Steady-state analysis and design of a switched-capacitor DC-DCconverter

A representative switched-capacitor DC-DC converter topology is presented, circuit operation is explained, and control strategies are identified. State-space averaging is used to analyze steady-state performance and to develop control criteria and design equations. The analytical results are verified by SPICE simulation     

Steady-state analysis of the constant-frequency clamped seriesresonant converter

A constant-frequency diode-clamped series resonant converter (CFCSRC) is proposed as a solution to problems associated with frequency-controlled resonant converters. This converter has two resonant frequencies, and control is achieved by varying the relative time spent at each switching frequency. Two zero-current-switching (ZCS) modes are examined and plotted in the output plane. An equation is given for the boundary between the two ZCS modes, as well as an expression for the boundary between ZCS and non-ZCS operation; both are plotted in the output plane. The output equation for the main mode is shown to be hyperbolic. Converter peak voltages limited to the input voltages, and peak currents are less than those of the frequency-controlled clamped series resonant converter over a large operating range. Data from a prototype converter are compared with theoretical data and are shown to be in good agreement with the theoretical model     

A recursive multiple model approach to noise identification

Correct knowledge of noise statistics is essential for an estimator or controller to have reliable performance. In practice, however, the noise statistics are unknown or not known perfectly and thus need to be identified. Previous work on noise identification is limited to stationary noise and noise with slowly varying statistics only. An approach is presented here that is valid for nonstationary noise with rapidly or slowly varying statistics as well as stationary noise. This approach is based on the estimation with multiple hybrid system models. As one of the most cost-effective estimation schemes for hybrid system, the interacting multiple model (IMM) algorithm is used in this approach. The IMM algorithm has two desirable properties: it is recursive and has fixed computational requirements per cycle. The proposed approach is evaluated via a number of representative examples by both Monte Carlo simulations and a nonsimulation technique of performance prediction developed by the authors recently. The application of the proposed approach to failure detection is also illustrated     

Data fusion of decentralized local tracker outputs

An approach for fusing offboard track-level data at a central fusion node is presented. The case where the offboard tracker continues to update its local track estimate with measurement and system dynamics models that are not necessarily linear is considered. An algorithm is developed to perform this fusion at a central node without having access to the offboard measurements, their noise statistics, or the location of the local estimator. The algorithm is based on an extension of results that were originally established for linear offboard trackers. A second goal of this work is to develop an inequality constraint for selecting the proper sampling interval for the incoming state estimates to the fusion node. This interval is selected to allow use of conventional Kalman filter algorithms at the fusion node without suffering error performance degradation due to processing a correlated sequence of track state estimates     

The Effect of a Pulsed Interference Signal on an Adaptive Array

The performance of a least mean square (LMS) adaptive array in the presence of a pulsed interference signal is examined. It is shown that a pulsed interference signal has two effects. First, it causes the array to modulate the desired signal envelope (but not its phase). Second, it causes the array output signal-to-interferenceplus-noise ratio (SINR) to vary with time. The desired signal modulation is evaluated as a function of signal arrival angles, powers and interference pulse-repetition frequency (PRF) and pulsewidth. It is shown that the signal modulation is small except when the interference arrives close to the desired signal. To evaluate the effect of the time-varying SINR, it is assumed that the array is used in a differential phase-shift keyed (DPSK) communication system. It is shown that the SINR variation causes a noticeable but not disastrous increase in the bit error probability.     

Instrument Failure Detection in Partially Observable Systems

Instrument failure detection using the dedicated observer scheme (DOS) depends on partial state observability through each instrument which is monitored. For instrument fault detection by the DOS technique, a quantitative measure of partial state observability is established for each instrument and used to determine a necessary condition on the output structure of the system. This measure, called the internal redundancy of the instrument, indicates the complexity of the logic required for failure detection, and it also indicates where some hardware redundancy can be introduced into the system to improve the fault detection capability of the DOS. The principles developed are applied to a simulation of the pitch axis autopilot of the A7 jet aircraft.     

