五自由度磁悬磨头电控系统研究

研究的高速磨床电磁悬浮磨头电控系统尽量采用最新技术，在保证系统 性能的前提下降低了系统造价。在该系统中采用TMS320F240 DSP芯片作为控制核心，同时控制磁悬浮轴承的悬浮和变频电机调速，采用运行效率很高的汇编语言编写控制软件，其中磁悬浮轴承是PID控制算法，电机调速为SPWM方式。磁悬浮轴承PWM功率放大器中采用能简化驱动的新型半桥电路，电机调速主电路中采用智能功率模块（IPM）。动态刚度测试和高速运转实验表明，该电控系统满足高速磨床电磁悬浮磨头的控制要求。     

Potential Effects of Surface Temperature Variations and Disturbances and Thermal Convection on the Mars InSight HP<Superscript>3</Superscript> Heat-Flow Determination

The HP³ instrument on the InSight lander mission will measure subsurface temperatures and thermal conductivities from which heat flow in the upper few meters of the regolith at the landing site will be calculated. The parameter to be determined is steady-state conductive heat flow, but temperatures may have transient perturbations resulting from surface temperature changes and there could be a component of thermal convection associated with heat transport by vertical flow of atmospheric gases over the depth interval of measurement. The experiment is designed so that it should penetrate to a depth below which surface temperature perturbations are smaller than the required measurement precision by the time the measurements are made. However, if the measurements are delayed after landing, and/or the probe does not penetrate to the desired depth, corrections may be necessary for the transient perturbations. Thermal convection is calculated to be negligible, but these calculations are based on unknown physical properties of the Mars regolith. The effects of thermal convection should be apparent at shallow depths where transient thermal perturbations would be observed to deviate from conductive theory. These calculations were required during proposal review and their probability of predicting a successful measurement a prerequisite for mission approval. However, their uncertainties lies in unmeasured physical parameters of the Mars regolith.     

Designing corrections for the trajectory of the <Emphasis Type="Italic">Spektr-R</Emphasis> spacecraft in the event of immersions into the Moon’s sphere of influence

The results of updating the parameters of motion of the Spektr-R spacecraft at the end of 2016 have shown that, in January 2018, with a probability close to unity, the condition that a spacecraft stay in the Earth’s shadow is violated; however, in May of the same year, the ballistic life of the spacecraft will be terminated. Thus, in 2017, the question arose of how to design the correction of flight of this spacecraft using its onboard propulsion system. The correction was designed with allowance for the fact that, for the first time since it was launched, the spacecraft in the course of several years, beginning with 2017, repeatedly approaches the Moon, deeply immersing into its sphere of influence. This paper presents the technologically and organizationally convenient, allowable versions of upcoming correction of the Spektr-R spacecraft trajectory and justifies the particular scheme of its implementation.     

Force on a coil moving above a grid structure

The force on a coil moving with a high-speed parallel to a conducting grid consisting of parallel tubes is investigated. The coil performs a rebound motion or an oscillatory heave motion when pressed toward the grid by reactive on-board engines. The coil is approximated by two parallel wires moving parallel to the grid tubes. The corresponding electrodynamic problem is two dimensional and is solved by expansions in terms of Bessel functions. Expressions are derived for the lift and drag force as well as the heat generated in the tubes in the limit of strong skin effect. The dependence on the grid spacing is analysed in the approximation of no mutual inductance between the tubes. Two specific applications are a shunt deflecting the coil, and a funnel leading to multiple reflection. Finally, the varying magnetic flux threading the coil is considered and the thermal load of the coil is estimated.     

The effect of small vibrations on Marangoni convection and the free surface of a liquid bridge

The effects of small vibrations on Marangoni convection were investigated experimentally using a liquid bridge of 5 cSt silicone oil with a disk diameter of 7.0 mm, and an aspect ratio close to 0.5. Experiments were performed to determine the critical temperature difference data for no vibration case and with small vibrations applied. The experimental results have shown that the effect of small vibrations on the onset of oscillatory flow is small since the critical temperature difference data for different aspect ratios were not affected by the vibrations. To clarify the surface oscillation phenomena induced by external vibrations, a 3-D numerical simulation model was also developed using a level set algorithm to predict the surface oscillations of isothermal silicone oil bridges. By subjecting the liquid bridge to small vibrations, the surface oscillation characteristics were predicted numerically, and the numerical results compared well with the predictions of an analytical model proposed previously. Furthermore, the effect of small vibrations on the surface vibration amplitude of the liquid bridge is also discussed.     

