MEMS Electronically Steerable Antennas for Fire Control Radars

Large apertures are of great benefit to applications that are prime powered limited as is found on aerostat and other airborne platforms. Electronically scanned array antennas are often proposed for these applications. However, increasing the aperture area with conventional array technology is met with prohibitive cost, weight, and prime power increases because of the dense spacing of phase shifters and/or active T/R modules. This discusses the recent development of RF MEMS (Microelectromechanical System) switch technology and the use of these switches in a Radanttrade lens configuration for arrays of approximately 10 m² at X-band. A proof-of-concept 0.4 m² MEMS Electronically Steerable Antenna (ESA) containing 25,000 MEMS switches has been successfully designed, fabricated, and tested. The 0.4 m² MEMS ESA was then integrated with an AN/APG-67 radar system to form the MEMS Demonstration Radar System. The MEMS Demonstration Radar System successfully detected both airborne and ground moving targets during a series of extensive radar demonstrations. This is believed to be the first large scale employment of MEMS switches in a scanning antenna and radar system. The low-cost, lightweight, and low power technology demonstrated can enable weight and power constrained platforms with electronic steering.     

Problems of application of face gasodynamic seals in aircraft engines

Problems arising in introduction of gasodynamic seals in aircraft engines are considered. The operation of a face gasodynamic seal as part of a natural gas pump is analyzed and its efficiency in the presence of oil is shown.     

Two years of INTEGRAL observation of the BHC IGR J17464-3213

On March 2003, IBIS, the γ-ray imager on board the INTEGRAL satellite, detected an outburst from a new source, IGR J17464-3213, that turned out to be an HEAO-1 transient, namely H1743-322. The spectral and temporal evolutions of the source were observed by INTEGRAL in different periods. Also RXTE observed the source for the first time on 2003 March 29 during a PCA Galactic bulge scan. The source flux decayed below the RXTE PCA sensitivity limit in November 2003, then in April 2004 it was again detected by INTEGRAL. On July 3, 2004 the source was again detected by RXTE/PCA at a 2–10 keV intensity of 16 mCrab and on July 7, reached 69 mCrab. Recently, a new outburst was observed on August 2005. We briefly summarise here the behaviour of the source observed by INTEGRAL from March 2003 to August 2005. The new outbursts of the source and the analysis of all the data collected (now public) give a global view of the spectral and time behaviour of this X-ray transient.     

Unmanned aircraft navigation for shipboard landing using infrared vision

This paper addresses the problem of determining the relative position and orientation of an unmanned air vehicle with respect to a ship using three visible points of known separation. The, images of the points are obtained from an onboard infrared camera. The paper develops a numerical solution to this problem. Both simulation and flight test results are presented.     

Features of active sidestick controllers

This paper discusses the advantages of incorporating active sidesticks into a modern aircraft cockpit. Active sidestick controllers for manual pilot inputs in pitch and roll are examined for commercial transport aircraft. Options and requirements for sidesticks are reviewed. The recommendation of an active sidestick controller is developed providing both cross-cockpit coupling and autopilot backdrive capability. These characteristics provide pilot cues identical to traditional cable-linked column/yoke configurations     

Methodologies in user interface design

Software applications that require a high learning curve, a mountain of documentation, and weeks of training should be things of the past. Today's applications need to be simple to learn and to use. The human/computer interface should be intuitive and consistent. Context sensitive help should be available to keep the user on track. This paper provides some guidelines for taking commercial world concepts and applying them to the Automatic Test Equipment world. Examples included are from the Integrated Maintenance Information System (IMIS)     

TMA from bearings and multipath time delays

A novel approach for target motion analysis (TMA), which uses conventional passive bearing together with multipath time-delay measurements is examined. This so-called "Multipath TMA" offers two tactical advantages over the classical bearings-only TMA: no requirement for any ownship maneuver, and a good performance in terms of estimation error achieved in a shorter time. Both known and unknown multipath cases are addressed. Finally, Monte-Carlo simulations and at-sea trials demonstrate the practical efficiency of such a multipath TMA.     

Millimeter wave radar with clutter measurements

A portable millimeter wave test radar system, also suitable for battery operation, gives interesting possibilities for clutter recordings at hard-to-reach sites. The designed system covers all common radar frequencies from the Ka- to V-bands and enables spatial detection of targets or clutter elements within an adjustable time gate, whereby spatial clutter profiles of rain can be analyzed. The construction allows full operation with non-scanning antennas as well. This is advantageous when measuring temporal RCS variations of selected targets or surface clutter from snow dunes.     

Time-dependent thermal X-ray afterglows from GRBS

Time-dependent thermal X-ray spectra are calculated from physically plausible conditions around GRB. It is shown that account for time-dependent ionization processes strongly affects the observed spectra of hot rarefied plasma. These calculations may provide an alternative explanation to the observed X-ray lines of early GRBs afterglows (such as GRB 011211). Our technique will allow one to obtain independent constraints on the GRB collimation angle and on the clumpiness of circumstellar matter.