前台阶流场的传热实验研究

本文尝试用瞬态实验方法, 在卢德威格风洞实验台上, 对小台阶高度 (H=4.0mm)的前台阶二维流场进行传热实验研究, 测定了当雷诺数为 11800至32200时的流场内热流通量和努谢尔特数的变化规律以及努谢尔特数随雷诺数变化的准则关系式。实验结果是令人满意的。      

“AP/HTPB/Al/催化剂”推进剂燃烧模拟计算方法

本文以我们在文献[1～4]中提出的“AP/HTPB/Al”推进剂燃烧模型为基础,首先讨论了催化剂作用部位与推进剂燃速、压力指数变化的关系,然后引入一个催化剂作用因子B.并以二茂铁系列催化剂为例,对模型中的几个与二茂铁催化剂作用部位相连系的反应动力学参数作“催化作用因子”校正,计算研究了四种二茂铁催化剂用量对燃速、压力指数的影响规律.计算结果与实验符合得很好,相对误差均小于±10%,证明本文提出的模拟计算方法具有较高的可靠性.     

Cascaded detector for multiple high-PRF pulse Doppler radars

A postdetection design methodology for a multiple high-pulse-repetition frequency (PRF) pulse Doppler radar has been developed. The postdetection processor consists of an M out of N detector where range and target ambiguities are resolved, followed by a square-law detector which enhances the minimum signal-to-noise (S/N) power-ratio per pulse burst performance. For given probabilities of false alarm and detection, formulas are derived from which the three thresholds associated with the cascaded detector can be found. Fundamental tradeoffs between the minimum S/N required, number of ghosts, and the number of operations (NOPs) that the cascaded detector must perform are identified. It is shown that the NOPs and the number of ghosts increase and the minimum S/N required decreases as the binary M out of N detector passes more detections to the square-law detector     

Automated air defense system using knowledge-based system

The proposed KAAD (knowledge-based automated air defense) system demonstrates a man-machine environment for airspace defense systems. When the unknown aircraft is hostile, a threat rating and response methods are generated by the system. It serves as a double-check decision-making system for a war control center. In addition to this application, the KAAD system can also be a useful tool as a training program for the war controller. The capabilities of the system are limited due to the shortage of knowledge resources. It requires communications among war controllers and air fighter pilots to organize a practical knowledge base. It is shown that the KAAD system can be combined with an automated ATC (air traffic control) system to become a practical system for air defense applications     

Y12─Ⅱ型飞机结冰对其飞行特性影响的试飞研究

以Ｙ１２─Ⅱ型飞机防冰系统适航验证试飞为例，就确定飞机结冰部位与防护方法，结冰对飞机飞行性能和操稳特性的影响，带冰着陆的可能性及其安全措施等问题进行了分析和讨论。通过飞行试验，初步检查出飞机结冰造成飞机飞行性能的损失和操稳特性的降低。仅在新机研制中，为防冰系统适航性验证工作提供参考。     

尖前缘翼干扰区的壁面压力和热流率分布

本文给出Ｍ＿∞＝７．８和６．７２，Ｒｅ＝３．５×１０￣７／ｍ和５．４×１０￣７／ｍ气流绕迎角为２０°、３０°和３５°尖前缘翼运动时，平板锥型干扰区的壁面压力和热流率分布。结果表明：（１）平板锥型干扰区的特征几何尺度与无粘激波角β＿０和翼迎角α相关，而壁面压力和热流率的峰值与法向马赫数Ｍ＿ｎ相关。（２）翼面压力和热流率分布由于受拐角涡影响，前者在翼根部呈波谷状，而后者呈波峰状，影响尺度与翼前缘处来流边界层厚度有关。     

SWE,a comprehensive plasma instrument for the WIND spacecraft

The Solar Wind Experiment (SWE) on the WIND spacecraft is a comprehensive, integrated set of sensors which is designed to investigate outstanding problems in solar wind physics. It consists of two Faraday cup (FC) sensors; a vector electron and ion spectrometer (VEIS); a strahl sensor, which is especially configured to study the electron strahl close to the magnetic field direction; and an on-board calibration system. The energy/charge range of the Faraday cups is 150 V to 8 kV, and that of the VEIS is 7 V to 24.8 kV. The time resolution depends on the operational mode used, but can be of the order of a few seconds for 3-D measurements. Key parameters which broadly characterize the solar wind positive ion velocity distribution function will be made available rapidly from the GGS Central Data Handling Facility.     

Design and characteristics of a multiband communication satelliteantenna system

Feasibility studies on a multiband communication satellite antenna system and the key technologies involved in devising this system are described. The proposed multiband communication satellite utilizes four frequency bands: Ka (30/20 GHz), Ku (14/12 GHz), C (6/4 GHz), and S (2.6/2.5 GHz). It has six beam configurations, three multibeam and three shaped-beam. The following key technologies are presented: (1) a low-loss frequency selective subreflector (FSR) for compact feeds, (2) a low-loss and broadband frequency selective surface (FSS), and (3) a highly accurate and reliable mesh reflector     

复合材料在DCB试验中的裂纹尺寸效应

在许多关于复合材料Ⅰ型层间断裂韧性试验研究工作中，不同的作者所选取的有效裂纹长度有很大的差异，由此带来试验结果分散程度很大，试验结果无法相互比较等问题。本文对复合材料在Ⅰ型层间断裂ＤＣＢ试验中裂纹的预裂长度、裂纹尖端形状以及裂纹测量误差等问题进行了研究。