Thin-film Li-LiMn2O4 batteries

Thin-film rechargeable Li-LiMn₂O₄ batteries have been fabricated and characterized. Following deposition by electron beam evaporation of LiMn₂O₄, the amorphous as-deposited cathode films 1 cm² in area by 0.3to 4-μm thick were annealed at 700°C to 800°C in oxygen in order to form the crystalline spinet phase. The specific capacity of the cells between 4.5 V to 3.8 V ranged from 50 μAh/mg to 120 μAh/mg. When cycled over this range, the batteries exhibited excellent secondary performance with capacity losses as low as 0.001% per cycle. On charging to 5.3 V, a plateau with a median voltage of 5.1 V was observed. The total charge extracted between 3.8 V to 5.3 V corresponded to about 1 Li/Mn₂ O₄     

Heavy ion action on yeast cells: inhibition of ribosomal-RNA synthesis, loss of colony forming ability and induction of mutants.

The action of heavy ions (Ar to U) accelerated to specific energies up to about 10 MeV/u (u=atomic mass unit) on different functions of yeast cells was studied. Ribosomal-RNA synthesis is inhibited according to a single-hit mechanism. Inactivation cross-sections were linearly related to the ratio of the squares of the effective charge Z* and the velocity of the ions. It is concluded from the analysis that the range of the most energetic delta-electrons is larger than previously assumed. There is no such dependence for survival and induction of mutants. In both cases cross-sections increase with the ion's specific-energy indicating an important contribution of long-range delta-electrons. The analysis shows that diploid yeast is not killed by a single-hit mechanism even by very heavy ions if the track width is too small. The relative importance of the penumbral region is even more pronounced with the more sensitive strains.     

Preflare heating of filaments

Disappearances of preflare filaments have been observed on June 22, 1980 (S07,W13) (flare at 13.04 U.T.) and September 3, 1980 (flare at 7.52 U.T.). The analysis of MSDP data (MEUDON) leads to the followings conclusions : - Disappearances begin a few minutes before the Hα impulsive phase. - The filaments can be seen again after the flares. - Upwards motions occur in several points, without disturbing significantly preëxisting downflows.Velocity maps suggest shears or velocity loops.The filament disappearance seems to be due to a heating mechanism beginning before the flare maximum.     

The Resolution Performance of Range Estimators

The theoretical basis and methods of implementation of a moment algorithm for the range separation estimation of two closely spaced point targets are presented. Moment estimation and noise filtering techniques introduced here result in a considerable improvement over Baum's algorithm. The error bounds are established and it is shown that the spectral moment estimator exhibits optimum (zero bias, minimum variance) performance when the target separation normalized to the standard deviation of the Gaussian pulse is 2?1.5. Monte Carlo simulation is performed to verify the approximations made and to demonstrate the feasibility of the working models.     

Dissipation of temperature perturbations in the middle atmosphere

It is often observed that the stratospheric and mesospheric temperature structure undergoes transient disturbances from its averaged steady-state behavior. The causes may be traceable to gravity waves, planetary waves, solar proton and relativistic electron precipitation, etc. We examine the theoretical time behavior of the atmospheric temperature following the cessation of such heating phenomena as it relaxes toward its quiescent steady-state value. We also study the time-dependent response during a model stratospheric-warming/mesospheric-cooling event. In particular, we investigate the roles of eddy heat conduction, non-LTE cooling in the 15μm CO₂ band, and an ambient vertical wind, and their relative importance as they depend upon altitude and time, in modifying temperature changes in this region.     

Sequential Piecewise Recursive Filter for GPS Low-Dynamics Navigation

The design, implementation, and performance of a real-time estimation algorithm, referred to in this paper as the sequential piecewise recursive (SPWR) algorithm, for the global-positioning system (GPS) low-dynamics navigation system is described. The SPWR algorithm for this application was implemented in single precision arithmetic (32 bit, floating point). Numerical results are presented covariance and filter gains at a slower rate than the state measurement update, and it uses U-D factor formulation to perform covariance computations. The SPWR algorithm saves real-time processing requirements without appreciable degradation of filter performance. Another important feature of the SPWR algorithm is that it incorporates pseudorange and delta-range data from each GPS satellite sequentially for navigation solution. The SPWR algorithm, for this application, was implemented in single precision arithmetic (32 bit, floating point). Numerical results are presented.     

Comet nucleus sample return: Plans and capabilities

ROSETTA — the Comet Nucleus Sample Return mission — is one of the four Cornerstone missions to which ESA has committed itself in its approved Long-Term Programme Horizon 2000. The mission is currently being studied in collaboration with NASA. The comet-nucleus samples that ROSETTA is to provide will allow us to study some of the most primitive material in the solar system and the physical and chemical processes that marked the beginning of the system 4.6 billion years ago. For ESA, ROSETTA is a new type of mission: one which will return a sample at cryogenic temperature, and where as much effort has to be spent on preparing the laboratory analysis on-ground as has to be invested in preparing the space segment with the sample acquisition and in situ documentation. As part of the preparation for this mission, ESA is now starting to consider Planetary Protection issues.     

Energy and charge localization in irradiated DNA.

The relation between the site of energy deposition and the site of its biological action is an important question in radiobiology. Even at 77 degrees K, evidence is clear that these two sites must be separated since energy deposition is random but specific products are formed. Several processes that may contribute to this separation are: 1) hole migration and stabilization through deprotonation to give neutral oxidation product radicals; 2) electron trapping and transfer to form specific radical anions, possibly followed by protonation to give neutral reduction product radicals; and 3) recombination of spatially separated charges or radicals. These microscopic processes will be reviewed critically in an analysis using electron paramagnetic resonance spectroscopy (EPR) evidence for and against long-range transfer of energy and/or charge in frozen, hydrated DNA.     

A new system identification technique for harmonic decomposition

An extended and unifying system identification technique is presented for a class of systems that include all main signal models that arise in the harmonic decomposition problem. This technique unifies and extends the previously developed system identification techniques which are improvements on the Pisarenko harmonic decomposition (or, its spatial dual, MUSIC) as they arise in arrays of sensors. The advantages of the technique and some of its specializations include having no assumptions of stationarity on the stochastic processes involved. Another contribution of this technique is that it can also be used without any resort to probability theoretic concepts, thus bypassing the approximation of autocorrelations via time averages, yielding the system parameters exactly. This technique can be utilized to determine the dominant modes of vibrations of flexible structures as well. An analogy is established between arrays of sensors for target signal returns and those that can be used for vibrations in flexible structures. This enables the results developed for each one of these problems to be applied to the other