The Radarsat Antarctic Mapping Mission

The Radarsat Earth-observation satellite was launched on November 4, 1995 aboard a Delta 2 rocket. Equipped with a sophisticated synthetic aperture radar (SAR), Radarsat can produce images of extraordinary clarity even through clouds, smog, haze, smoke, and darkness. The SAR has a variety of operating modes. It can be adjusted to produce swathes between 35 and 500 km in width, with ground resolutions from 100 m to as low as eight. In addition, the beam can be steered at angles up to 49° from the satellite's nadir vector, giving it the unique ability to image areas it is not directly overflying. In exchange for the launch, CSA agreed to provide NASA with access to the SAR data, and to execute a 180° yaw-around of Radarsat twice during its lifetime to map the Antarctic continent. Preliminary results from the first of these Antarctic Mapping Missions, dubbed AMM-1, are presented     

Design of the TRIO system-on-chip for aerospace

Several design and testing aspects of the TRIO smart sensor data acquisition chip, developed by JHU/APL for NASA spacecraft applications are presented. TRIO includes a 10 bit self-corrected analog-to-digital converter (ADC), 16/32 analog inputs, a front end multiplexer with selectable aquisition time, a current source, memory, serial and parallel bus, and control logic. So far TRIO is used in many missions including Contour, Messenger, Stereo, Pluto, and the generic JPL X2000 spacecraft bus.     

Observations of diffuse galactic positron annihilation radiation

The Galactic plane was scanned nearly three times by the UCSD/MIT Hard X-Ray and Low Energy Gamma-Ray Experiment on HEAO-1 from August 1977 through September 1978. Its Medium Energy Detectors were of the NaI/CsI phoswich type and operated over the 100 keV to 2 MeV range, with a 17° FWHM field of view and a 9% energy resolution at 511 keV. Sky maps for each epoch of observation were constructed in several energy bands. After subtraction of known point sources, a component associated with the galactic plane remains, whose spectrum is consistent with a power law and a positron annihilation spectrum. In the 333 to 583 keV energy band the flux is concentrated within ±35° of the galactic center, and the ratio of flux/radian (anticenter) is high, with a 2σ lower limit of 13. The parameters of the galactic center region's annihilation spectrum are positronium fraction of 0.9±0.1 and 511 keV flux of (2.0±0.7)×10⁻³ photons/cm²-sec-rad.     

MMS星座对磁层顶磁通量绳内离子惯性尺度结构的观测

利用MMS观测数据,对磁层顶通量绳内离子惯性尺度（d_i）的结构进行分析研究.结果发现,许多不同尺度（约1d_i至数十d_i）的通量绳内都存在具有d_i尺度的电流 j _m,其方向在磁层顶局地坐标系的-M方向,即与磁层顶查普曼-费拉罗电流同向,由电子在+M方向的运动（ v _em）携带.这些电流结构具有以下特征：磁鞘与磁层成分混合,磁场为开放形态;离子去磁化,电子与磁场冻结;N方向（即垂直于磁层顶电流片方向）的电场 E _n显著增大,幅度达到约20mV·m^-1,并伴有明显的尖峰状起伏,该增强和尖峰状起伏的电场对应于霍尔电场.分析表明,电流、电子与离子运动的偏离以及霍尔电场之间遵从广义欧姆定律,三者密切关联.进一步对磁层顶磁重联的探测数据进行分析发现,在很多重联区内也存在与通量绳内相似的结构,其尺度约为d_i量级,其中霍尔电场 E _N、电流 j _M和电子速度 v _eM均与通量绳内对应物理量的方向相同且幅度相近.基于上述观测事实,采用经典FTE通量绳模型,对通量绳内电流、电子运动和霍尔电场的起源进行了初步探讨,认为其来源于磁层顶无碰撞磁重联区内的相应结构,并且后者在离子尺度通量绳的形成过程中起到重要作用.     

Composite model of a research flight simulator for a helicopter with the hingeless main rotor

This paper presents a composite model of a flight simulator. This simulator is intended for carrying out investigative tests of flight dynamics imitation models of a hingeless rotor helicopter. A schematic diagram, composition and operation channels of the flight simulator software are presented. A possibility of applying the control lag is estimated.     

