A Closely Regulated TWT Converter

The design concept for the traveling wave tube amplifier converter for possible use in the Thermoelectric Outer Planet Spacecraft (TOPS) is presented. An unusual combination of semiconductors and magnetics were utilized to achieve very stable voltage regulation on a number of separate outputs to satisfy the requirements of a high-power traveling wave tube (TWT), and at the same time operate at an efficiency of better than 90 percent from a 30-volt source. The circuitry consists of an output filter, an auxiliary Jensen oscillator driving a high-reactance transformer to provide current limiting to the heater, a variable time delay, a main Jensen oscillator driving the power transformer with a maximum step-up ratio of 120 to 1, and series transistorized post regulators to provide precise voltage adjustment and low output impedance. This paper discusses the design of the high-reactance transformer and the high step-up ratio transformer, as well as the high-voltage series regulators that are limited in range and operate at the top of the unregulated output voltage. Test data is presented, and details of current transients caused by charging the filter circuits, input current ripple, and output voltage ripples are considered. The circuit provides better than 0.5 percent regulation against load change, input voltage change, and over-operating temperature range of from -20 to + 80°C, with output ripple voltage of less than 2 volts peak-to-peak on top of the 3600-Vdc output. The measured efficiency was typically 87 percent. and recommendations are included to improve this to in excess of 90 percent.     

An interacting multiple model approach for target tracking withglint noise

The application of the interacting multiple model (IMM) estimation approach to the problem of target tracking when the measurements are perturbed by glint noise is considered. The IMM is a very effective approach when the system has discrete uncertainties in the dynamic or measurement model as well as continuous uncertainties. It is shown that this method performs better than the “score function” method. It is also shown that the IMM method performs robustly when the exact prior information of the glint noise is not available     

An exact expression for resolution cell area in special case ofbistatic radar systems

An exact expression for the bistatic resolution-cell area (A _B) is developed for the special case in which either the transmit or receive antenna has a broad azimuth beamwidth or is omnidirectional. Quantitative examples are presented to illustrate the variation of A_B with location. A comparison is made with the performance of a commonly used approximation formula     

Observations of interplanetary shocks: Recent progress

Interplanetary shock observations since the prior Solar Terrestrial Physics Symposium in 1978 are reviewed. Since the interval coincides with the recent solar maximum, emphasis is placed on shocks associated with transient solar phenomena, including coronal transients and eruptive prominences as well as flares. A good correlation between shocks and Storm Sudden Commencements has persisted into the recent maximum. Shocks have been identified that are associated with disappearing filaments and coronal transients rather than with flares. Significant progress has been made in the indirect observation of shocks near the Sun as a result of radio wave measurements in interplanetary space and measurement of the scintillation and spectral broadening of spacecraft radio transmissions. Preliminary results regarding the thickness of interplanetary shocks have appeared. Several quasi-parallel shocks propagating more nearly along, rather than across, the magnetic field have been identified. The plasma drivers accompanying interplanetary shocks have received increased attention and distinctive features have been found in electron, ion and magnetic field data.     

The plasma mantle: Composition and other characteristics observed by means of the PROGNOZ-7 satellite

A brief summary of the main results of magnetospheric ion composition measurements in general is first presented. PROGNOZ-7 measurements in the nightside plasma mantle are then described and analyzed. Some of the results are the following: In the nightside mantle not too far from midnight the properties of the mantle are sometimes consistent with the open magnetosphere model. However during most magnetic storm situations O⁺ ions appear in the mantle in large proportions and with high energies. The acceleration process affecting the ions has been found in several cases to give equal amounts of energy to all ions independent of mass. Along the flanks of the magnetosphere the flow of the plasma is often low or absent. The O⁺ content is high (up to 20%) and the energy spectrum of both ions and electrons may be very hot, even up to the level of the ring current plasma in the keV range.The O⁺ content in the plasma mantle is positively correlated with the magnetospheric activity level. The mantle, however, does not appear to be the dominating source for the storm time ring current. Direct acceleration of ionospheric ions onto the closed field lines of the plasma sheet and ring current is most likely the main source. The magnetopause on the nightside and along the flanks of the magnetosphere appears to be a fairly solid boundary for mantle ions of ionospheric origin. This is especially evident during periods with high geomagnetic activity, when the mantle is associated with fairly strong fluxes of O⁺ ions.An interesting observation in most of the mantle passages during geomagnetically disturbed periods is the occurrence of intense, magnetosheath like, regions deep inside the mantle. In some cases these regions with strong antisunward flow and with predominant magnetosheath ion composition was observed in the innermost part of the mantle, i.e. marking a boundary region between the lobe and the mantle. These magnetosheath penetration events are usually associated with strong fluxes of accelerated ionospheric ions in nearby parts of the mantle. Evanescent penetration regions with much reduced flow properties are frequently observed in the flank mantle.     

Automated Tracking for Aircraft Surveillance Radar Systems

An improved moving target detector (MTD) (a digital signal processor) has been designed, constructed, and tested which successfully rejects all forms of radar clutter while providing reliable detection of all aircraft within the coverage of the radar. The MTD is being tested on both terminal and enroute surveillance radars for the FAA. This processor has been integrated with automatic tracking algorithms to give complete rejection of ground clutter, heavy precipitation, and angels (birds).     

Magnetic Position and Orientation Tracking System

Three-axis generation and sensing of quasi-static magneticdipole fields provide information sufficient to determine both the position and orientation of the sensor relative to the source. Linear rotation transformations based upon the previous measurements are applied to both the source excitation and sensor output vectors, yielding quantities that are linearly propotional to small changes in the position and orientation. Changes are separated using linear combinations of sensor output vectors, transformed to the desired coordinate frame, and used to update the previous measurements. Practical considerations for a head-tracking application are discussed.     

An Approach to Built-In Testing

The archiitecture and justification for an approach to built-in testing (BIT) in electronic circuits and systems is presented. The proposed system is capable of on-line fault detection and prediction up to the shop replaceable assembly (SRA) level and is designed to interface with external automatic test equipment (ATE) for off-line fault diagnosis within the SRA. The constituent parts of the BIT system have been extensively simulated and the approach appears to be suitable for hardware implementation both with respect to computational and economic considerations.