Operating characteristics of a high radius pre-swirl cooling system

An experimental investigation into pre-swirl effectiveness and receiver hole discharge coefficient characteristics for a high radius injection pre-swirl cooling systems was carried out on a physically representative experimental rig with a 450 mm diameter rotor.The receiver holes and pre-swirl nozzle were located at a radius of 181 mm and 180 mm respectively.The experimental work was mainly conducted at 5 000～12 000 r/min,4 bar absolute pressure and 1.132 kg/s air supply.The maximum air supply temperature was 190 ℃.Pressure and temperature distributions in the pre-swirl system were examined with an emphasis on the velocity effectiveness of the pre-swirl system as a whole and on the discharge coefficients of the rotating 'receiver holes' in the rotor.The results showed that the velocity effectiveness increased with increasing swirl ratio resulting in reduced blade cooling flow temperature.Different seal flow configurations caused very different effectiveness at different speeds,but outflow through the inner and outer seals always gave the highest effectiveness compared other configurations.Increasing the seal flow rate reduced the effectiveness.For the coefficient of discharge,except for the low speed range,it increased with increase in swirl ratio for most speeds.      

基于伴随非等温射流理论的缝槽气膜冷却模型

在伴随非等温射流基础上发展了一种适用于缝槽气膜冷却绝热温比预估的数学模型.通过合理假设推导出二维壁面射流混合层核心温度分布规律,将其作为气膜绝热壁温,并考虑缝槽几何特征参数和气膜吹风比对冷却效率的影响,得到绝热温比计算公式.用试验数据对该预估模型进行拟合分析,得到了与试验数据拟合精度在±8%以内的半经验预估模型,证明该模型的可行性和应用潜力,并需要更多的试验数据对其进行验证和改进.      

复材机身制造的自动化流水线工艺过程

AeroSuite给出了一个飞行器制造过程有效管理整个产品制造流程的解决方案。它包括FiberSIM复材工艺软件、SyncroFIT机身设计制造装配软件、对于首件鉴定过程的流程化的质量规划模块(QPE)。     

PARAMETER ANALYSIS ON CIRCULATION CONTROLLED CIRCULAR CYLINDER FOR NOTARTM TAIL BOOM

Lift on circulation control （CC） circular cylinder is calculated via numerical simulations based on 2D real- izable k-e epsilon viscous model and compared with experimental data. The simulation result shows an acceptable agreement with tested data. With the proved grid and simulation method, series of simulations are conducted to study the effect of parameters on lift. Single slotted tail booms under different clown wash velocities are optimized with the principle of generating maximum total moment around the main rotor shaft with same total power con- sumption. The results show that larger jet flow velocity, or smaller blow angle, or larger diameter of the cross section can help generating larger lift while enhancing the attachment of both the jet flow and down wash flow. Multiple slotted tail boom is better because it increases lift with same total slot width, and can increase lift by in- creasing total slot width without causing separation, also it helps generating high steady lift at a big rank of slot at- tack angles. To mount a guide vane （GV） at the exit of the slot, or shape the upper slot wall like a smooth-GV, or design the slot with an edge fillet is not recommended because it reduces the velocity of both the jet flow and the upstream of the attached downwash flow. Compared with other shapes of the slots, arcs-profiled slot performs better because of larger jet flow velocity and smaller blow angle. In order to generate the largest moment with same total power consumed by the entire NOTARTM system, total width of the slots and slot attack angle should be optimized according to velocity of down wash flow.     

Occurrence of equatorial plasma bubbles over Kolhapur

This paper reports the nightglow observations of OI 630.0 nm emissions, made by using all sky imager operating at low latitude station Kolhapur (16.8°N, 74.2°E and dip lat. 10.6°N) during high sunspot number years of 24th solar cycle. The images are analyzed to study the nocturnal, seasonal and solar activity dependence occurrence of plasma bubbles. We observed EPBs in images regularly during a limited period 19:30 to 02:30 LT and reach maximum probability of occurrence at 22:30 LT. The observation pattern of EPBs shows nearly no occurrence during the month of May and it maximizes during the period October–April. The equinox and solstice seasonal variations in the occurrence of plasma bubbles show nearly equal and large differences, respectively, between years of 2010–11 and 2011–12.     