Filtering of discontinuous processes arising in marine integratednavigation systems

A refined stochastic model for the errors of the Loran-C radio navigation aid is described, and it is shown how this model can be used to improve the performance of integrated navigation systems. In addition to the usual propagation errors, Loran-C time of arrival measurements are occasionally plagued with sudden intermittent errors of a particular magnitude and caused by receiver cycle selection errors. These result in sudden large jumps in the calculated position solution. The Loran-C error has been modeled as the sum of a diffusion process, representing the normal propagating errors, and a pure jump process of Poisson type, representing the cycle selection errors. A simple integrated navigation system is then described, based on the Loran-C model and the standard dead reckoning (heading and speed) system model. Assuming that the observed process is governed by a linear stochastic difference equation, a recursive linear unbiased minimum variance filter is developed, from which the Loran-C and dead reckoning errors, and hence position and velocity, can be estimated     

The effect of small vibrations on Marangoni convection and the free surface of a liquid bridge

The effects of small vibrations on Marangoni convection were investigated experimentally using a liquid bridge of 5 cSt silicone oil with a disk diameter of 7.0 mm, and an aspect ratio close to 0.5. Experiments were performed to determine the critical temperature difference data for no vibration case and with small vibrations applied. The experimental results have shown that the effect of small vibrations on the onset of oscillatory flow is small since the critical temperature difference data for different aspect ratios were not affected by the vibrations. To clarify the surface oscillation phenomena induced by external vibrations, a 3-D numerical simulation model was also developed using a level set algorithm to predict the surface oscillations of isothermal silicone oil bridges. By subjecting the liquid bridge to small vibrations, the surface oscillation characteristics were predicted numerically, and the numerical results compared well with the predictions of an analytical model proposed previously. Furthermore, the effect of small vibrations on the surface vibration amplitude of the liquid bridge is also discussed.     

Surface characteristics of spacecraft components affect the aggregation of microorganisms and may lead to different survival rates of bacteria on Mars landers

Layers of dormant endospores of Bacillus subtilis HA101 were applied to eight different spacecraft materials and exposed to martian conditions of low pressure (8.5 mbar), low temperature (-10 degrees C), and high CO(2) gas composition and irradiated with a Mars-normal ultraviolet (UV-visible- near-infrared spectrum. Bacterial layers were exposed to either 1 min or 1 h of Mars-normal UV irradiation, which simulated clear-sky conditions on equatorial Mars (0.1 tau). When exposed to 1 min of Mars UV irradiation, the numbers of viable endospores of B. subtilis were reduced three to four orders of magnitude for two brands of aluminum (Al), stainless steel, chemfilm-treated Al, clear-anodized Al, and black-anodized Al coupons. In contrast, bacterial survival was reduced only one to two orders of magnitude for endospores on the non-metal materials astroquartz and graphite composite when bacterial endospores were exposed to 1 min of Mars UV irradiation. When bacterial monolayers were exposed to 1 h of Mars UV irradiation, no viable bacteria were recovered from the six metal coupons listed above. In contrast, bacterial survival was reduced only two to three orders of magnitude for spore layers on astroquartz and graphite composite exposed to 1 h of Mars UV irradiation. Scanning electron microscopy images of the bacterial monolayers on all eight spacecraft materials revealed that endospores of B. subtilis formed large aggregates of multilayered spores on astroquartz and graphite composite, but not on the other six spacecraft materials. It is likely that the formation of multilayered aggregates of endospores on astroquartz and graphite composite is responsible for the enhanced survival of bacterial cells on these materials.     

The Rosat mission

The primary scientific objective of the ROSAT mission is to perform the first all sky survey with an imaging X-ray telescope leading to an improvement in sensitivity by several orders of magnitude compared with previous surveys. Consequently a large number of new sources (> 10⁵) will be discovered and located with an accuracy of 1 arcmin. After completion of the survey which will take about half a year the instrument will be used for detailed observations of selected targets.The X-ray telescope consists of a fourfold nested Wolter type I mirror system with 80 cm aperture and 240 cm focal length, and three focal plane detectors. In the baseline version these will be imaging proportional counters (0.1 – 2 keV) providing a field of view of 2⁰ × 2⁰.