A bioreactor system for the nitrogen loop in a Controlled Ecological Life Support System.

As space missions become longer in duration, the need to recycle waste into useful compounds rises dramatically. This problem can be addressed by the development of Controlled Ecological Life Support Systems (CELSS) (i.e., Engineered Closed/Controlled Eco-Systems (ECCES)), consisting of human and plant modules. One of the waste streams leaving the human module is urine. In addition to the reclamation of water from urine, recovery of the nitrogen is important because it is an essential nutrient for the plant module. A 3-step biological process for the recycling of nitrogenous waste (urea) is proposed. A packed-bed bioreactor system for this purpose was modeled, and the issues of reaction step segregation, reactor type and volume, support particle size, and pressure drop were addressed. Based on minimization of volume, a bioreactor system consisting of a plug flow immobilized urease reactor, a completely mixed flow immobilized cell reactor to convert ammonia to nitrite, and a plug flow immobilized cell reactor to produce nitrate from nitrite is recommended. It is apparent that this 3-step bioprocess meets the requirements for space applications.     

Dose equivalent, absorbed dose and charge spectrum investigation in low Earth orbit.

Particle intensity, dose equivalent and absorbed dose have been measured on board the space shuttle Endeavour during STS-108 in December 2001 by Dublin Institute for Advanced Studies (DIAS). The dose estimates are based on very accurate measurements of recoils produced in CR-39 by cosmic ray primary and secondary protons and heavier nuclei and by secondary neutrons. The corresponding LET spectra were used to determine dose equivalent and absorbed dose values. Estimates of the total flux of Z > or = 2 nuclei have been undertaken and a preliminary charge spectrum was measured. Some comparisons are made with preliminary data obtained on STS-105 (ISS Expedition) and other missions using CR-39 detectors.     

Family of constrained signal detectors for hyperspectral imagery

Generalized likelihood ratio tests (GLRTs) are derived for the problem of detecting targets in hyperspectral images. These detectors are derived under the assumptions that the signals from the materials in the image mix linearly and that the noise in the system is Gaussian. It is also assumed that the abundances of the signals from the various materials in a pixel must sum to one. This constraint models the fact that the material abundances in a pixel are just the fraction of the pixel that they occupy. Under these assumptions, detectors are derived which outperform the detectors derived without the sum-to-one constraint.     

New instrumentation for optical measuring of oxygen in gas or dissolved in liquids.

The optical oxygen sensor is a novel device for the determination of oxygen in gases or dissolved in liquids. It is based on the measurement principle of fluorescence quenching, which is completely different from that of polarographic oxygen sensors (today the most widespread devices of oxygen detection). The new instrument offers features and advantages, which render it not only a realistic alternative, but, for specific applications, make it superior to existing electrochemical methods. The system is based on low-cost semiconductor devices (light-emitting diodes, photodiodes, low-cost analogue and digital components) and new LED-compatible oxygen-sensitive membranes. The flow cell of the instrument may be thermostatted and the sensor can be calibrated by a simple two-point calibration procedure. The optical oxygen sensor is particularly suitable for measuring dissolved oxygen in respirometry, since no oxygen is consumed by the device and the signal is independent of sample flowrate or stirring speed. Typical fields of application are monitoring of oxygen in ground and drinking water, in process control in bioreactors and in breath gas and blood gas analysis.     

Injuries to plants from controlled environment contaminants.

The use of controlled environments is subject to problems from contaminants emitted from materials of the system and from plants. Many contaminants are difficult to identify because injurious dosages are very low, there is a lack of information on what compounds injure plants, because species and cultivars differ greatly in their sensitivity to injury and injury symptoms often are not distinctive. Plastics have been shown to emit many different volatile compounds. The compound, di-butyl phthalate, contained in certain flexible plastics, has been shown to be very toxic to plants. Other injuries have been produced by caulking compounds and bonded screening. Paints have been shown to release xylene that is toxic to plants. Steam for humidification can cause problems because of hydroxylamines and other compounds added to steam used for heating to control fungal growth in return lines. Mercury, from broken thermometers is a particular problem in growth chambers because small quantities can collect in cracks and slowly volatilize to slow growth of plants. Plants themselves release large quantities of volatile hydrocarbons, with ethylene being the commonly recognized chemical that can be damaging when allowed to accumulate. People release large quantities of carbon dioxide which can cause variations in the rate of growth of plants. Contaminant problems can be controlled through filtering of the air or ventilation with make-up air, however the potential for problems is always present and careful testing should be undertaken with the particular species and cultivars being grown insure that there are no toxic agents altering growth in each particular controlled environment being utilized.     

Nanotechnology-based molecular test equipment (MTE)

This paper describes original research efforts in the design, simulation, and development of nanotechnology-based molecular test equipment (MTE). This is a research effort for testing printed circuit boards independent of traditional automatic test equipment (ATE) through the fabrication of MTE within integrated circuits (ICs). The MTE is embedded within the IC substrate and encapsulated within nanoprobes that connect between the surface and the substrate of the IC at various functional areas. A process is followed whereby IC device simulation is performed to assess the electrical, chemical, and structural properties of integrated and adjacent substrate devices. Through this approach the nominal and failed device performance parameters of interest to substrate-based MTE are found. Discussion of the development and application of MTE within IC architectures is provided, including such topics as the effect of substrate composition on the design and realization of MTE, interfaces between MTE and IC devices, and reporting of MTE results to the IC surface and technician. Potential application areas within different device functions will also be identified. A chemical structure diagram is also provided to illustrate the implementation of MTE using discrete device configurations with MTE-augmented logic     

An introduction to gravity perception in plants and fungi--a multiplicity of mechanisms.

The origin and subsequent evolution of life on Earth has taken place within an environment of which a 1g gravitational force is a part. Thus, all living organisms accommodate this variable in their structure and function. Evolution has also selected mechanisms to sense gravity which, in consequence, give particular orientations to living process. It is anticipated that the higher the evolutionary status of an organism, the greater the chance that it will possess multiple mechanisms of gravisensing because evolution discards nothing that assists fitness, but only adds to existing processes. A multiplicity of mechanisms permits gravity to participate in a wide range of developmental programmes, such as taxes, morphisms and tropisms, through the action of different sensors and distinct transduction/response pathways.     

A large flat panel multifunction display for military and spaceapplications

A flat panel multifunction display (MFD) that offers the size and reliability benefits of liquid crystal display technology while achieving near-CRT display quality is presented. Display generation algorithms that provide exceptional display quality are being implemented in custom VLSI components to minimize MFD size. A high-performance processor converts user-specified display lists to graphics commands used by these components, resulting in high-speed updates of two-dimensional and three-dimensional images. The MFD uses the MIL-STD-1553B data bus for compatibility with virtually all avionics systems. The MFD can generate displays directly from display lists received from the MIL-STD-1553B bus. Complex formats can be stored in the MFD and displayed using parameters from the data bus. The MFD also accepts direct video input and performs special processing on this input to enhance image quality     

The SOHO CELIAS/SEM EUV database from SC23 minimum to the present

The SOHO Solar EUV Monitor has been in operation since December 1995 onboard the SOHO spacecraft. This instrument is a highly stable transmission grating solar extreme ultraviolet spectrometer. It has made nearly continuous full disk solar irradiance measurements both within an 8 nm bandpass centered at 30.4 nm and throughout the 0.1 to 50 nm solar flux region since launch. The 30.4 nm flux, the 0.1 to 50 nm flux and the extracted soft X-ray (0.1 to 5 nm) flux are presented and compared with the behavior of solar proxies.