A new global version of M(3000)F2 prediction model based on artificial neural networks

A new version of global empirical model for the ionospheric propagation factor, M(3000)F2 prediction is presented. Artificial neural network (ANN) technique was employed by considering the relevant geophysical input parameters which are known to influence the M(3000)F2 parameter. This new version is an update to the previous neural network based M(3000)F2 global model developed by Oyeyemi et al. (2007), and aims to address the inadequacy of the International Reference Ionosphere (IRI) M(3000)F2 model (the International Radio Consultative Committee (CCIR) M(3000)F2 model). The M(3000)F2 has been found to be relatively inaccurate in representing the diurnal structure of the low latitude region and the equatorial ionosphere. In particular, the existing hmF2 IRI model is unable to reproduce the sharp post-sunset drop in M(3000)F2 values, which correspond to a sharp post-sunset peak in the peak height of the F2 layer, hmF2. Data from 80 ionospheric stations globally, including a good number of stations in the low latitude region were considered for this work. M(3000)F2 hourly values from 1987 to 2008, spanning all periods of low and high solar activity were used for model development and verification process. The ability of the new model to predict the M(3000)F2 parameter especially in the low latitude and equatorial regions, which is known to be problematic for the existing IRI model is demonstrated.     

Method for the prediction of the effective dose equivalent to the crew of the International Space Station

This paper describes a methodology for assessing the pre-mission exposure of space crew aboard the International Space Station (ISS) in terms of an effective dose equivalent. In this approach, the PHITS Monte Carlo code was used to assess the particle transport of galactic cosmic radiation (GCR) and trapped radiation for solar maximum and minimum conditions through an aluminum shield thickness. From these predicted spectra, and using fluence-to-dose conversion factors, a scaling ratio of the effective dose equivalent rate to the ICRU ambient dose equivalent rate at a 10 mm depth was determined. Only contributions from secondary neutrons, protons, and alpha particles were considered in this analysis.     

Estimation of optical maturity parameter for lunar soil characterization using Moon Mineralogy Mapper (M3)

Prolonged exposure of the microscopic outer layer of the lunar surface to the space environment leads to the maturation of the surface. Maturation can be quantified and it may be expressed in terms of optical maturity (OMAT). Optical maturity estimations are very much helpful in the identification and mapping of the major minerals present on the lunar regolith. Estimation of the maturation and mineral mapping using remote sensing techniques are achieved, by coupling spectral reflectance of the lunar surface with an optimized origin. The present work estimates the optical maturity and Ferrous oxide content of the Goldschmidt and Schrodinger craters, through the recalibration of the classical method of Lucey et al. (2000a) with an origin of (0.08, 1.18) and Moon Mineralogy Mapper (M3) data. The overall recalibration results assure that the craters are highly matured.     

Signatures of strong geomagnetic storms in the equatorial latitude

Ionosonde data from two equatorial stations in the African sector have been used to study the signatures of four strong geomagnetic storms on the height – electron density profiles of the equatorial ionosphere with the objective of investigating the effects and extent of the effects on the three layers of the equatorial ionosphere. The results showed that strong geomagnetic storms produced effects of varying degrees on the three layers of the ionosphere. Effect of strong geomagnetic storms on the lower layers of the equatorial ionosphere can be significant when compared with effect at the F2-layer. Fluctuations in the height of ionization within the E-layer were as much as 0% to +20.7% compared to −12.5% to +8.3% for the F2-layer. The 2007 version of the International Reference Ionosphere, IRI-07 storm-time model reproduced responses at the E-layer but overestimated the observed storm profiles for the F1- and F2-layers.     

Cosmic Ray Energetics And Mass for the International Space Station (ISS-CREAM)

The Cosmic Ray Energetics And Mass (CREAM) instrument is configured with a suite of particle detectors to measure TeV cosmic-ray elemental spectra from protons to iron nuclei over a wide energy range. The goal is to extend direct measurements of cosmic-ray composition to the highest energies practical, and thereby have enough overlap with ground based indirect measurements to answer questions on cosmic-ray origin, acceleration and propagation. The balloon-borne CREAM was flown successfully for about 161 days in six flights over Antarctica to measure elemental spectra of Z = 1–26 nuclei over the energy range 10¹⁰ to >10¹⁴ eV. Transforming the balloon instrument into ISS-CREAM involves identification and replacement of components that would be at risk in the International Space Station (ISS) environment, in addition to assessing safety and mission assurance concerns. The transformation process includes rigorous testing of components to reduce risks and increase survivability on the launch vehicle and operations on the ISS without negatively impacting the heritage of the successful CREAM design. The project status, including results from the ongoing analysis of existing data and, particularly, plans to increase the exposure factor by another order of magnitude utilizing the International Space Station are presented.