飞机平尾偏角引动量的自动检测

根据飞机纵向操纵系统工作原理和纵向平飞操纵原理，推导了平衡速度与平尾偏角的关系式，分析了操纵杆力、平衡速度、平尾偏角的相互关系及平衡速度的调整原理。结合平尾偏角检测现状，提出了一种利用机械臂自动检测飞机平尾偏角的方法，成功研制了平尾偏角自动检测仪，并用于平衡速度的调整。反复检测表明：该检测仪可取代目前广泛使用的人工检测方法，提高了飞机维修保障能力，具有较大的推广前景。     

空气中微细电火花沉积铜合金工艺方法

提出了一种在空气中将工具电极丝黄铜材料沉积到工件上的新工艺方法。实现该方法的基本条件为:(1)工具电极接脉冲电源正极;(2)在空气中放电;(3)窄脉宽配合宽脉间。通过大量实验对微细电火花沉积加工的工艺规律进行了系统深入的研究,得出各主要工艺参数对沉积工艺效果的影响规律。最终以黄铜电极丝为工具电极,在高速钢工件表面上沉积出直径为0.19 mm、高度为7.35 mm的微小圆柱体。利用SEM、能谱分析和X射线衍射及显微硬度测试等方法对沉积物进行分析,得出该沉积物的组织结构、化学成分和硬度等方面的基本性质,为进一步研究三维沉积加工奠定了基础。     

典型电离层多普勒记录及其讨论

由于地面电离层多普勒频率偏移测量具有时间连续、设备相对简便等固有特征，它特别适合于扰监测。本文在整理北京大学电离层高频多普勒台站观测资料的基础上，给出了一些典型电离层多普勒效应观测现象，这些现象反映了多普勒的细致分析对电离层形态学研究有其特殊意义。利用IRI模型，对多普勒频移的太阳耀斑效应及电离层不规则结构对多普勒频移的影响进行了模拟计算，理论结果与观测基本一致，从而大体上解释了这些响应的物理机制。论文最后对观测到的一种特殊的记录类型－－S型描迹的具体成因作了详细的分析和讨论，指出在一定条件下，以一定相位速度水平传播的声重波可以产生这类记录，给出了相位速度和振幅等声重波参数与记录描迹形状的关系，这对从多普勒频移记录推演电离层中的波动特征有一定的帮助。     

MONITORING OF ENERGETIC PARTICLE ENVIRONMENT INSIDE THE CHINA-BRAZIL EARTH RESOURCE SATELLITE

On 14 October 1999, the Chinese-Brazil earth resource satellite (CBERS-1) was launched in China. On board of the satellite there was an instrument designed at Peking University to detect the energetic particle radiation inside the satellite so the radiation fluxes of energetic particles in the cabin can be monitored continuously. Inside a satellite cabin, radiation environment consists of ether penetrated energetic particles or secondary radiation from satellite materials due to the interactions with primary cosmic rays.Purpose of the detectors are twofold, to monitor the particle radiation in the cabin and also to study the space radiation environment The data can be used to study the radiation environment and their effects on the electronics inside the satelhte cabin. On the other hand, the data are useful in study of geo-space energetic particle events such as solar proton events, particle precipitation and variations of the radiation belt since there should be some correlation between the radiation situation inside and outside the satellite.The instrument consists of two semi-conductor detectors for protons and electrons respectively. Each detector has two channels of energy ranges. They are 0.5-2MeV and ≥2MeV for electrons and 5-30MeV and 30-60MeV for protons. Counting rate for all channels are up to 104/(cm2@s)and power consumption is about 2.5 W. There are also the additional functions of CMOS TID (total integrated dose) effect and direct SEU monitoring. The data of CBMC was first sent back on Oct. 17 1999 and it's almost three years from then on. The detector has been working normally and the quality of data is good.The preliminary results of data analysis of CBMC not only reveal the effects of polar particle precipitation and radiation belt on radiation environment inside a satellite, but also show some important features of the geo-space energetic particle radiation.As one of the most important parameters of space weather, the energetic charged particles have great influences on space activities and ground tech nology. CBMC is perhaps the first long-term on-board special equipment to monitor the energetic particle radiation environment inside the satellite and the data it accnmulated are very useful in both satellite designing and space research.     

