Ultraviolet spectrometer experiment for the Voyager mission

The Voyager Ultraviolet Spectrometer (UVS) is an objective grating spectrometer covering the wavelength range of 500–1700 Å with 10 Å resolution. Its primary goal is the determination of the composition and structure of the atmospheres of Jupiter, Saturn, Uranus and several of their satellites. The capability for two very different observational modes have been combined in a single instrument. Observations in the airglow mode measure radiation from the atmosphere due to resonant scattering of the solar flux or energetic particle bombardment, and the occultation mode provides measurements of the atmospheric extinction of solar or stellar radiation as the spacecraft enters the shadow zone behind the target. In addition to the primary goal of the solar system atmospheric measurements, the UVS is expected to make valuable contributions to stellar astronomy at wavelengths below 1000 Å.     

Third-Order Loop Filter Design for Acceleration-Rate Tracking

A perfect third-order loop filter design that can be implemented as a digital filter is obtained which minimizes the noiseless steady-state acceleration rate (jerk) error for a fixed loop noise bandwidth. Simulations were performed to obtain transient responses of the third-order loop plus a sample fourth-order loop under a jerk input. The results enable one to obtain a loop design that minimizes the loop noise bandwidth required for a given steady-state jerk error and thus obtain better noise jitter performance.     

Design of the HEAO Main Bus Shunt Regulator

The High Energy Astronomy Observatory (HEAO) main bus regulator contains a redundant error amplifier (REA) and a 12-section sequenced shunt transconductance amplifier (STA) in which not more than three and not less than one shunt section are in an active control mode regardless of a failure in any one of the twelve sections. The part of the work concerned with the shaping of the frequency response of the REA and STA minor feedback loops and of the teolator major feedback loop is described. Emphasis is on the application of a general design technique embodying a "design-analyze-measure iteration loop," in which a first-cut design and analysis is corrected ard improved after experimental observation of discrepancies and deficiencies. In particular, an incipient high-frequency oscillation was thereby reliably eliminated. It is demonstrated that analysis techniques involving a minimum of algebra can provide full quantitative information on an efficient and reliable system design.     

Defending a Moving Target Against Missile or Torpedo Attack

Problems involving kinematics of a counterweapon intercepting an attacking missile are well known. However, when the attacker's target, the counterweapon's launch platform, is moving, the problem generally becomes amenable only to trajectory simulation. Such may be the case in defense against torpedo attack against a ship and other situations involving the use of antimissile missiles. This paper derives the kinematic relations among the three bodies (missile, target, and counterweapon) in closed form under the asymptotic approximation of constant-bearing trajectories (collision courses). It is shown that the defending target, even if moving, can still determine the optimum course for its counterweapon when range and speed of the attacking vehicle are unknown. A simple relation is derived for the ratio between the attacker-target range (and time to impact) at counterweapon launch and the range at interception of the attacker by the counterweapon. Normalized curves are presented for some representative cases of defense by a counterweapon of known speed against a torpedo or missile attack on a moving target. The equations are shown to reduce to the familiar form for a stationary target.     

ATC Beacon Interference Characteristics in the New York Area

An experimental program is described that had the objective of measuring the effects of the time-dependent structure of downlink (air craft to ground) interference generated by the Air Traffic Control Radar Beacon System (ATCRBS) in an active air traffic terminal area that are relevant to system and ground controller response time. The results of this program indicate a number of interesting details concerning the correlation of the level of the downlink interference with changes in the arrival and departure rates of aircraft at the local terminal sites.     

Hr 7308: A unique Cepheid

Numerical models of Cepheids have been computed with a range of effective temperatures and compositions. The amplitudes increase if the helium abundance increases or if the effective temperature decreases. The latter effect is contrary to observational data. The models also exhibit velocity amplitudes which are much lower than those observed.     

A methodology for addressing support equipment obsolescence

The rapid growth of technology over the last twenty years is providing vastly improved capabilities for both avionics and avionics test systems. Unfortunately, an environment of rapid technological growth breeds a corresponding environment of rapid technological obsolescence. Test systems developed fifteen years ago are becoming increasingly more difficult to support due to obsolescence issues and, additionally, such a test system does not reflect the current state-of-the-art for automatic test equipment. The ability of a test system to evolve is essential to providing cost-effective support systems for electronic systems. The F-15 Tactical Electronic Warfare System (TEWS) Intermediate Support System (TISS) was developed under the Modular Automatic Test Equipment (MATE) guidelines to support the suite of F-15 electronic warfare LRUs. MATE imposed hardware architecture constraints, which were factors that contributed to its abandonment. However, the modular aspect of MATE has provided a system that can easily evolve with technological advancements. Modularity is the cornerstone of modern software systems and this is the aspect that has been exploited in the evolution of the TISS     

A survey of the outer planets Jupiter,Saturn, Uranus,Neptune, Pluto,and their satellites

A survey of current knowledge about Jupiter, Saturn, Uranus, Neptune, Pluto, and their satellites is presented. The best available numerical values are given for physical parameters, including orbital and body properties, atmospheric composition and structure, and photometric parameters. The more acceptable current theories of these bodies are outlined with thorough referencing offering access to the details. The survey attempts to cover the literature through May 1, 1972. Prepared Under Contract No. NAS7-100 National Aeronautics and Space Administration.     

Identifications of some highly-ionized iron and nickel lines in the 200–400 Å region of the solar spectrum

A number of previously unclassified multiplets of Fexiv, xiii, xii, and xi produced by transitions of the type 3s ²3p ⁿ -3s3p ⁿ⁺¹ are identified in the XUV spectrum of the Sun. The iron lines account for most of the previously unidentified strong lines between 330 and 370 Å. Solar observations of especial value for the investigation of the 300–400 Å region were the slitless spectroheliograms of September 22, 1968 (Purcell and Tousey, 1969) and November 4, 1969 (Tousey, 1971) — on which the image of a flare was recorded. Other solar identifications in the same spectral region include the resonance lines of Nixvii and Nixviii, and one 3p-3d multiplet of Fexiii. The solar blend at 417 Å involving the Fexv inter-combination line and Sxiv is resolved.