The plasma mantle: Composition and other characteristics observed by means of the PROGNOZ-7 satellite

A brief summary of the main results of magnetospheric ion composition measurements in general is first presented. PROGNOZ-7 measurements in the nightside plasma mantle are then described and analyzed. Some of the results are the following: In the nightside mantle not too far from midnight the properties of the mantle are sometimes consistent with the open magnetosphere model. However during most magnetic storm situations O⁺ ions appear in the mantle in large proportions and with high energies. The acceleration process affecting the ions has been found in several cases to give equal amounts of energy to all ions independent of mass. Along the flanks of the magnetosphere the flow of the plasma is often low or absent. The O⁺ content is high (up to 20%) and the energy spectrum of both ions and electrons may be very hot, even up to the level of the ring current plasma in the keV range.The O⁺ content in the plasma mantle is positively correlated with the magnetospheric activity level. The mantle, however, does not appear to be the dominating source for the storm time ring current. Direct acceleration of ionospheric ions onto the closed field lines of the plasma sheet and ring current is most likely the main source. The magnetopause on the nightside and along the flanks of the magnetosphere appears to be a fairly solid boundary for mantle ions of ionospheric origin. This is especially evident during periods with high geomagnetic activity, when the mantle is associated with fairly strong fluxes of O⁺ ions.An interesting observation in most of the mantle passages during geomagnetically disturbed periods is the occurrence of intense, magnetosheath like, regions deep inside the mantle. In some cases these regions with strong antisunward flow and with predominant magnetosheath ion composition was observed in the innermost part of the mantle, i.e. marking a boundary region between the lobe and the mantle. These magnetosheath penetration events are usually associated with strong fluxes of accelerated ionospheric ions in nearby parts of the mantle. Evanescent penetration regions with much reduced flow properties are frequently observed in the flank mantle.     

GTD Terrain Reflection Model Applied to ILS Glide Scope

The capability of calculating the reflection of electromagnetic signals from uneven terrain has many applications. One of these is the determination of instrument landing system (ILS) glide slope performance. For this application the wavelength is approximately 1 m, incidence angles are usually near grazing, and the fields are horizontally polarized, so that gross irregularities such as dropoffs and hills are more important than surface roughness. Past approaches used to calculate the ground reflections for this application have been three-dimensional physical optics models which were very cumbersome and time consuming and which neglected important diffraction and shadowing phenomenon; a two-dimensional physical optics model which was faster than the three-dimensional models but ignored many shadowing and transverse terrain variation effects; and a half-plane diffraction model which is applicable only to a specified type of terrain geometry. In this paper a terrain reflection model based on the geometrical theory of diffraction (GTD) is described which can accommodate any piecewise linear terrain profile, requires less computer time than the physical optics models, is capable of including transverse terrain effects, and determines the reflected fields with all important diffraction and blockage effects included.     

Dynamic considerations for control of closed life support systems

Reliability of closed life support systems will depend on their ability to continue supplying the crew's needs in the face of perturbations and equipment failures. These dynamic considerations interact with the basic static (equilibrium) design through the sizing of storages, the specification of excess capacities in processors, and the choice of system initial state (total mass in the system). This paper uses a very simple system flow model to examine the possibilities for system failures even when there is sufficient storage to buffer the immediate effects of the perturbation. Two control schemes are shown which have different dynamic consequences in response to component failures.     

Advanced regenerative environmental control and life support systems: Air and water regeneration

Extended manned space missions will require regenerative life support techniques. Past U.S. manned missions used nonregenerative expendables, except for a molecular sieve-based carbon dioxide removal system aboard Skylab. The resupply penalties associated with expendables becomes prohibitive as crew size and mission duration increase. The U.S. Space Station, scheduled to be operational in the 1990's, is based on a crew of four to sixteen and a resupply period of 90 days or greater. It will be the first major spacecraft to employ regenerable techniques for life support. The paper uses the requirements for the Space Station to address these techniques.