空-空导弹全向攻击最优制导规律研究

 将发射瞬时所确定的平行接近弹道作为基准弹道,由于各种干拢所引起的相对于基准弹道的偏离作为偏差来处理;用最优控制理论导出空-空导弹进行全向攻击的最优制导律,此制导律包含目标加速度反馈。当目标作非机动飞行时,最优制导律是一种变比例系数的比例制导。数字仿真结果表明:在相同条件下,最优制导弹道需用过载、终端脱靶量均小于比例制导,特别是从目标前方攻击时,其制导精度大大优于比例制导。     

金属图象分割的研究

结合金属图象的特点,利用传统阚值分割技术和基于最大熵原则的图象分割技术对金属图象分割进行了分析;并根据金属图象分析要求,提出了先二值化金属图象再进行边缘提取的方法.对比实验结果表明,基于最大熵原则的图象分割技术可以获得较好的分割效果,所提出的方法能够获得连续闭合的晶粒边缘,为下一步的金属图象分析提供了可靠的依据.     

多径衰落条件下两种常规测向方法的误差问题

讨论了莱斯多径衰落信道模型在两类常规测向技术中的应用。利用常规测向技术对信噪比的特定要求,分析了具有莱斯分布特性衰落信道对比相、比幅测向误差抖动的影响,给出了其分布函数,并通过仿真指出其应用限制。最后就工程应用中所关心的模型参数获取和采样点数确定等问题作一论述。     

Investigation of corona initiation voltage at reduced pressures

The results of an experimental study of the 60 Hz ac corona inception voltage at reduced pressures for a cylindrical conductor and a parallel ground plane are presented. Several spacings and bare and insulated conductors of several diameters are considered. Empirical expressions from which a reasonably accurate prediction of the corona inception voltage (CIV) may be made have been inferred from experimental data     

A recursive multiple model approach to noise identification

Correct knowledge of noise statistics is essential for an estimator or controller to have reliable performance. In practice, however, the noise statistics are unknown or not known perfectly and thus need to be identified. Previous work on noise identification is limited to stationary noise and noise with slowly varying statistics only. An approach is presented here that is valid for nonstationary noise with rapidly or slowly varying statistics as well as stationary noise. This approach is based on the estimation with multiple hybrid system models. As one of the most cost-effective estimation schemes for hybrid system, the interacting multiple model (IMM) algorithm is used in this approach. The IMM algorithm has two desirable properties: it is recursive and has fixed computational requirements per cycle. The proposed approach is evaluated via a number of representative examples by both Monte Carlo simulations and a nonsimulation technique of performance prediction developed by the authors recently. The application of the proposed approach to failure detection is also illustrated     

Blind adaptive decision fusion for distributed detection

We consider the problem of decision fusion in a distributed detection system. In this system, each detector makes a binary decision based on its own observation, and then communicates its binary decision to a fusion center. The objective of the fusion center is to optimally fuse the local decisions in order to minimize the final error probability. To implement such an optimal fusion center, the performance parameters of each detector (i.e., its probabilities of false alarm and missed detection) as well as the a priori probabilities of the hypotheses must be known. However, in practical applications these statistics may be unknown or may vary with time. We develop a recursive algorithm that approximates these unknown values on-line. We then use these approximations to adapt the fusion center. Our algorithm is based on an explicit analytic relation between the unknown probabilities and the joint probabilities of the local decisions. Under the assumption that the local observations are conditionally independent, the estimates given by our algorithm are shown to be asymptotically unbiased and converge to their true values at the rate of O(1/k/sup 1/2/) in the rms error sense, where k is the number of iterations. Simulation results indicate that our algorithm is substantially more reliable than two existing (asymptotically biased) algorithms, and performs at least as well as those algorithms when they work.     

一种新颖的瞬时浮点放大器

介绍了瞬时浮点放大器的原理及构成，并给出一种结构新的具有２５６阶的瞬时浮点放大器，可有效地提高数据采集系统的测量范围。     

六喷管超音速引射器性能的理论分析和实验研究

对某一定尺寸的六喷管超音速引射器进行气动性能的实验研究。结果表明：随着主次流压比Ｐ＊ｐ／Ｐ＊ｓ增加，引射系数及修正引射系数下降；当引射系数增加时，混合管动量修正系数Ｋｍ下降，但主喷管流量系数μ变化不大。对上述工况进行理论计算的结果与实验数据符合良好。     

室温贮存对树脂粘度和加压点的影响

讨论了５４０５改性双马来酰亚胺树脂基体在室温下，贮存时间对粘度以及对固化过程中加压点的影响，给出了相应的计算方法。     

获取自由飞模型气动导数的综合飞行试验研究

过去已进行过多个机种的自由飞模型大迎角特性试验，但均为单一项目的试验，现介绍了将获取放宽静稳定度特性和气动导数两个项目综合于一个自由飞模型飞行试验项目中的情况，用脉冲升降舵激发起模型的纵向短周期运动，用参数辩识方法获取气动导数，试验结果表明这种方法是可行的，为从事本专业及相关专业的科研人员提供了参考。