Al-Li合金搅拌摩擦焊搭接接头的疲劳性能

通过疲劳寿命试验、疲劳断口和金相组织分析,研究了Al-Li合金搅拌摩擦焊搭接接头的疲劳性能,分析了接头前进侧热机影响区(TMAZ, Thermal-Mechanically Affected Zone)出现的"钩状缺陷"对其疲劳性能的影响.结果表明,钩状缺陷容易引起裂纹萌生及扩展,减小接头的有效承载板厚,适当缩短搅拌针长度可以改善钩状缺陷,提高接头力学性能.母材与搭接接头的疲劳S-N曲线研究表明:在高疲劳应力下,接头的疲劳寿命接近母材,但随着疲劳应力水平降低,接头的疲劳寿命急剧下降,200万循环周次下的疲劳强度仅达到80 MPa,为母材的35%.     

气动发动机输出扭矩无因次分析

针对气动发动机的工作过程,利用能量方程、气体状态方程、连续性方程及运动过程方程建立气动发动机的非线性微分方程组.选取合适的基准量,对所建立的微分方程组进行无因次化,得到无因次化的数学模型.利用MATLAB/Simulink仿真工具,对无因次数学模型进行研究,得到各无因次量对气动发动机输出扭矩的影响.从仿真结果可以看出,气动发动机的无因次转速、进气门面积比例因子、排气门面积比例因子以及进气持续角度对气动发动机的无因次输出扭矩影响较大.当发动机转速升高扭矩急剧下降时,可以通过调整进气门面积比例因子、排气门面积比例因子以及进气持续角度使输出扭矩恒定.     

Comparison of ionosphere characteristic parameters obtained by ionosonde with IRI-2007 model over Southeast Asia

In this work, the foF2 and hmF2 parameters at the conjugate points near the magnetic equator of Southeast Asia are studied and compared with the International Reference Ionosphere (IRI) model. Three ionosondes are installed nearly along the magnetic meridian of 100°E; one at the magnetic equator, namely Chumphon (10.72°N, 99.37°E, dip angle 3.0°N), and the other two at the magnetic conjugate points, namely Chiang Mai (18.76°N, 98.93°E, dip angle 12.7°N) and Kototabang (0.2°S, 100.30°E, dip angle 10.1°S). The monthly hourly medians of the foF2 and hmF2 parameters are calculated and compared with the predictions obtained from the IRI-2007 model from January 2004 to February 2007. Our results show that: the variations of foF2 and hmF2 predicted by the IRI-2007 model generally show the similar feature to the observed data. Both parameters generally show better agreement with the IRI predictions during daytime than during nighttime. For foF2, most of the results show that the IRI model overestimates the observed foF2 at the magnetic equator (Chumphon), underestimates at the northern crest (Chiang Mai) and is close to the measured ones at the southern crest of the EIA (Kototabang). For hmF2, the predicted hmF2 values are close to the hmF2(M3000F2_OBS) during daytime. During nighttime, the IRI model gives the underestimation at the magnetic equator and the overestimation at both EIA crests. The results are important for the future improvements of the IRI model for foF2 and hmF2 over Southeast Asia region.     

Digital signal processing and numerical analysis for radar in geophysical applications

Numerical solutions for signal processing are described in this work as a contribution to study of echo detection methods for ionospheric sounder design. The ionospheric sounder is a high frequency radar for geophysical applications. The main detection approach has been done by implementing the spread-spectrum techniques using coding methods to improve the radar’s range resolution by transmitting low power. Digital signal processing has been performed and the numerical methods were checked. An algorithm was proposed and its computational complexity was calculated.     

