov stability designs for switchingregulator/low-pass filter system' by M.L. Brooks

Erroneous conclusions reached in the original paper (see ibid., vol.25, no.5, p.602-10, Sept. 1989) concerning the applicability of the Rough criterion in studying the stability of fourth-order linear systems and its relationship with Lyapunov's stability tests are corrected. A brief review of relevant theory is presented, and faults in the analysis that led to these conclusions are identified. The relationship between the Routh criterion and the second method of Lyapunov is reviewed, and a correct application of the Lyapunov method is presented. It is shown that contrary to the conclusions of the paper discussed, these two methods are equivalent for any linear, time-invariant system, including the fourth-order system in question     

Fuel Savings in the WHECON Attitude Control System Using an Asymmetric Controller

This paper investigates the possibility of generating an on-off limit cycle mode in the WHECON attitude control system. lt is shown that, by eliminating the off set angle ? in the roll-actuated control torquer, the WHECON system can be reduced to the structure considered earlier by Mendel and, therefore, an on-off limit cycle can be generated simply by introducing an appropriate amount of asymmetry into the deadzone characteristic of the WHECON controller. Because with this mode of on-off limit cycle the thruster jets will fire only once in each cycle of the oscillation, it is claimed that a considerable amount of fuel can be saved by the proposed modifications to the original WHECON design. Dynamic simulation study was conducted with the actual nonlinear model of the WHECON system considered and the results indicate that, for both zero and nonzero values of the off set angle ?, substantial fuel savings can be achieved by using the asymmetric controller.     

Ultraviolet spectrometer experiment for the Voyager mission

The Voyager Ultraviolet Spectrometer (UVS) is an objective grating spectrometer covering the wavelength range of 500–1700 Å with 10 Å resolution. Its primary goal is the determination of the composition and structure of the atmospheres of Jupiter, Saturn, Uranus and several of their satellites. The capability for two very different observational modes have been combined in a single instrument. Observations in the airglow mode measure radiation from the atmosphere due to resonant scattering of the solar flux or energetic particle bombardment, and the occultation mode provides measurements of the atmospheric extinction of solar or stellar radiation as the spacecraft enters the shadow zone behind the target. In addition to the primary goal of the solar system atmospheric measurements, the UVS is expected to make valuable contributions to stellar astronomy at wavelengths below 1000 Å.     

Dynamics and control of an orbiting flexible mobile manipulator

This paper presents a Lagrangian formulation for studying the dynamics and control of the proposed Space Station based Mobile Servicing System (MSS) for a particular case of inplane libration and maneuvers. The simplified case is purposely considered to help focus on the effects of structural and joint flexibility parameters of the MSS on the complex interactions between the station and manipulator dynamics during slewing and translational maneuvers. The response results suggest that under critical combinations of parameters, the system can become unstable. During maneuvers, the deflection of the MSS can become excessive, leading to positioning error of the payload. At the same time the libration error can also be significant. A linear quadratic regulator is designed to control the deflection of the manipulator and maintain the station at its operating configuration.     

Reducing Undesirable Effects in the Human Centrifuge

The human centrifuge is used to train pilots and astronauts for flights where they are subject to large accelerations. This paper deals with the problems of simulating such linear accelerations with a rotating device and presents suitable means of reducing undesirable simulation error. The advantages of using three gimbals rather than the usual two are considered. Numerical results illustrate the problems of simulation and the improvement achieved by the use of a third gimbal.     

Switchless Control Strategies for Minimum Time Frequency Transitions in Phase-Locked Loops

The problem of minimum time frequency transitions in phase-locked loops with both phase and frequency controls applied is investigated using Pontryagin's maximum principle. Typically, a type II secondorder loop with a damping ratio of 0.707 subjected to a step change in the frequency of its input signal is considered and switchless control strategies that force the transients in the loop to settle down in minimum time are obtained.     

High energy particle dispersion events observed by interball-1 and -2

Time period from October 1996 until January 1998 was checked on high energy resolution DOK2 energetic particle instrument measurements on Interball-1 and Interball-2 for the ion (> 20 keV) dispersive events (EDIS) with the exclusion of Interball-1 orbit parts in the tail. A variety of energy dispersive events, both in ion and electron spectra with different duration is found in the auroral regions, in the outer magnetosphere and near the cusp. While EDIS were observed in all sectors of MLT, the best conditions for their observation were in the afternoon local time. The characteristics of dispersive events observed by DOK2 are consistent with their explanation by the gradient-curvature drift of particles from the injection point(s) in the night local time sector given in Lutsenko at al., 2000a, b.     

Tapped-inductor filter assisted soft-switching PWM DC-DC power converter

A novel high-frequency transformer linked full-bridge type soft-switching phase-shift pulsewidth modulated (PWM) controlled dc-dc power converter is presented, which can be used as a power conditioner for small-scale photovoltaic and fuel cell power generation systems as well as isolated boost dc-dc power converter for automotive ac power supply. In these applications with low-voltage large-current sources, the full-bridge circuit is the most attractive topology due to the possibility of using low-voltage high-performance metal-oxide-semiconductor field-effect transistor (MOSFET) and achieving high efficiency of the dc-dc power converter. A tapped-inductor filter including the freewheeling diode is newly implemented in the output stage of the full-bridge phase-shift PWM dc-dc converter to achieve soft-switching operation for the wide load variation range. Moreover, in the proposed converter circuit, the circulating current is effectively minimized without using additional resonant circuit and auxiliary power switching devices. The practical effectiveness of the proposed soft-switching dc-dc power converter was verified in laboratory level experiment with 1 kW 100 kHz breadboard setup using power MOSFETs. Actual efficiency of 94-97% was obtained for the wide duty cycle and load variation ranges.     

Optimal Inputs for Nonlinear Process Parameter Estimation

The sensitivity of observed data to an unknown parameter is enhanced by utilizing optimal inputs. The derivation is given for the optimal input of an nth-order nonlinear differential equation. To obtain the optimal input, the solution of 4n two-point boundary value equations is required. Numerical resutis are given for a second order linear example. The optimal return is compared with the return obtained for a step input. The existence of a critical time length is demonstrated.     

Ballistics, navigation, and motion control for a spacecraft during its landing on the surface of Phobos

Basic concepts and algorithms laid as foundations of the scheme of landing on the Martian moon Phobos (developed for the Phobos-Grunt project) are presented. The conditions ensuring the landing are discussed. Algorithms of onboard navigation and control are described. The equations of spacecraft motion with respect to Phobos are considered, as well as their use for correction of the spacecraft motion. The algorithm of estimation of the spacecraft’s state vector using measurements with a laser altimeter and Doppler meter of velocity and distance is presented. A system for modeling the landing with a firmware complex including a prototype of the onboard computer is described.