某风扇/增压级非设计点性能计算及进气畸变影响分析

在原流线曲率法程序的基础上, 增加了适用于高速风扇/压气机的双激波损失模型.真实地反映了高速风扇/压气机的实际工作状况, 提高了预测高速风扇/压气机非设计点性能的准确性, 完善了分析进气畸变对风扇/压气机性能及稳定性影响的准三维计算模型.针对一台外涵转子叶尖马赫数大于1.4的大涵道比风扇/增压级, 计算分析了其非设计点性能以及进气畸变的影响.计算结果与试验结果吻合较好, 精度可靠, 可应用于工程实际.      

基于直升机舰面起降动态仿真的风限图计算

建立了基于直升机舰面起降动态仿真的风限图（WOD）计算方法,综合计入舰船尾流、直升机运动和驾驶员操控等多因素的作用提升风限图计算的准确度。基于耦合舰船非定常尾流的飞行动力学模型,发展了适于直升机多轴协同操控的驾驶员模型,建立了舰面起降轨迹的数学描述和生成方法,形成计入舰船尾流、直升机运动和驾驶员操控等多因素综合作用的直升机舰面起降动态仿真方法。在此基础上,总结风限图计算判据,建立风限图计算方法。计算结果表明,某些风况下直升机在舰面起飞和降落过程中受到舰船尾流的干扰远大于在甲板上方悬停时受到的作用。本文方法能够捕捉到不同起降点和起降方式导致舰船尾流时空变化的干扰,与传统计算方法相比,显著提升了风限图计算的准确度。     

Design and analysis of a truss deployable antenna mechanism based on a 3UU-3URU unit

Space deployable structures with large calibers, high accuracy, and large folding ratios are indispensable equipment in the aerospace field. Given that the single-DOF 3RR-3RRR deployable unit cannot be fully folded, this study proposes a 3UU-3URU deployable unit with two kinds of DOF: folding movement and orientation adjustment. First, based on the G-K formula, the DOF of the 3UU-3URU unit is analyzed. Then, the 3UU-3URU unit is used to construct a deployable truss antenna with a curved surface, and the DOF of the whole deployable antenna containing multiple 3UU-3URU units is calculated. The structural design of a deployable antenna with two loops is carried out with specific parameters and geometric relations. Next, a DOF simulation of a basic combination unit composed of three 3UU-3URU units is performed. Finally, a prototype of the basic combination unit is manufactured, and the DOF of the mechanism is experimentally verified.     

双定子涡流制动器电磁参数对制动力矩的影响

介绍了双定子涡流制动器(DSECB)的工作原理。根据等效磁路法推导了DSECB制动力矩公式。利用有限元法对DSECB进行了3D仿真分析。详细分析了DSECB各电磁参数对制动力矩特性曲线的影响,为DSECB优化设计提供了参考依据。     

涡桨飞机螺旋桨滑流气动干扰效应及流动机理

螺旋桨滑流对飞机各气动部件的干扰是涡桨飞机气动设计中面临的难点之一。以某双发涡桨支线客机为对象,采用数值模拟手段分析了滑流对机翼、平尾、垂尾的影响及其流动机理。计算采用基于动态面搭接网格技术的非定常方法,气动力与表面压力分布的计算结果均与实验值吻合良好。研究结果表明：在滑流影响下,全机升力和阻力有所增加,升阻比和纵向静稳定度有所降低,并在无侧滑状态下产生了滚转力矩和偏航力矩;在不同展向位置,滑流对机翼表面流动分离的影响存在显著的差异。在螺旋桨下行运动一侧,滑流的旋转减小了当地迎角,同时桨后气流速度较高,翼面流动分离被有效抑制。在螺旋桨上行运动一侧,滑流的旋转增大了当地迎角,而且桨后气流速度较低,因而翼面流动分离并未得到明显改善;在中小迎角下,滑流对背景飞机平尾当地的动压没有产生影响,但增加了下洗角变化率,进而导致平尾效率降低;垂尾的侧力与偏航力矩是由滑流的侧洗引起的,而滑流的侧洗又与左右两侧机翼升力分布的不对称性有关。     

常规闭口风洞相阵列气动声学试验

传统气动声学研究观点认为,精确的声学测量要求风洞背景噪声和洞壁反射足够低,传声器测量结果有足够高的信噪比,这是大多数风洞无法达到的要求.近些年,基于声纳和雷达技术发展起来的麦克风相阵列技术可以通过增加阵列的传声器数目从而大幅提高声学测量的信噪比,具有噪声源研究和定位能力,并被成功地应用于非声学固壁风洞噪声源测量和噪声物理机制研究.作者基于相阵列波束生成频域算法研制出常规闭口风洞相阵列系统及相关技术,在FD-09风洞尝试进行了相阵列校准试验和某民机噪声测量试验.结果表明:相阵列技术能够准确捕捉到真实的校准声源,并从技术上验证了相阵列系统在常规闭口风洞测量气动噪声是有效的.     