Preliminary calibration results of VEGA 1 and 2 SIGMA-3 gas chromatograph

SIGMA - 3 gas chromatograph on board VEGA 1 and 2 landing probes has been operated successfully in the 60 - 50 km altitude range, providing several in - situ chemical analysis of the gas and the aerosols of Venus cloud layers. Post flight calibration required to derive atmospheric abundancies from gas chromatograms were carried out using the SIGMA - 3 spare model. A Venus atmospheric aerosol simulation chamber was used in which sulfuric acid droplets were generated. Preliminary results of these calibration experiments indicate that the concentration of sulfuric acid in the upper part of the clouds ( 60 to 55 km) is about 1 mg/m³ and suggest that an additional constituant must be present in noticeable amount in the aerosols. From these experiments the mixing ratio upper limits of SO₂ is 100 ppmV and of H₂S and COS is few 10 ppmV.     

固体火箭发动机药柱三维温度场应力场有限元分析

采用有限元法计算固体火箭发动机药柱在固化冷却时的三维瞬态温度场。基于粘弹性积分型本构关系，计算热应力场。计算程序可用于工程实际。     

Determination of aerodynamic forces on satellites by theory and wind tunnel experiments

Theoretical and experimental aspects of satellite aerodynamics in free molecular flow have been studied. A FORTRAN-program package has been developed to calculate free molecular aerodynamic force and moment coefficients of general and special convex shapes, using an approximation of the surfaces by plane triangular elements.As a special case for concave bodies, the drag of a satellite of TD1A-similar shape has been investigated by an approximate theory and by wind tunnel experiments. Comparisons are made between experimental results, the approximate theory and exact theory.     

The Extreme Ultraviolet Imager Investigation for the IMAGE Mission

The Extreme Ultraviolet Imager (EUV) of the IMAGE Mission will study the distribution of He⁺ in Earth's plasmasphere by detecting its resonantly-scattered emission at 30.4 nm. It will record the structure and dynamics of the cold plasma in Earth's plasmasphere on a global scale. The 30.4-nm feature is relatively easy to measure because it is the brightest ion emission from the plasmasphere, it is spectrally isolated, and the background at that wavelength is negligible. Measurements are easy to interpret because the plasmaspheric He⁺ emission is optically thin, so its brightness is directly proportional to the He⁺ column abundance. Effective imaging of the plasmaspheric He⁺ requires global `snapshots in which the high apogee and the wide field of view of EUV provide in a single exposure a map of the entire plasmasphere. EUV consists of three identical sensor heads, each having a field of view 30° in diameter. These sensors are tilted relative to one another to cover a fan-shaped field of 84°×30°, which is swept across the plasmasphere by the spin of the satellite. EUVs spatial resolution is 0.6° or 0.1 R _E in the equatorial plane seen from apogee. The sensitivity is 1.9 count s^–1 Rayleigh^–1, sufficient to map the position of the plasmapause with a time resolution of 10 min.     

Molecular alterations in tumorigenic human bronchial and breast epithelial cells induced by high LET radiation.

Carcinogenesis is a multi-stage process with sequence of genetic events governing the phenotypic expression of a series of transformation steps leading to the development of metastatic cancer. In the present study, immortalized human bronchial (BEP2D) and breast (MCF-10F) cells were irradiated with graded doses of either 150 keV/micrometer alpha particles or 1 GeV/nucleon 56Fe ions. Transformed cells developed through a series of successive steps before becoming tumorigenic in nude mice. Cell fusion studies indicated that radiation-induced tumorigenic phenotype in BEP2D cells could be completely suppressed by fusion with non-tumorigenic BEP2D cells. The differential expressions of known genes between tumorigenic bronchial and breast cells induced by alpha particles and their respective control cultures were compared using cDNA expression array. Among the 11 genes identified to be differentially expressed in BEP2D cells, three (DCC, DNA-PK and p21(CIP1)) were shown to be consistently down-regulated by 2 to 4 fold in all the 5 tumor cell lines examined. In contrast, their expressions in the fusion cell lines were comparable to control BEP2D cells. Similarly, expression levels of a series of genes were found to be altered in a step-wise manner among tumorigenic MCF-10F cells. The results are highly suggestive that functional alterations of these genes may be causally related to the carcinogenic process.