The Electric Antennas for the STEREO/WAVES Experiment

The STEREO/WAVES experiment is designed to measure the electric component of radio emission from interplanetary radio bursts and in situ plasma waves and fluctuations in the solar wind. Interplanetary radio bursts are generated from electron beams at interplanetary shocks and solar flares and are observed from near the Sun to 1 AU, corresponding to frequencies of approximately 16 MHz to 10 kHz. In situ plasma waves occur in a range of wavelengths larger than the Debye length in the solar wind plasma λ _D ≈10 m and appear Doppler-shifted into the frequency regime down to a fraction of a Hertz. These phenomena are measured by STEREO/WAVES with a set of three orthogonal electric monopole antennas. This paper describes the electrical and mechanical design of the antenna system and discusses efforts to model the antenna pattern and response and methods for in-flight calibration.     

全电无人机主推进直驱永磁电动机热负荷研究

以全电无人飞机主推进直驱永磁电动机为研究对象,分析处于不同工况下主推进电动机热负荷特性.针对主推进电动机开启式结构特点,根据流体力学及传热学理论,建立强风冷却条件下流固耦合物理模型与数学模型,通过仿真计算不同热负荷、不同爬升角度时主推进电动机的温升,分析主推进电动机热负荷及温升随飞行工况的变化规律.对主推进电动机进行风洞与飞行试验.结果表明:热负荷为5500A2/(cm·mm2)时电动机最高温升为124K,与仿真值误差在2%以内,验证了理论分析正确性.无人机主推进电动机热负荷选取范围为3000~5500A2/(cm·mm2).      

M-ary CPSK Detection with Noisy Reference and Interferences

A general expression of the error probability on an M-ary coherent phase-shift-keyed (MCPSK) signal purturbed by a noisy reference carrier, multiple interferences, and additive Gaussian noise is presented taking into account the frequencey divider in the carrier recovery circuit. First, a new expression for the probability density function (pdf) of the phase of a composite wave of signal, multiple interferences, and additive Gaussian noise is derived. Then this result and a pdf of the phase error modified from the Tikhonov distribution are used to obtain the erro probability of an MCPSK detector. In addition, the comparison between the error probabilities with and without the frequency divider is given, and it is found that the estimation is more pessimistic when the frequency divider is included.     

俄罗斯铝锂合金的研制和应用概况

本文介绍了俄国1420,1430,1450等铝锂合金的研制过程和性能,并与西方类似合金进行了对比,同时还列举了铝锂合金在战斗机、运输机、民航机和直升机上作为结构元件和应用情况。     

Presupernova evolution of the most massive stars

Taking as example a 60M _⊙ star of solar metallicity, the state of the art of model calculations for very massive, from the main sequence to the supernova stage, is reviewed. It is argued that — due to the simple internal structure of Wolf-Rayet stars — the post main sequence evolutionary phases are currently those which are better understood. A brief discussion of the supernova outcome from very massive stars is given. Then, the more uncertain main sequence evolution is discussed. A first attempt to incorporate results about pulsational instabilities of very massive stars in stellar evolutionary calculations is performed. On its basis, a new type of evolutionary sequence for very massive stars is obtained, namely O-star → Of-star → H-rich WNL → LBV → H-poor WNL → WNE → WC → SN. This scenario is shown to correspond better to many observed properties of very massive stars than the standard one. It includes a model for the prototype LBV P Cygni.     

The Origin of Mercury’s Internal Magnetic Field

Mariner 10 measurements proved the existence of a large-scale internal magnetic field on Mercury. The observed field amplitude, however, is too weak to be compatible with typical convective planetary dynamos. The Lorentz force based on an extrapolation of Mariner 10 data to the dynamo region is 10⁻⁴ times smaller than the Coriolis force. This is at odds with the idea that planetary dynamos are thought to work in the so-called magnetostrophic regime, where Coriolis force and Lorentz force should be of comparable magnitude. Recent convective dynamo simulations reviewed here seem to resolve this caveat. We show that the available convective power indeed suffices to drive a magnetostrophic dynamo even when the heat flow though Mercury’s core–mantle boundary is subadiabatic, as suggested by thermal evolution models. Two possible causes are analyzed that could explain why the observations do not reflect a stronger internal field. First, toroidal magnetic fields can be strong but are confined to the conductive core, and second, the observations do not resolve potentially strong small-scale contributions. We review different dynamo simulations that promote either or both effects by (1) strongly driving convection, (2) assuming a particularly small inner core, or (3) assuming a very large inner core. These models still fall somewhat short of explaining the low amplitude of Mariner 10 observations, but the incorporation of an additional effect helps to reach this goal: The subadiabatic heat flow through Mercury’s core–mantle boundary may cause the outer part of the core to be stably stratified, which would largely exclude convective motions in this region. The magnetic field, which is small scale, strong, and very time dependent in the lower convective part of the core, must diffuse through the stagnant layer. Here, the electromagnetic skin effect filters out the more rapidly varying high-order contributions and mainly leaves behind the weaker and slower varying dipole and quadrupole components (Christensen in Nature 444:1056–1058, 2006). Messenger and BepiColombo data will allow us to discriminate between the various models in terms of the magnetic fields spatial structure, its degree of axisymmetry, and its secular variation.     

Integral-projection method and singularities of its application in mating shells with inconsistent parameters of approximation

We describe a numerical integral-projection method used by the authors for the approximate solution of systems of interrelated two-dimensional linear boundary-value problems in mechanics of composite shell systems. The method is based on discretization in each shell substructure of a two-dimensional problem along one of coordinates using a projection-grid variant of the Galerkin-Petrov method and its subsequent transformation to a system of ordinary differential equations; by integration and introduction of sought functions as unknown derivatives, the system is reduced to a system of integral equations being solved by the method of mechanical quadratures. The method is characterized by the fact that its application requires no additional conditions of conformity with discretization parameters of substructures being mated.     

Relationship Between Substorm Auroras and Processes in the Near-Earth Magnetotail

Although the auroral substorm has been long regarded as a manifestation of the magnetospheric substorm, a direct relation of active auroras to certain magnetospheric processes is still debatable. To investigate the relationship, we combine the data of the UV imager onboard the Polar satellite with plasma and magnetic field measurements by the Geotail spacecraft. The poleward edge of the auroral bulge, as determined from the images obtained at the LHBL passband, is found to be conjugated with the region where the oppositely directed fast plasma flows observed in the near-Earth plasma sheet during substorms are generated. We conclude that the auroras forming the bulge are due to the near-Earth reconnection process. This implies that the magnetic flux through the auroral bulge is equal to the flux dissipated in the magnetotail during the substorm. Comparison of the magnetic flux through the auroral bulge with the magnetic flux accumulated in the tail lobe during the growth phase shows that these parameters have the comparable values. This is a clear evidence of the loading–unloading scheme of substorm development. It is shown that the area of the auroral bulge developing during substorm is proportional to the total (magnetic plus plasma) pressure decrease in the magnetotail. These findings stress the importance of auroral bulge observations for monitoring of substorm intensity in terms of the magnetic flux and energy dissipation.