Enhanced multipath mitigation method based on multi-resolution CNR model and adaptive statistical test strategy for real-time kinematic PPP

This study proposes an enhanced multipath mitigation method based on multi-resolution carrier-to-noise-ratio (CNR) model and adaptive statistical test strategy for real-time kinematic precise point positioning (PPP) applications. The multi-resolution CNR model is established with GPS observation data collected from DOY 152 to 181 of 2019 by 230 globally distributed IGS stations, which used to analyze the relevant factors affecting CNR. Statistical results indicate that the CNR is not only related to the satellite elevation, but also closely related to the receiver types and specific satellite. The maximum difference between different receivers can reach 20 dB for the same satellite at the same elevation. In addition, the performance of the CNR is also obviously different between each satellite, and the maximum difference between different satellites is about 10 dB for the same receiver at the same elevation. Hence, in terms of the method which is based on CNR information for multipath detection and mitigation, the independence of receiver types, satellite and frequency must be considered. With the above analysis, this study developed a multi-resolution CNR model based on different receiver types, different satellites and different elevation firstly. Then, combined with the adaptive statistical test strategy which is based on the difference of CNR between inter-frequency and the difference of CNR between adjacent epochs, the multipath can be detected effectively. For the epoch which affected by multipath, the down-weighted strategy based on CNR is adopted to mitigate the influence of multipath on positioning. Real-time kinematic PPP data are collected to assess the proposed method, and the results demonstrate that the proposed method can detect the multipath effectively, and the detection rate can reach 90.28%. Moreover, after adopting the mitigation strategy, the RMS bias of the east, north and up components are improved about 19.95%, 17.89% and 23.07% compared to the original results, respectively. It is worth noting that this proposed method is also suitable for other GNSS, such as GLONASS and BDS, but the corresponding CNR model must be established simultaneously.     

Postcapture stabilization of space robots considering actuator failures with bounded torques

Space robotics is regarded as one of the most impressing approaches for space debris removal missions. Due to the residual momentum of debris, it is essential to stabilize the base rapidly after capture. This paper presents a novel control strategy for stabilization of a space robot in postcapture considering actuator failures and bounded torques. In the control strategy, the motion of the manipulator is not regarded as a disturbance to the base; in contrast, it is utilized to compensate for the limitation of the control torques by means of an inverse dynamical model of the system. Different scenarios where actuators are external mechanisms or momentum exchange devices have been carried out, and for actuator failures, both single- and two-actuator failures have been considered. Regarding to the performance of actuators, control torques are bounded. In cases that either single or two actuators have failed, the base can be stabilized kinematically when actuators are external mechanisms, but can only be stabilized dynamically when only momentum exchange devices are used. Finally, a space robot with a seven-degree-of-freedom manipulator in postcapture is studied to verify the validity and feasibility of the proposed control scheme. Simulation results show that the whole system can be stabilized rapidly.     

聚合物淬火介质CH-202M在钢铁零件淬火上的基础研究

 聚合物淬火介质冷却金属时于金属表面形成一层聚合物隔离膜,45钢和40Cr钢在不同浓度介质中淬火,可得到比水淬、油淬更大的淬透深度和更小的淬火变形,并可防止淬火开裂。淬火后的组织正常,机械性能符合要求。故表明,此种介质用于钢铁零件淬火非常有效。本文还对使用中的一些管理问题进行了阐明。     

Use of the radial velocity measurement in target tracking

A new sequential filtering algorithm that incorporates the radial velocity measurement into a Kalman filter, in the presence of correlated range and radial velocity measurement errors, is presented. An analysis is given concerning its asymptotic behavior on the basis of analysis of its stochastic controllability and observability. The simulation results verify the analysis and show that the new algorithm is superior to the conventional extended Kalman filter (EKF) and close to an ideal filter.     

信道状态信息无线感知数据获取及应用综述

近年来,基于信道状态信息（CSI）的无线感知技术在室内定位、活动识别、健康检测等方向有众多探索性研究应用。然而,现有研究获取CSI数据主要依靠自主采集,对CSI开源数据集和数据采集设备/工具的研究现状不够清晰。首先阐述了基于无线保真（WiFi）CSI的无线感知技术,详细介绍了9种CSI数据采集设备/工具,概括了CSI的应用方向及研究现状,并汇总了近5年的CSI开源数据集,分析了现有CSI无线感知研究的局限性与面临的挑战,最后总结全文并对CSI无线感知未来的发展进行展望。     

有向拓扑下无径向速度测量的多导弹协同制导

针对多枚导弹在平面内从各自期望的方向同时击中移动目标问题,提出一种有向通信拓扑下无需导弹-目标径向速度测量且带视线角约束的分布式有限时间协同制导律。基于平面内导弹-目标相对运动方程建立带视线角约束的多导弹协同制导模型。基于二阶多智能体协同控制理论设计了视线方向上的制导律,可保证有向拓扑下多导弹的打击时刻在有限时间内达到一致。基于齐次系统稳定性理论和积分滑模控制理论设计了视线法向方向上的制导律,可保证多导弹击中移动目标且视线角在有限时间内收敛到期望值。仿真校验所设计的协同制导律在理想条件下可使有向拓扑下的多导弹从各自的期望方向同时击中移动目标。     

航天器平台-载荷-控制一体化协同研制

航天器任务能力的指标提升,对卫星系统设计的深入、精细以及集约要求更高。以系统性能最优为终极目标,围绕任务能力开展多学科一体化设计,进而引起的产品集成、验证模式的显著改变。本文对国内外航天器多学科一体化研制模式的发展和应用情况进行介绍,分析了一体化设计的需求和内涵,并对多学科一体化协同平台的实现及探索性应用进行了研究。     

HCKF性能评估及其在传递对准中的应用

针对高阶容积卡尔曼滤波(HCKF)算法在传递对准中的应用问题,提出综合运用多变量函数泰勒级数展开和计算复杂度分析的性能评估方法。基于高阶球面-径向容积准则建立HCKF算法模型,并对其估计精度和计算量进行量化和对比分析：HCKF具有5阶泰勒级数展开精度且计算复杂度为O(n 4),综合性能优于高斯厄米特积分滤波(GHQF)和无迹卡尔曼滤波(UKF)。将三种非线性滤波算法应用到舰机大失准角传递对准系统中,摇摆台试验结果表明：HCKF的估计精度比UKF高17%,计算量比GHQF小2个数量级,与HCKF性能评估结果一致。     

基于序列凸规划的运载火箭轨迹在线规划方法

针对大气层内气动力对轨迹规划求解实时性与收敛性的影响,提出一种基于模型补偿序列凸规划的大气层内火箭轨迹规划方法.该方法的核心思想是通过设计一种序列补偿的方式,将火箭动力学中非线性项(气动力加速度与重力加速度)与过程约束项(动压、过载约束等)进行凸化,从而将轨迹规划问题转化为序列凸规划问题而得到快速求解.在此基础上,本文...     

车辆导航系统中超前滞后校正方法

分析了车辆导航系统中超前滞后产生的原因,提出了利用地图匹配MM(Map Matching)进行GPS(Global Positioning System)/DRS(Dead Reckoning System)组合导航系统超前滞后校正的方法.该方法是将超前滞后误差归结为GPS误差,先利用GPS沿道路垂直方向上误差的可观测性进行GPS误差校正,再将校正的GPS信息与DRS信息进行卡尔曼滤波,从而减少组合导航系统超前滞后误差.仿真结果表明上述方法是行之有效的.