GPS modeling for designing aerospace vehicle navigation systems

The complexity of the design of a Global Positioning System (GPS) user segment, as well as the performance demanded of the components, depends on user requirements such as total navigation accuracy. Other factors, for instance the expected satellite/vehicle geometry or the accuracy of an accompanying inertial navigation system can also affect the user segment design. Models of GPS measurements are used to predict user segment performance at various levels. Design curves are developed which illustrate the relationship between user requirements, the user segment design, and component performance     

Nickel-Cadmium Batteries as Capacitive Filters for Pulsed Loads

This investigation consisted of several tests of specially fabricated nickel-cadmium batteries having circular disk-type electrodes. These batteries were evaluated as filter elements between a constant current power supply and a 5 Hz pulsed load demanding approximately twice the power supply current during the load on a portion of the cycle. Short tests lasting 104 cycles were conducted at up to a 21 C rate and an equivalent energy density of over 40 J/Ib. In addition, two batteries were subjected to 10h dischar cycles, one at a 6.5 C rate and the other at a 13 C rate. Assuming an electrode-to-battery weight ratio of 0.5, these tests represent an energy density of about 7 and 14 J/Ib, respectively. Energy density, efficiency, capacitance, average voltage, and available capacity were tracked during these tests. After 10y capacity degradation was negligible for one battery and about 20 percent for the other. Cadmium electrode failure may be the factor limiting lifetime at extremely low depth of discharge cycling. The output was examined and a simple equivalent circuit was proposed.     

Cometary origin of the biosphere: a progress report.

Empirical evidence of the accretion temperature for undifferentiated meteorites coming from the asteroid belt, combined with any reasonable temperature gradient extending from the asteroid belt to the Earth's zone, suggests that the Earth accreted from very hot dust grains that were degassed from all volatile elements and depleted in labile compounds. Isotopic evidence from the atmospheric noble gases also shows that no primary atmosphere has survived on the Earth. The only possible source for the atmosphere and the oceans is therefore the cometary bombardment that is predicted as the inescapable consequence of the formation of the giant planets. This implies that comets are the only source of organic carbon, nitrogen and water, hence of the total biosphere of the Earth.     

A theory of gravikinesis in Paramecium.

The archaic eukaryote unicellular microorganism, Paramecium, is propelled by thousands of cilia, which are regulated by modulation of the membrane potential. Ciliates can successfully cope with gravity, which is the phylogenetically oldest stimulus for living things. One mechanism for overcoming sedimentation is negative gravitaxis, an orientational response antiparallel to the gravity vector. We have postulated the existence of a negative gravikinesis in Paramecium, i.e. a modulation of swimming speed as a function of cellular orientation in space. With negative gravikinesis, an upward oriented cell actively augments the rate of forward swimming and depresses active locomotion during downward orientation. A brief outline of the gravikinesis hypothesis is given on a quantitative basis and experimental data are presented which have confirmed the major assumptions.     

Macrosegregation during crystal growth in horizontal bridgman boat

This paper is devoted to direct numerical simulation of the fluid flow and macrosegregation in horizontal Bridgman systems. Results concerning the fluid flows at Pr=0 and Pr=0.015 are given for various values of Gr and in situation where the melt-crystal interface is at rest. Practical laws concerning the behaviour of the mass transport and the level of inhomogeneity in the cavity are derived. The effects of some parameters such as Gr, Sc and the pulling speed on the concentration repartition in the two phases melt and crystal are studied and the average concentration in the crystal is shown for various situations.     

Design and analysis of a microprocessor-controlledpeak-power-tracking system [for solar cell arrays]

Stability and dynamics of a series configuration peak-power tracking (PPT) system are analyzed. The operating modes of the system, as well as mode transitions, are investigated based on qualitative graphical representations of dc load lines at various interfaces of the system. Analysis of multiloop control in the PPT mode is discussed. This includes the design of the inner voltage loop and analysis of the closed-loop system stability around the peak-power point. For an optimum dynamic performance and stability, design parameters of the inner voltage loop and the outer PPT loop are identified. Experimental verifications, supported by simulation results, are performed     

Performance of a centrifugal phytotron.

It is possible to cultivate plants under an artificial gravity field generated by a centrifugal device in space. In order to determine an optimal magnitude of gravity, there is a need to investigate the relationship between plant and growth and gravity, including not only reduced gravity but also gravity greater than 1G. A prototype centrifugal phytotron was designed and fabricated in order to investigate the relationship between plant growth and increased gravity. This device enables us to cultivate plants over the long term by controlling environmental conditions in the phytotron such as temperature, relative humidity, CO2 concentration and light intensity. The results of our experiment indicate that plant seeds can germinate and grow even under an artificial gravity which changes sinusoidally from 2G to 4G.     

A computer network with SCADA and case tools for on-line process control in greenhouses.

Climate control computers in greenhouses are used to control heating and ventilation, supply water and dilute and dispense nutrients. They integrate models into optimally controlled systems. This paper describes how information technology, as in use in other sectors of industry, is applied to greenhouse control. The introduction of modern software and hardware concepts in horticulture adds power and extra oppurtunities to climate contol in greenhouses.