基于连续覆盖特性分析的星座设计

研究了需要对地面目标进行连续覆盖的星座的设计问题．首先推导了对覆盖性能有重要影响的星间覆盖间隔时间和轨道面覆盖间隔时间的计算公式，通过算例针对不同配置的星座进行了计算，使用工程仿真软件STK验证了分析结果．通过理论分析、算例计算以及工程仿真为该类型星座设计提供了理论指导。     

利用MF雷达对耀斑期间电离层D区电子密度的观测研究

利用MF雷达观测资料对X级别耀斑爆发期间在66-80km高度之间的电子密度进行了研究，观测到了耀斑爆发期间电子密度的突然增加，在较低高度上的电子密度的时间变化趋势与耀斑的软X射线辐射通量相关．电子密度的变化强度依赖于具体的耀斑参数，有些耀斑引起的电子密度增加高达400cm^-3，有些仅为100cm^-3左右．但耀斑期间在这一高度区间增加的总电子含量增量仅占耀斑辐射引起的整个电离层总电子含量增量的千分之一左右．最后，利用恢复阶段电子密度的时间变化过程估算了1997年11月4日耀斑期间部分高度上的有效复合系数．     

An innovative study on low surface energy micronano coatings with multilevel structures for laminar flow design

Laminar flow design is one of the most effective ways to reduce the drag of a commercial aircraft by expanding the laminar flow region on the surface of the aircraft. As material science develops, the emergence of new materials such as low surface energy materials has offered new choices for laminar flow design of commercial aircraft. Different types of low surface energy micro-nano coatings are prepared to verify the effects on the boundary layer transition position and the drag of the airfoil through wind tunnel tests. The infrared thermal imaging technology is adopted for measuring the boundary layer transition, while the momentum integral approach is employed to measure the drag coefficient through a wake rake. Infrared thermal imaging results indicate that the coatings are capable of moving backward the boundary layer transition position at both a low velocity of Mach number 0.15 and a high velocity of Mach number 0.785. Results of the momentum integral approach demonstrate that the drag coefficients are reduced obviously within the cruising angle of attack range from 1° and 5° by introducing the low surface energy micro-nano coating technology.     

基于STM32的视频流图像更新方法的研究

对基于STM32系统低速(工作主频72MHz)视频流处理显示更新方案的研究。结合图像处理基本理论,分析传统的显示方法的不足,并提出一种新的视频流图像更新的方法,通过一定的实验数据和理论结果,验证该方法可行性。     

新一代战斗机非定常流动数值研究综述

新一代战斗机强调超机动能力和强隐身性，其中大攻角下的静态失速、动态失速及内埋弹仓绕流是与高机动和强隐身密切相关的、极具挑战的几类典型的非定常流动，它们对数值方法提出了极高的要求。为了高精度地仿真流场、清楚地揭示流动机理，有效地控制非定常流动，非常有必要发展高精度且高效率的RANS-LES混合方法体系，包含RANS-LES混合方法本身、与RANS-LES混合方法匹配的高精度自适应耗散格式、基准湍流模式、高质量计算网格、高精度时间推进方法、非定常量的统计方法等，具有极强的紧迫性。提出、发展、验证并应用该类方法数值仿真新一代战斗机（包括单独部件、组合体、甚至全机）的非定常流动，数值预测结果与风洞实验数据吻合良好；此类方法可为新型战斗机设计提供理论依据和分析手段。     

低速大转矩永磁游标电机在发酵罐中的应用

采用秸秆生产丁醇时,为了达到高效率发酵,需要使发酵液中菌体分布均匀,所加物料需要及时搅拌。工业化生产丁醇的发酵罐尺寸较大,搅拌过程对驱动电机的输出转矩要求较高,因此高效率、小体积、低速大转矩的秸秆发酵搅拌电机对工业化发酵生产丁醇意义重大。设计了一种定转子永磁游标电机用于发酵液搅拌,并对电机的槽极数、电磁性能进行了具体的研究。制造样机并采用滞环控制实现了对液态发酵对象的快速响应,且实现了低能耗、高效率的发酵过程。