The Magnetospheric Multiscale Magnetometers

The success of the Magnetospheric Multiscale mission depends on the accurate measurement of the magnetic field on all four spacecraft. To ensure this success, two independently designed and built fluxgate magnetometers were developed, avoiding single-point failures. The magnetometers were dubbed the digital fluxgate (DFG), which uses an ASIC implementation and was supplied by the Space Research Institute of the Austrian Academy of Sciences and the analogue magnetometer (AFG) with a more traditional circuit board design supplied by the University of California, Los Angeles. A stringent magnetic cleanliness program was executed under the supervision of the Johns Hopkins University’s Applied Physics Laboratory. To achieve mission objectives, the calibration determined on the ground will be refined in space to ensure all eight magnetometers are precisely inter-calibrated. Near real-time data plays a key role in the transmission of high-resolution observations stored on board so rapid processing of the low-resolution data is required. This article describes these instruments, the magnetic cleanliness program, and the instrument pre-launch calibrations, the planned in-flight calibration program, and the information flow that provides the data on the rapid time scale needed for mission success.     

Some Aspects of Swerling Models for Fluctuating Radar Cross Section

The structure of Swerling's 1957 model for fluctuating radar cross section and signal amplitude is examined prinwrily in terms of mixture representations. The authors also show the relationship of Nakagami's m distrubution to Swerling's amplitude distribution, and Nakagami's q distribution (Hoyt vector density) is reduced to the Swerling distribution. Nonuniform phase distributions associated with Swerling's functions are also derived. Results are given when Swerling's amplitude density is used as a prior distribution with Bennett's (Rice's) distribution for the amplitude of a sine wave plus narrowband Gaussian noise.     

The polarization of celestial X-rays

The processes by which X-radiation may be emitted by celestial sources are investigated, and the net polarization such radiation would possess is predicted. The amount of polarization observed at the Earth would depend both on the mechanism producing the radiation and on the fractional extent of the source over which it is coherently polarized. Highly polarized X-radiation would suggest synchrotron emission as the source mechanism. Radiation whose polarization is low but nonzero would be produced by synchrotron emission from a source whose magnetic fields are inhomogeneous on a large scale, or by bremsstrahlung of electrons whose velocity vectors lie in one predominant direction. Nonobservable polarization would result from sources of synchrotron radiation whose magnetic fields show small-scale irregularities, from the bremsstrahlung of electrons whose velocity vectors are either random or spherically symmetric in direction over the entire source, or from sources whose mechanism of producing the radiation imparts no net polarization, e.g., thermal radiation from neutron stars, line radiation from electronic shell transitions within atoms, and the inverse Compton effect. Measurement of the net polarization of the X-rays from the several known celestial sources could thus lead to the specification of the mechanisms capable of producing the radiation from such sources.     

STADAR: Servo Tester with Automatic Data Acquisition and Reduction

STADAR is a Servo Tester with Automatic Data Acquisition and Reduction developed for the Apollo program. This paper describes the operational capability of STADAR and discusses certain aspects of the design. STADAR evaluates system performance by supplying an input stimuli and two data acquisition and analysis channels. Stimuli (0.02-30 c/s 0-10 V peak) are automatically programmed to a frequency accuracy of ±0.01 percent and an amplitude accuracy of ± 0.1 percent. Data acquisition accuracy is 0.1 percent or 50 microvolts. System design utilizes programmable data filters to improve system S/N ratio. Active filter mechanization methods and results are presented as well as techniques for instantaneous precise generation of stimuli which are automatically programmed.     

Design and Application of an Adaptive Tracking Filter Control System

The design of an adaptive tracking filter control system and its application to large flexible booster vehicles is described. The problem of elastic vehicle stability is considered along with its solution by conventional and adaptive techniques. The improvement in vehicle stability, which may be achieved with the adaptive tracking filter technique as compared to conventional techniques, is shown. The control system evolved uses two adaptive tracking filters to phase stabilize the first and second bending modes, in addition to conventional compensation techniques. The application of this adaptive technique to a vehicle in which the modal frequencies are in close proximity (<2.5 percent separation) is discussed. The mechanization of the adaptive control system involves the selection of design techniques and components that are electrically and physically compatible with the intended airborne application. The development of a suitable frequency tracking technique and tracking filter is described, in addition to the electronic and mechanical design of the adaptive control system prototype.     

Astrometric positioning and orbit determination of geostationary satellites

In the project titled “Astrometric Positioning of Geostationary Satellite” (PASAGE), carried out by the Real Instituto y Observatorio de la Armada (ROA), optical observation techniques were developed to allow satellites to be located in the geostationary ring with angular accuracies of up to a few tenths of an arcsec. These techniques do not necessarily require the use of large telescopes or especially dark areas, and furthermore, because optical observation is a passive method, they could be directly applicable to the detection and monitoring of passive objects such as space debris in the geostationary ring.     

Market mature 1998 hybrid electric vehicles

Beginning in 1990, the major automotive passenger vehicle manufacturers once again re-evaluated the potential of the battery powered electric vehicle (EV). This intensive effort to reduce the battery EV to commercial practice focused attention on the key issue of limited vehicle range, resulting from the low energy density and high mass characteristics of batteries, in comparison to the high energy density of liquid hydrocarbon (HC) fuels. Consequently, by 1995, vehicle manufacturers turned their attention to hybrid electric vehicles (HEV). This redirection of EV effort was highlighted finally in 1997, at the 57th Frankfurt Motor Show, the Audi Duo parallel type hybrid was released for the domestic market as a 1998 model vehicle. Also at the 1997 32nd Tokyo Motor Show, Toyota Hybrid System (THS) Prius was released for the domestic market as a production 1998 model vehicle. This paper presents a comparative analysis of the key features of these two 1998 model year production hybrid systems. Among the conclusions, two issues are evident: one, the major manufacturers have turned to the hybrid concept in their search for solutions to the key EV issues of limited range; and, heating/air conditioning; and two, the focus is now on introducing hybrid EV for test marketing domestically     

Source and loss processes in the inner magnetosphere

Space Science Reviews -