基于MC145152的VOR地面信标模仿仪频率合成器的设计与实现

本文提出了VOR地面信标模仿仪对频率合成器的要求,介绍了集成锁相环芯片MC145152的工作特性,验证了基于MC145152的PLL频率合成器在VOR地面信标模仿仪中的设计与实现的有效性。     

远红外加热制备预浸带及其对复合材料性能的影响

以远红外加热方式制备了连续芳纶纤维浸胶带，并与工艺成熟的电加热方式制备的预浸带及相应的复合材料性能作比较，确定了远红外加热预浸胶工艺参数。研究结果表明，远红外加热所制备的预浸带性能及相应复合材料压力容器性能与现行工艺成熟的电加热制品性能相当。     

耦合进排气壳的增压器涡轮流动干扰及激振力弱化研究

为探究船用增压器涡轮在耦合进排气壳条件下的流动特性,采用SST湍流模型和FFT方法对某增压器轴流涡轮与进排气壳耦合的流场进行非定常数值模拟,重点分析排气壳非对称流场对涡轮动叶片压力的干扰特性和扰动来源,在此基础上提出基于导叶非对称布局的激振力弱化改型方案并进行了验证。结果表明：进气壳影响静叶前缘静压沿周向的分布,排气壳流场导致的非对称背压会给动叶表面造成低频的压力波动,约为3.6%的转子通过频率,在尾缘吸力面处该低频波动幅值大于动静叶排干涉导致的高频波动幅值;排气壳内部复杂的分离流动和涡系结构是产生上述流动干扰的主要原因。4种非对称布局方案都能在几乎不影响涡轮性能的前提下分散并弱化高频波动幅值;其中Case2尾缘高频幅值减小了98.6%,低频幅值减小了52.6%,而且涡轮效率还有略微提高,为最优布局。     

从双层到多层带有微结构的硅硅直接键合技术研究

通过理论分析和实验验证对多层带有微结构的硅硅直接键合技术进行了研究.采用的硅片表面活化处理方法是亲水湿法,采用的键合工艺流程是先将硅片在键合机中进行预键合,再使用退火炉进行高温退火.其中预键合参数对多层键合成功与否起到决定性的作用,为节约实验时间,针对3个主要预键合参数（温度、压力、时间）的选取进行了详细的正交实验分析.使用项目组自制的硅硅键合分析软件对键合片的红外图像进行处理分析,计算键合率.采用实验得到的最佳预键合工艺参数,多层键合的键合率达到了86.6527%.      

舰载遥测设备伺服跟踪视轴稳定方法研究

论述了舰船摇摆对视轴稳定的影响,给出了由于舰船摇摆所引起的视轴附加角速度公式;分析了陀螺稳定回路的性能,给出了数学模型。所采用的视轴稳定方法,经过海上试验,船摇隔离度满足技术指标的要求。     

发射天线配置对混响室性能的影响研究

为了优化混响室的结构设计,采用基于矩量法的电磁仿真软件FEKO分别对不同发射天线配置时混响室内的电磁场进行了仿真计算,考察了发射天线的种类和位置对混响室场性能的影响,结果表明选择合适的发射天线并进行合理的位置设计能显著改善混响室内电场的性能。     

A Celestial Analytic Positioning Method by Stellar Horizon Atmospheric Refraction

This article, in allusion to the limitation of conventional stellar horizon atmospheric refraction based on orbital dynamics model and nonlinear Kalman filter in practical applications, proposes a new celestial analytic positioning method by stellar horizon atmospheric refraction for high-altitude flight vehicles, such as spacecraft, airplanes and ballistic missiles. First, by setting up the geometric connexion among the flight vehicle, the Earth and the altitude of starlight refraction, an expression for the relationship of starlight refraction angle and atmospheric density is deduced. Second, there are produced a novel measurement model of starlight refraction in a continuous range of altitudes (CRA) from 20 km to 50 km on the basis of the standard atmospheric data in stratosphere, and an empirical formula of stellar horizon atmospheric refraction in the same altitudes against the tangent altitude. Third, there is introduced a celestial analytic positioning algorithm, which uses the least square differential correction instead of nonlinear Kalman filter. The information about positions of a flight vehicle can be obtained directly by solving a set of nonlinear measurement equations. The stellar positioning algorithm adopts the characteristics of stellar horizon atmospheric refraction thereby removing needs for orbit dynamics models and priori knowledge of flight vehicles. The simulation results evidence the validity of the proposed stellar positioning algorithm.     

基于HS3282的ARINC429航空通讯总线设计

ARINC429通讯总线已经广泛应用在航空电子系统中,成为机载设备之间通讯主要接口。简要地介绍了ARINC429接口的硬件设计和软件算法。在航电系统通讯设计中具有典型性和实用性。     

军队装备修理保障企业保密安全工作初探

军队装备修理保障企业，是我军装备能力建设的重要组成部分，也是敌特分子渗透破坏和拉拢的重点目标。确保军队装备修理保障企业保密安全，事关企业的生死存亡，更是企业的政治要求。本文就军队装备修理企业的保密安全工作现状，以及存在的问题，就如何结合自身实际开展保密安全工作，进行了探索。     

Assessing attitude error of FORMOSAT-3/COSMIC satellites and its impact on orbit determination

An attitude determination and control system (ADCS) is critical to satellite attitude maneuvers and to the coordinate transformation from the inertial frame to the spacecraft frame. This paper shows specific sensors in the ADCS of the satellite mission FORMOSAT-3/COSMIC (F3/C) and the impact of the ADCS quality on orbit accuracy. The selection of main POD antenna depends on the beta angles of the different F3/C satellites (for FM2 and FM4) during the inflight phase. In particular, under the eclipse, alternative attitude sensors are activated to replace the Sun sensors, and such a sensor change leads to anomalous GPS phase residuals and a degraded orbit accuracy. Since the nominal attitude serves as a reference for ADCS, the 3-dimensional attitude-induced errors in reduced dynamic orbits over selected days in 2010 show 9.35, 10.78, 4.97, 5.48, 7.18, and 6.89 cm for FM1–FM6. Besides, the 3-dimensional velocity errors induced by the attitude effect are 0.10, 0.10, 0.07, 0.08, 0.09, and 0.10 for FM1–FM6. We analyze the quality of the observed attitude transformation matrix of F3/C and its impact on kinematic orbit determination. With 249 days of GPS in 2008, the analysis leads to the following averaged 3-dimensional attitude-induced orbit errors: 2.72, 2.62, 2.37, 1.90, 1.70, and 1.99 cm for satellites FM1–FM6. Critical suggestions of geodetic payloads for the follow-on mission of F3/C are presented based on the current result.