Ionospheric F2-Layer critical frequency retrieved from COSMIC radio occultation: A statistical comparison with measurements from a meridional ionosonde chain over Southeast Asia

In this paper, we compared the F2-Layer critical frequency (foF2) derived from FORMOSAT-3/COSMIC radio occultation (RO) and ionosondes at Chiang Mai, Chumphon and Kototabang during the years 2008–2015 to evaluate the performance of COSMIC RO over Southeast Asia region. The results show that the time development of foF2 values derived from COSMIC RO generally agrees well with those from ionosonde measurements. However, the differences between the foF2 derived from COSMIC RO and that derived from ionosonde observations display latitudinal dependence. COSMIC RO tends to underestimate foF2 at Chiang Mai and Kototabang, which is near to the north EIA crest and the south one, respectively, while a little overestimate foF2 at Chumphon, which is close to the geomagnetic equator. COSMIC RO agrees best with ionosonde at Chumphon and worst at Chiang Mai. At each ionosonde station, the quality of COSMIC RO data degrades with the increase of solar activity. In addition, at the station Chiang Mai and Kototabang, COSMIC RO performs better in summer than in equinox and winter. Furthermore, the differences in foF2 derived from COSMIC RO and that from ionosonde measurements vary with local time, i.e., the differences in foF2 are generally smaller at night and larger in noontime when equatorial ionization anomaly (EIA) is well developed.     

Evaluation and improvement of coastal GNSS reflectometry sea level variations from existing GNSS stations in Taiwan

Global sea level rise due to an increasingly warmer climate has begun to induce hazards, adversely affecting the lives and properties of people residing in low-lying coastal regions and islands. Therefore, it is important to monitor and understand variations in coastal sea level covering offshore regions. Signal-to-noise ratio (SNR) data of Global Navigation Satellite System (GNSS) have been successfully used to robustly derive sea level heights (SLHs). In Taiwan, there are a number of continuously operating GNSS stations, not originally installed for sea level monitoring. They were established in harbors or near coastal regions for monitoring land motion. This study utilizes existing SNR data from three GNSS stations (Kaohsiung, Suao, and TaiCOAST) in Taiwan to compute SLHs with two methods, namely, Lomb–Scargle Periodogram (LSP)-only, and LSP aided with tidal harmonic analysis developed in this study. The results of both methods are compared with co-located or nearby tide gauge records. Due to the poor quality of SNR data, the worst accuracy of SLHs derived from traditional LSP-only method exceeds 1?m at the TaiCOAST station. With our procedure, the standard deviations (STDs) of difference between GNSS-derived SLHs and tide gauge records in Kaohsiung and Suao stations decreased to 10?cm and the results show excellent agreement with tide gauge derived relative sea level records, with STD of differences of 7?cm and correlation coefficient of 0.96. In addition, the absolute GNSS-R sea level trend in Kaohsiung during 2006–2011 agrees well with that derived from satellite altimetry. We conclude that the coastal GNSS stations in Taiwan have the potential of monitoring absolute coastal sea level change accurately when our proposed methodology is used.     

航天器扫描镜成像位置误差补偿技术

研究地球静止轨道航天器两自由度扫描镜成像位置误差补偿问题,即通过对扫描角的补偿,使光轴在地球表面的成像点位置与标称位置相同,消除探测区域的位置偏差.在考虑扫描镜法线偏移、姿态偏差以及轨道误差条件下,推导了光轴成像点的地心经纬度计算公式.给出了上述3类误差的具体描述方式,并分析了各种误差对光轴成像点位置的影响关系.基于角度误差的小量假设条件,给出了扫描镜的步进角/扫描角补偿量的显式算法.针对法线偏移信息一般难以准确测量的问题,提出了一种利用扫描镜在特定工作模式下的光轴惯性空间定向能力和法线偏移的长周期特性对其进行估计的方法.仿真结果表明,所提出的补偿方案和算法能够显著提高成像点位置精度.     

不同重力条件下单气泡池沸腾现象的数值研究

对不同重力条件下常压饱和水中单气泡池沸腾现象的气泡生长过程及传热特性进行了数值模拟. 采用简化的润滑流模型计算生长气泡底部微液膜的贡献, 而其他宏观区域的气液两相介质则用连续界面模型统一处理. 气液界面形状和加热面上接触线的运动分别采用Level Set方法和固定的表观接触角来近似刻画. 计算结果表明, 气泡生长过程中, 当量直径近似与生长时间的1/3～1/2次方成正比, 重力对相关趋势的影响不大, 但强烈影响着气泡脱落直径和生长时间, 其中脱落直径反比于重力的1/3次方, 生长时间反比于重力的4/5次方. 在固定的核化点数密度条件下, 加热面平均热流密度近似与壁面过热度的3/2次方成正比, 该趋势并不随重力的减弱而改变.