挠性空间结构的H∞辨识

重点研究挠性空间结构的Ｈ∞辨识，研究表明：依据系统的输入输出空间，对系统的未知动力学参数估计和对高维数截断的适当操作，将导致适合于控制的低维数学模型。模型维数确定时，系统模型与实际系统的距离在Ｈ∞范数的意义下几乎为最小，模型维数足够大时，系统模型与实际系统的距离可任意小，这是文下间提出了挠性空间结构Ｈ∞辨识的基本思想，为此，以带挠性梁的卫星系统为背景，首先分析了系统的动力学特性，引入了挠性系统Ｈ∞     

Kinetic cyclotron and synchrotron maser instabilities: Radio emission processes by direct amplification of radiation

This article reviews the theory of the kinetic (cyclotron an synchroton) maser instabilities. The subject has been extensively developed in recent years by many authors, who have been incited by the research of the auroral kilometric radiation and other applications. The maser mechanism is appealing because it is simple and efficient, and can lead to direct amplification of radiation. Two types of electron distribution functions have been investigated so far. These are the loss-cone and hollow-beam distributions which may exist pervasively in many regions within and beyond the solar system. It is likely that the maser instabilities can have many potentially important applications to numerous radio emission processes observed in astrophysical research.     

太阳风中磁重联的可能性及其观测证据

本文利用美国行星际监测卫星IMP-H和IMP-J同时在弓激波上游的极佳时机(1976年1月21日—22日)探测的结果, 比较了两个卫星同时测得的离子脉冲(E≥125keV/Q, Q≥1)的计数率和各向异性.分析表明在IMP-H比IMP-J离地球远的四个事件a—d中, a和b事件时, IMP-H上测得的计数率大于IMP-J上计数率, 各向异性从太阳指向地球;c事件时, IMP-J上计数率大于IMP-H上的测量值, 各向异性从太阳指向地球;d事件时, IMP-J上计数率大于IMP-H上的相应值, 各向异性改变方向, 从地球指向太阳.它们可以用太阳风中扇形边界样的磁场反转形态磁重联产生的高能粒子的假说来满意地得到解释.     

大型客机航空电子系统研发关键技术分析及建议

根据未来航电系统的发展和研发大型客机的需求,结合目前国内航电系统研制的基础,针对国内民机航电研制的薄弱环节,提出了发展我国航空电子系统的关键技术.在此基础上,提出了开展民用大型客机航空电子系统研发的建议.     

基于特征模型的全系数自适应控制系统稳定性研究

讨论了基于特征模型的黄金分割加逻辑微分自适应控制律组成闭环系统的稳定性问题。针对参数未知、线性定常或慢时变的二阶不稳定对象,本文给出了在采样周期满足一定条件下,上述闭环系统渐近稳定的充分条件,其中包含对于时变参数变化范围和非线性阻尼系数的约束条件。     

Measurements of heat transfer and pressure in a trailing edge cavity of a turbine blade

 An experimental investigation is conducted to obtain the heat transfer and pressure drop data for an integral trailing edge cavity test section that simulates a novel turbine blade's internal cooling passage with bleed holes. Local heat transfer is measured on both the suction and pressure sides by a transient liquid crystal technique, while pressures at six positions are recorded by pressure calibrators. Moreover, flow characteristic and its effect on heat transfer are analyzed for conditions with or without bleed flow. The experimental results show that, in the cases with bleed flow, local heat transfer on the pressure side exceeds that on the suction side in the first and second channels. In the cases without bleed flow, in the first and third channels, local heat transfer on the suction side weakens whilst it increases significantly on the pressure side. For the second channel, non-bleed condition leads to a more balanced heat transfer distribution between the upstream and downstream channel. Besides, after the bleed holes are blocked, heat transfer in the first bend region on the suction side declines sharply, while the opposite phenomenon occurs for the second bend region on the pressure side. In both bleed and non-bleed cases, the total pressure of six measurement positions decreases continuously along the channel at the same Reynolds number and it promotes for higher Reynolds number. Among all the measurement points, under the same flow rate condition, the highest speed occurs at Position 5, which also shows the maximum difference between the total and static pressures. When the bleed holes are blocked, the total pressure at each measurement position appears to increase.     

有控飞行器非线性气动模型结构的确定（Ⅰ）

非线性气动模型结构确定是飞行器参数辨识中极其重要的问题。首先给出了非线性气动模型的数学描述,在此基础上,以导弹纵向及侧向运动方程为例,首次系统地分析了有控飞行器非线性气动模型结构确定中必然存在的共线性问题。频域分析过程清晰地表明在通常的试验情况下,m_z~α及m_z~(ω_z)是不可单独辨识的,从理论上解释了国内外一直不单独辨识它们的原因所在。指出原有的模型结构确定方法,如AIC准则,逐步回归等已不再适用于非线性气动模型结构的确定。同时对参数的可辨识性也作了一定的讨论。     

Quadrature Sampling with High Dynamic Range

Many radio and sonar systems require signal outputs in complex low-pass form. To achieve this, it is possible to use uniform sampling of the bandpass signal, together with computation of the quadrature component by way of a Hilbert transform. The bandpass to low-pass translation is accomplished by undersampling. A hardware implementation is described which achieves 70 dB spurious-free dynamic range and a bandwidth of 30 kHz.     

大迎角非定常气动力建模与模型比较

应用系统识理论,以６００ 三角翼纵向俯仰运动为例,在频率域内建立了基于Ｆｏｕｒｉｅｒ变换法的非定常气动力数学模型及非线性代数模型,在时间域内建立了基于Ｆｏｕｒｉｅｒ反变换法及数据库法的阶跃函数模型。用大振幅非定常实验数据进行模型参数辨识。本文主要对Ｆｏｕｒｉｅｒ变换模型初值的选取进行讨论,并对所建立的几种数学模型进行比较。结果表明,基于Ｆｏｕｒｉｅｒ变换法的数学模型,有明确的表达式,拟合结果较好;非线性代数模型表达式简单,便于应用,但对于不同实验模型,表达式不同;基于Ｆｏｕｒｉｅｒ 反变换法的阶跃函数模型,表达式复杂,而且当时间趋于零时,计算误差较大;基于数据库法的阶跃函数模型没有明确表达式,但其精度较高,可以用于对其他模型结果的比较。     

单输入系统的最优闭环极点区域探讨

本文基于无限时域二次型性能指标的最优控制,讨论单输入线性定常系统闭环极点的分布区域问题。文中引入最优闭环极点区的概念,提出不等式寻优法和加权阵寻优法,并举例说明了两种方法在研究最优闭环极点区问题上的应用。