Review of flow control mechanisms of leading-edge vortices

Vortex control concepts employed for slender and nonslender delta wings were reviewed. Important aspects of flow control include flow separation, vortex formation, flow reattachment, vortex breakdown, and vortex instabilities. The occurrence and relative importance of these phenomena strongly depend on the wing sweep angle. Various flow control methods were discussed: multiple vortices, control surfaces, blowing and suction, low-frequency and high-frequency excitation, feedback control, passive control with wing flexibility, and plasma actuators. For slender delta wings, control of vortex breakdown is achieved by modifications to swirl level and external pressure gradient acting on the vortex core. Effects of flow control methods on these two parameters were discussed, and their effectiveness was compared whenever possible. With the high-frequency excitation of the separated shear layer, reattachment and lift enhancement in the post-stall region is observed, which is orders of magnitude more effective than steady blowing. This effect is more pronounced for nonslender wings. Re-formation of vortices is possible with sufficient amplitude of forcing at the optimum frequency. Passive lift enhancement on flexible wings is due to the self-excited wing vibrations, which occur when the frequency of wing vibrations is close to the frequency of the shear layer instabilities, and promote flow reattachment.     

大曲率弯道和叶栅内的湍流数值模拟

本文在贴体曲线坐标系下应用非交错网格技术，发展了适于求解复杂流动的压力修正算法，采用速度的协变物理分量为动量方程的求解变量，推导得出一个适于任何曲线坐标系下控制单元体界面流通量的插值模式，可以有效地抑制不合理的波动压力场，计算表明，算法稳定收敛，计算值与试验值吻合良好，同时能预示通道内复杂的流动现象。     

米定义发展的启示

通过简要介绍米定义发展的历史，人们从中得到的启示是：这样严密的定义，还在不断地进行修改，使其更加完善。诸如量块长度的定义、测量方法、测量原理和测量可靠性的评估等原来的定义和规定也断地更晚是理所当然的事。     

细长体分离起始点的实验研究

本文实验研究了细长体模型在中等迎角下的初始分离问题。观察了不同头部形状的细长体在不同迎角下的分离流态。考察并分析了分离起始点的性质。观察到开式分离的存在,实验结果分析认为开式分离可以起始于正常点。此外,在钝头和尖头模型上都出现了螺旋点形式的头部涡。它们或是闭式分离的起始点,或是奇点型开式分离的起始点。     

DO 28飞行试验数据一致性检验

 本文研究DO28试验机飞行试验数据一致性检验及其误差校正。建立了由非线性运动学方程及内容广泛的校正环节构成的一致性检验模型,解决了大地风场重构、测量信号时间延迟估计、ψ转换及测量控制信号的校正。为DO28参数估计提供了可靠、准确的飞行试验数据。     

分布式航空电子系统信息传输机构设计研究

 航空电子系统日益增长的复杂性使其必须走向分布式处理的道路。本文介绍一个基于1553B总线的分布式航空电子系统的实验模型——EPDAS系统,讨论了EPDAS系统信息传输机构的有关组成部分:总线通信协议、通信管理软件和总线接口,本文在分析传统的同步总线控制方式的缺点之后,提出了询问和命令/响应相结合的总线控制方式,该方式能提高总线传输的效率和实时性。在EPDAS系统的总线接口设计中,引入了流水线并行处理技术,解决了总线接口的瓶颈问题,并使之易于VLSI化;伪DMA控制的概念,使总线接口电路更加简化;共享存贮器的互连技术,具有效率高、控制简单、容易实现等优点。EPDAS系统结构合理、效率高,符合国情、适合于新一代的飞机。     

计算机辅助公差设计与分析的研究现状及展望

对目前计算机辅助环境下的设计公差和工序公差的设计与分析、尺寸公差和形位公差的确定、公差设计理论以及计算机辅助公差的应用现状等多方面进行了归纳和概括,分析了当前这些技术和理论的不足,并结合当前的实情,展望了计算机辅助公差设计与分析技术的发展趋势.     

六喷管超音速引射器性能的理论分析和实验研究

对某一定尺寸的六喷管超音速引射器进行气动性能的实验研究。结果表明：随着主次流压比Ｐ＊ｐ／Ｐ＊ｓ增加，引射系数及修正引射系数下降；当引射系数增加时，混合管动量修正系数Ｋｍ下降，但主喷管流量系数μ变化不大。对上述工况进行理论计算的结果与实验数据符合良好。     

Phased array of large reflectors for deep-space communication

In this paper the problem of uplink array calibration for deep-space communication is considered. A phased array of many modest-size reflectors antennas is used to drastically improve the uplink effective isotropic radiated power of a ground station. A radar calibration procedure for the array phase distribution is presented using a number of in-orbit targets. Design of optimal orbit and the number of calibration targets is investigated for providing frequent calibration opportunities needed for compensating array elements phase center movements as the array tracks a spacecraft. Array far-field focusing based on the near-filed in-orbit (low Earth orbit (LEO)) calibration targets is also presented and array gain degradation analysis based on the position error of the array elements and in-orbit targets has been carried out. It is shown that errors in the in-orbit targets positions significantly degrade the far-field array gain while the errors in array elements positions are not very important. Analysis of phase errors caused by thermal noise, system instability, and atmospheric effects show insignificant array gain degradation by these factors     

The Pre-CME Sun

The coronal mass ejection (CME) phenomenon occurs in closed magnetic field regions on the Sun such as active regions, filament regions, transequatorial interconnection regions, and complexes involving a combination of these. This chapter describes the current knowledge on these closed field structures and how they lead to CMEs. After describing the specific magnetic structures observed in the CME source region, we compare the substructures of CMEs to what is observed before eruption. Evolution of the closed magnetic structures in response to various photospheric motions over different time scales (convection, differential rotation, meridional circulation) somehow leads to the eruption. We describe this pre-eruption evolution and attempt to link them to the observed features of CMEs. Small-scale energetic signatures in the form of electron acceleration (signified by nonthermal radio bursts at metric wavelengths) and plasma heating (observed as compact soft X-ray brightening) may be indicative of impending CMEs. We survey these pre-eruptive energy releases using observations taken before and during the eruption of several CMEs. Finally, we discuss how the observations can be converted into useful inputs to numerical models that can describe the CME initiation.