微肋薄膜减阻的实验研究

作者根据湍流附面层结构新的解释及非光滑特殊造型表面可以减小流体阻力的事实,作者研制了微肋条减阻薄膜,贴在赛船上参加比赛,获得好成绩[1、2] 。作者在风洞中做了贴及不贴微肋薄膜平板试验对比。结果贴微肋薄膜可减阻约 7%。      

三路功率分流恒星式减速器的动态特性

 本文用Fourier级数法求解了三路功率分流恒星式减速系统的运动微分方程，获得了系统的频域和时域响应，计算了系统的动载和载荷在各路传动上分配的动态均匀性以及太阳轮中心的浮动轨迹，包括了各级联接刚度以及各类偏心误差的影响，以定量的分析为减速器改善动态性能的优化设计提供了依据。     

Optimal speckle reduction in polarimetric SAR imagery

Speckle is a major cause of degradation in synthetic aperture radar (SAR) imagery. With the availability of fully polarimetric SAR data, it is possible to use the three complex elements (HH, HV, VV) of the polarimetric scattering matrix to reduce speckle. The optimal method for combining the elements of the scattering matrix to minimize image speckle is derived, and the solution is shown to be a polarimetric whitening filter (PWF). A simulation of spatially correlated, K-distributed, fully polarimetric clutter is then used to compare the PWF with other, suboptimal speckle-reduction methods. Target detection performance of the PWF, span, and single-channel |HH|² detectors is compared with that of the optimal polarimetric detector (OPD). A novel, constant-false-alarm-rate (CFAR) detector (the adaptive PWF) is as a simple alternative to the OPD for detecting targets in clutter. This algorithm estimates the polarization covariance of the clutter, uses the covariance to construct the minimum-speckle image, and then tests for the presence of a target. An exact theoretical analysis of the adaptive PWF is presented; the algorithm is shown to have detection performance comparable with that of the OPD     

Cascaded detector for multiple high-PRF pulse Doppler radars

A postdetection design methodology for a multiple high-pulse-repetition frequency (PRF) pulse Doppler radar has been developed. The postdetection processor consists of an M out of N detector where range and target ambiguities are resolved, followed by a square-law detector which enhances the minimum signal-to-noise (S/N) power-ratio per pulse burst performance. For given probabilities of false alarm and detection, formulas are derived from which the three thresholds associated with the cascaded detector can be found. Fundamental tradeoffs between the minimum S/N required, number of ghosts, and the number of operations (NOPs) that the cascaded detector must perform are identified. It is shown that the NOPs and the number of ghosts increase and the minimum S/N required decreases as the binary M out of N detector passes more detections to the square-law detector     

平板边界层转捩的数值模拟

对于自由湍流引起的压力梯度为零的平板边界层转捩过程的数值模拟,本文提出了一个单方程湍流模型 (VL M模型),对湍流粘性系数和湍流长度尺度都进行了修正以正确引入低雷诺数效应。数值计算表明,该模型在自由来流湍流度为 0.03～8%的大范围内能正确模拟边界层转捩全过程,包括转捩区起点位置和转捩区长度、边界层内的平均及脉动参数分布等。本文还提出了上述转捩过程的时均化五阶段模型。      

大多普勒容限巴克码脉压

 本文介绍用补偿式非相干型旁瓣抑制滤波器(SSF)实现13位巴克码脉冲压缩旁瓣抑制的理论计算及实验结果。补偿式非相干型SSF采用最小二乘近似逆滤波方法设计,若子脉冲宽度为0.7μs,峰值旁瓣电平不超过-30dB,这种SSF的多普勒容限能达到-40kHz～+40kHz。理论计算及实验结果都表明,所设计的补偿式非相干型SSF的多普勒容限比具有同样长度冲激响应序列的R-G-ISSF有显著改善。     

冷挤压机载荷与缓冲参数关系的试验研究

 <正> 机械式冷挤压机在挤压过程中的冲击振动对模具和产品质量有严重影响。在工程上采取一些措施,但关于挤压载荷与缓冲参数关系,迄今未曾见到系统的报导。本文首先对挤压机缓冲装置工作时的动力过程作了系统的分析,建立了力学数学模型,进行了系统的计算,并在航空专用冷挤压机上作了系统的试验,测试了不同挤压材料、不同缓冲参数时挤压载荷、模具和机身应力的波形与数据。从而得出缓冲参数对挤压载荷的影响规律;缓冲参数对制件质量和挤压能消耗的影响趋势;缓冲参数间的相互制约关系等。发现了冲击载荷曲线前沿斜率对金属成形机器构件应变应力动态响应值有很大影响。     

用三维欧拉方程计算机身与机翼绕流

本文用Jameson的三维欧拉方程有限体积法、四步Runge-Kutta时间推进格式,计算机身和大后掠细长机翼的三维可压缩绕流。对钝头机身,用C-O型网格;尖头机身与大后掠细长机翼用H-O型网格。本文介绍钝头旋成体、带座舱前机身和三角翼绕流的计算结果,显示流场等值M线分布,计算压强系数分布与实验比较,以及三角翼大迎角分离涡等。由于用了隐式残值光顺等加速收敛措施,有效地减少推进步数,节省机时。