Systematic examination of the geomagnetic storm sudden commencement using multi resolution analysis

Geomagnetic storm sudden commencements (SSC) contain a wealth of information which is useful in many applications. It is important to point out that the SSCs used in this study are sampled at the rate of one sample per second in order get use of such high resolution data. In this paper, two studies are made on the geomagnetic SSC and an SSC onset automatic detection algorithm is introduced. The first study is about finding the relationship between the SSC rise time and its amplitude. Where it is found that there is a positive correlation between the amplitude and the amplitude gradient which is the amplitude divided by rise time. The second study is checking the spectrum of the SSC, starting from its onset until the end of the SSC rise time. This check had proved that the SSC contains both low and high frequency regions. This led us to introduce a new term, namely the SSC variation rate (VR). This VR is defined as the maximum rate of change of the field in the higher-frequency region of the SSC. These two studies were the guide to build an SSC automatic detector of one sample per second data using multi resolution analysis (MRA) of the discrete wavelet transform (DWT). The data set contains 134 SSCs with different VRs that were collected from the Circum-pan Pacific Magnetometer Network (CPMN). It is found that the standard deviation of the detection error is 41 s and that the average error is 9 s. From the calculated error distribution function, it is found that the detection error is within the range of −1.5 to 3 min. The detection process, as will be shown in the article, takes 70 s for one station and 3 min if the decision is related to the detection(s) of other stations. These results demonstrate the superiority of the proposed algorithm over other algorithms in which the detection error ranges between −8 and 5 min and the detection process takes 2–10 min. In addition to being faster and more accurate than the other algorithms, the proposed algorithm is the first algorithm that automatically detects the SSC onset times from high-resolution data unlike previous studies that focused on determining the SSC times automatically using one-minute resolution data.     

Modelling and observing Jovian electron propagation times in the inner heliosphere

The propagation of Jovian electrons in interplanetary space was modelled by solving the relevant transport equation numerically through the use of stochastic differential equations. This approach allows us to calculate, for the first time, the propagation time of Jovian electrons from the Jovian magnetosphere to Earth. Using observed quiet-time increases of electron intensities at Earth, we also derive values for this quantity. Comparing the modelled and observed propagation times we can gauge the magnitude of the transport parameters sufficiently to place a limit on the 6 MeV Jovian electron flux reaching Earth. We also investigate how the modelled propagation time, and corresponding Jovian electron flux, varies with the well-known ∼13 month periodicity in the magnetic connectivity of Earth and Jupiter. The results show that the Jovian electron intensity varies by a factor of ∼10 during this cycle of magnetic connectivity.     

Testing the three-dimensional IRI-SIRMUP-P mapping of the ionosphere for disturbed periods

This paper describes the three-dimensional (3-D) electron density mapping of the ionosphere given as output by the assimilative IRI-SIRMUP-P (ISP) model for three different geomagnetic storms. Results of the 3-D model are shown by comparing the electron density profiles given by the model with the ones measured at two testing ionospheric stations: Roquetes (40.8°N, 0.5°E), Spain, and San Vito (40.6°N, 17.8°E), Italy. The reference ionospheric stations from which the autoscaled foF2 and M(3000)F2 data as well as the real-time vertical electron density profiles are assimilated by the ISP model are those of El Arenosillo (37.1°N, 353.3°E), Spain, Rome (41.8°N, 12.5°E), and Gibilmanna (37.9°N, 14.0°E), Italy. Overall, the representation of the ionosphere made by the ISP model is better than the climatological representation made by only the IRI-URSI and the IRI-CCIR models. However, there are few cases for which the assimilation of the autoscaled data from the reference stations causes either a strong underestimation or a strong overestimation of the real conditions of the ionosphere, which is in these cases better represented by only the IRI-URSI model. This ISP misrepresentation is mainly due to the fact that the reference ionospheric stations covering the region mapped by the model turn out to be few, especially for disturbed periods when the ionosphere is very variable both in time and in space and hence a larger number of stations would be required. The inclusion of new additional reference ionospheric stations could surely smooth out this concern.     

Estimation of ballistic coefficients of low altitude debris objects from historical two line elements

This paper presents a new method for estimating ballistic coefficients (BCs) of low perigee debris objects from their historical two line elements (TLEs). The method uses the drag perturbation equation of the semi-major axis of the orbit. For an object with perigee altitude below 700 km, the variation in the mean semi-major axis derived from the TLE is mainly caused by the atmospheric drag effect, and therefore is used as the source in the estimation of the ballistic coefficient. The method is tested using the GRACE satellites, and a number of debris objects with external ballistic coefficient values, and agreements of about 10% are achieved.