Future of Space Astronomy: A global Road Map for the next decades

The use of space techniques continues to play a key role in the advance of astrophysics by providing access to the entire electromagnetic spectrum from radio to high energy γ rays. The increasing size, complexity and cost of large space observatories places a growing emphasis on international collaboration. Furthermore, combining existing and future datasets from space and “ground based” observatories is an emerging mode of powerful and relatively inexpensive research to address problems that can only be tackled by the application of large multi-wavelength observations. While the present set of astronomical facilities is impressive and covers the entire electromagnetic spectrum, with complementary space and “ground based” telescopes, the situation in the next 10–20 years is of critical concern. The James Webb Space Telescope (JWST), to be launched not earlier than 2018, is the only approved future major space astronomy mission. Other major highly recommended space astronomy missions, such as the Wide-field Infrared Survey Telescope (WFIRST), the International X-ray Observatory (IXO), Large Interferometer Space Antenna (LISA) and the Space Infrared Telescope for Cosmology and Astrophysics (SPICA), have yet to be approved for development.     

Relativistic electron fluxes and dose rate variations during April–May 2010 geomagnetic disturbances in the R3DR data on ISS

Space radiation has been monitored successfully using the Radiation Risks Radiometer-Dosimeter (R3D) installed at the ESA EXPOSE-R (R3DR) facility outside of the Russian Zvezda module of the International Space Station (ISS) between March 2009 and January 2011. R3DR is a Liulin type spectrometer–dosimeter with a single Si PIN detector 2 cm² of area and 0.3 mm thick. The R3DR instrument accumulated about 2 million measurements of the absorbed dose rate and flux of 10 s resolution. The total external and internal shielding before the detector of R3DR device is 0.41 g cm⁻². The calculated stopping energy of normally incident particles to the detector is 0.78 MeV for electrons and 15.8 MeV for protons. After the Coronal Mass Ejection (CME) at 09:54 UTC on 3 April 2010, a shock was observed at the ACE spacecraft at 0756 UTC on 5 April, which led to a sudden impulse on Earth at 08:26 UTC. Nevertheless, while the magnetic substorms on 5 and 6 of April were moderate; the second largest in history of GOES fluence of electrons with energy >2 MeV was measured. The R3DR data show a relatively small amount of relativistic electrons on 5 April. The maximum dose rate of 2323 μGy day⁻¹ was reached on 7 April; by 9 April, a dose of 6600 μGy was accumulated. By the end of the period on 7 May 2010 a total dose of 11,587 μGy was absorbed. Our data were compared with AE-8 MIN, CRESS and ESA-SEE1 models using SPENVIS and with similar observations on American, Japanese and Russian satellites.     

The South Pole-Aitken basin region,Moon: GIS-based geologic investigation using Kaguya elemental information

Using Geographic Information Systems (GIS), we performed comparative analysis among stratigraphic information and the Kaguya (SELENE) GRS data of the ∼2500-km-diameter South Pole-Aitken (SPA) basin and its surroundings. Results indicate that the surface rock materials (including ancient crater materials, mare basalts, and possible SPA impact melt) are average to slightly elevated in K and Th with respect to the rest of the Moon. Also, this study demonstrates that K and Th have not significantly changed since the formation of SPA. The elemental signatures of the impact basin of Fe, Ti, Si, O through time include evidence for resurfacing by ejecta materials and late-stage volcanism. The oldest surfaces of SPA are found to be oxygen-depleted during the heavy bombardment period relative to later stages of geologic development, followed by both an increase in silicon and oxygen, possibly due to ejecta sourced from outside of SPA, and subsequent modification due to mare basaltic volcanism, which increased iron and titanium within SPA. The influence of the distinct geologic history of SPA and surroundings on the mineralogic and elemental abundances is evident as shown in our investigation.     

GNSS single frequency ionospheric range delay corrections: NeQuick data ingestion technique

A study of the performance of the NeQuick model and the Klobuchar model for GNSS single frequency range delay correction on a global scale was done using data for moderate solar activity. In this study NeQuick was used in the way intended for Galileo. This study is to assess the performance of the two models at each ionospheric geographic region during moderate solar activity as previously published studies were concentrated only on high solar activity. The results obtained showed that NeQuick outperformed Klobuchar for the whole year at the three geographical regions of the ionosphere. In terms of monthly root mean square of mismodeling, NeQuick outperformed Klobuchar by 15 TECU or more at low-latitudes, 5 TEC or more at mid-latitudes, and 1 TECU or more at high-latitudes.     

加速度计贮存稳定期分析

在石英挠性加速度计有限元仿真分析的基础上,得到了加速度计标度因数稳定性随温度及时间的变化数据,采用乘积型最小二乘曲面拟合方法对标度因数稳定性、时间、温度数据进行拟合,建立了标度因数稳定性的加速退化近似模型;考虑不同产品间的分散差异和试验测试误差,对加速退化近似模型进行随机化处理,基于一阶泰勒展开计算方差的方法,给出含置信度的加速退化近似模型;结合加速度计贮存条件,进行基于模型的贮存稳定期分析,得到贮存条件下给定稳定性判据时的加速度计稳定期;同时,也可以给出加速度计稳定性评价结果,判断某贮存条件下贮存一段时间后的稳定性是否能够满足要求.     

自动阻抗调配器的校准技术探讨

自动阻抗调配器在微电子行业应用越来越广泛,但是目前国内还没有计量技术机构开展该类仪器的计量校准工作,本文介绍了其机械结构、工作原理,设计了控制模型,组建了校准系统,实现了主要参数矢量重复性、驻波比和插入损耗的校准工作。     

采用小电流进行阻值测试的方法研究

介绍了一种采用小电流进行阻值测试的方法。其用于要求严格控制测试电流、电压的阻值测量领域,采用了自动测试功能,解决了现有测试过程繁杂、耗时、准确度低、受人为因素影响较大等问题,提高了测试效率、安全性和准确度。     

绳驱动拟人臂机器人的动力学建模及张力分析

与传统的机械臂相比,绳驱动拟人臂机器人采用串并混联的结构形式,模拟了人手臂肌肉的并联驱动方式,但是,绳索的引入也增加了动力学分析的难度.将绳驱动拟人臂机器人视为基座、大臂、小臂和末端四连杆串联机构,采用迭代牛顿-欧拉法建立动力学方程的递推形式,考虑绳驱动的冗余特性和绳索的单方向受力性,提出基于动态最小预紧力的张力分配算法,求解出各绳索的驱动力.与未进行张力分配的方法及基于静态最小预紧力的方法相比,所提出的算法可使各绳索驱动力根据动态最小预紧力进行实时调节,满足了不同工作条件下机构的刚度要求.     

Al-Li合金搅拌摩擦焊搭接接头的疲劳性能

通过疲劳寿命试验、疲劳断口和金相组织分析,研究了Al-Li合金搅拌摩擦焊搭接接头的疲劳性能,分析了接头前进侧热机影响区(TMAZ, Thermal-Mechanically Affected Zone)出现的"钩状缺陷"对其疲劳性能的影响.结果表明,钩状缺陷容易引起裂纹萌生及扩展,减小接头的有效承载板厚,适当缩短搅拌针长度可以改善钩状缺陷,提高接头力学性能.母材与搭接接头的疲劳S-N曲线研究表明:在高疲劳应力下,接头的疲劳寿命接近母材,但随着疲劳应力水平降低,接头的疲劳寿命急剧下降,200万循环周次下的疲劳强度仅达到80 MPa,为母材的35%.