Testing for Year 2000 readiness: technical and management issues

The approach of the Year 2000 (Y2K) has called into question the condition of readiness of computer systems upon which organizations depend. Will these systems operate reliably after midnight, January 1, 2000, or will problems associated with date calculations cause failures that adversely affect users? This question has caused organizations to identify their critical systems, test these systems for Y2K problems, and take corrective action where necessary to ensure Y2K readiness. This paper examines various technical and management issues that Southwest Research Institute has dealt with in solving these problems     

Power management and distribution system for a more-electricaircraft (MADMEL)

A five-phase Power Management and Distribution System for a More-Electric Aircraft (MADMEL) program was awarded by the Air Force to Northrop/Grumman Military Aircraft Division in September 1991. The objective of the program is to design, develop, and demonstrate an advanced electrical power generation and distribution system for a More-Electric Aircraft (MEA). The MEA emphasizes the use of electrical power in place of hydraulics, pneumatic, and mechanical power to optimize the performance and life cycle cost of the aircraft. This paper presents an overview of the MADMEL program and a top-level summary of the program results, development and test of major components to date. In Phase I and Phase II studies, the electrical load requirements were established and the electrical power system architecture was defined for both near-term (NT-year 1996) and far-term (FT-year 2003) MEA application. The detailed design and specification for the Electrical Power System (EPS), its interface with the Vehicle Management System, and the test set-up were developed under Phase III. Phase IV, fabrication and testing of the subsystem level hardware, has been completed. Overall system level integration and testing, Phase V, is scheduled to be completed by September 1999     

UVCS/SOHO Observations of Spectral Line Profiles in Polar Coronal Holes

Ultraviolet emission line profiles have been measured on 15-29 September 1997 for H I 1216 Å, O VI 1032, 1037 Å and Mg X 625 Å in a polar coronal hole, at heliographic heights ? (in solar radii) between 1.34 and 2.0. Observations of H I 1216 Å and the O VI doublet from January 1997 for ? = 1.5 to 3.0 are provided for comparison. Mg X 625 Å is observed to have a narrow component at ? = 1.34 which accounts for only a small fraction of the observed spectral radiance, and a broad component that exists at all observed heights. The widths of O VI broad components are only slightly larger than those for H I at ? = 1.34, but are significantly larger at ? = 1.5 and much larger for ? > 1.75. In contrast, the Mg X values are less than those of H I up to 1.75 and then increase rapidly up to at least ? = 2.0, but never reach the values of O VI.     

Soho Observations of Density Fluctuations in Coronal Holes

In recent UVCS/SOHO White Light Channel (WLC) observations we found quasi-periodic variations in the polarized brightness (pB) in the polar coronal holes at heliocentric distances of 1.9 to 2.45 solar radii. The motivation for the observation is the 2.5D MHD model of solar wind acceleration by nonlinear waves, that predicts compressive fluctuations in coronal holes. In February 1998 we performed new observations using the UVCS/WLC in the coronal hole and obtained additional data. The new data corroborate our earlier findings with higher statistical significance. The new longer observations show that the power spectrum peaks in the 10–12 minute range. These timescales agree with EIT observations of brightness fluctuations in polar plumes. We performed preliminary LASCO/C2 observations in an effort to further establish the coronal origin of the fluctuations. This revised version was published online in June 2006 with corrections to the Cover Date.     

Large-scale Coronal Heating, Clustering of Coronal Bright Points, and Concentration of Magnetic Flux

By combining quiet-region Fe XII coronal images from SOHO/EIT with magnetograms from NSO/Kitt Peak and from SOHO/MDI, we show that the population of network coronal bright points and the magnetic flux content of the network are both markedly greater under the bright half of the large-scale quiet corona than under the dim half. These results (1) support the view that the heating of the entire corona in quiet regions and coronal holes is driven by fine-scale magnetic activity (microflares, explosive events, spicules) seated low in the magnetic network, and (2) suggest that this large-scale modulation of the magnetic flux and coronal heating is a signature of giant convection cells. This revised version was published online in June 2006 with corrections to the Cover Date.     

Voyager 2 Observations of Corotating Interaction Regions (CIRs) in the Outer Heliosphere

We review observations from Voyager 2 of CIRs and merged CIRs in the outer heliosphere. The rather simple characteristics of the CIR-associated changes in plasma, magnetic field, and particles become more complex as observations are made at greater and greater distances. Pickup ions from charge exchange undoubtedly play an important role in the structure, but the full details are not yet understood. This revised version was published online in August 2006 with corrections to the Cover Date.     

Multiparametric importance sampling for simulation of radar systems

The performances of the importance sampling (IS) techniques are improved by using multiparametric distortions of the input random processes. The analysis of different constant false-alarm rate (CFAR) algorithms confirms the usefulness of this method. The potential of this new approach is fully exploited if optimization techniques are used to obtain the optimum distortions and to avoid bias in the estimates     

Advanced materials for next generation NiMH portable, HEV and EVbatteries

While Ovonic NiMH batteries are already in high volume commercial production for portable applications, advances in materials technology have enabled performance improvements in specific energy (100 Wh/kg), specific power (600-1000 W/kg), high temperature operation, charge retention, and voltage stability. Concurrent with technology advances, Ovonic NiMH batteries have established performance and commercial milestones in electric vehicles, hybrid electric vehicles, as well as scooter, motorcycle and bicycle applications. As important as these advances, significant manufacturing cost reductions have also occurred which allow continued growth of NiMH technology. In this paper, advances in performance, applications and cost reduction are discussed with particular emphasis on the improved proprietary metal hydride and nickel hydroxide materials that make such advances possible