An Experimental Radar Facility

A coherent CW superheterodyne radar system operating at frequencies of 9, 17, 35, and 70 GHz is described. The radars are installed on a free-flight range to study backscattering from wakes of hypersonic-velocity projectiles. Each radar is equipped with a focused-lens antenna oriented at an angle of approximately 45° to the flight axis. Amplitude and phase of the received signal are recorded separately. Some typical results are given to demonstrate the capabilities of the equipment.     

Time-Optimal Control of a Bounded Phase-Coordinate Process II: High-Order Systems with Multiple Control Inputs

This paper considers the problem arising from the design of an autopilot for a large booster. The motion-controlling actuators of the booster have both position and rate limits. The problem is formulated as a bounded phase-coordinate problem and analyzed by the ``backing out of the target' procedure. A method of constructing the optimal control is presented. An example of an oscillatory system with two control inputs is given, and the optimal control is expressed as an explicit time function.     

Estimated Flight Time for Optimum Trajectories

Various methods are presented for estimating the flight time for vehicles which fly an optimum trajectory. A realistic example is considered in order to display the inherent accuracy of each of these methods. Numerical integration methods are found to be the most accurate. Simple formulas are derived for the case where a less accurate estimate is acceptable. All of these methods require less computation than would be required in order to solve the overall optimization problem. Thus any one of these methods can be applied to an onboard guidance scheme or control system which requires a real time estimate of the time-to-go.     

Comments on the Communication and Data Problems Associated with a Mars Trip During a Conjunction Phase

The analysis and comments presented in this paper are meant to establish the general communication parameters associated with Martian flyby probes and with lander and manned vehicles. Fundamental data transfer problems are reviewed to define comparisons and trends of tradeoffs for future studies. Selected focal points are based upon the long propagation path length, with inherent time delays, and the high noise produced by the sun. These problems are magnified because large quantities of data must be obtained to satisfy the needs of the scientific community and the curiosity of an interested public. A comparison of two communication systems is provided: the microwave spectrum and the optical spectrum, as represented by the microwaves at 2.3 GHz and the laser at 6328 ?. A method of cost effectiveness or value received from space missions (a criterion of power input for data quantity received) is also presented.     

Checkout: A Changing Technology

On-board/in-flight checkout of future aerospace systems will necessitate a fundamental departure from today's design and checkout activities. The interrelationship of checkout, incorporated into prime vehicular functions, man as a subsystem, and standardization Of hardware/software must be considered as a functional and integral entity if the efforts of today's long-range planning are to become tomorrow's reality. This paper will describe future systems checkout, maintenance and support considerations, and actions and tentative measures necessary for implementation. The realization of the implementation of these concepts into functional elements will depend, accurately and economically, upon the degree of government perceptiveness and the extent of industrial support.     

Advanced Development of ESG Strapdown Navigation Systems

The fundamental problem of inertial navigation, double integration of acceleration to obtain position, is defined and discussed. Mechanizations of both space-stable and local-vertical platform systems are exhibited. The synthesis problem for an electrically suspended gyro (ESG) strapdown system is defined and discussed: readout, readout errors due to vehicle motion, synchronization of readout with system computer, alignment, correction and calibration for mass unbalance drift, and digital mechanization. Alignment, calibration, and acceleration measurement are also discussed. Sources of error involved in the electronic gimbaling including those peculiar to strapdown configuration are discussed and compared to mechanically gimbaled systems. Advanced developments required in the component and systems areas are listed, and it is shown that such development will lead to reduced complexity, higher accuracy, and increased reliability and utility for inertial systems.     

Recent developments in micrometeoroid simulation

In the first part the state of the art of the most advanced micrometeoroid simulation techniques is reviewed. Then a new accelerator is described, which was developed jointly by the Technische Universität München and the N.A.S.A. George C. Marshall Space Flight Center. Finally the use of this new technique is indicated for basic research in fields other than astronautics.     

High-Sensitivity Quartz Accelerometer for Measurements of Small Accelerations of Spacecraft

A quartz sensor of small accelerations with a capacitive transducer is designed and produced, allowing one to measure spacecraft accelerations with a resolution of 10^–7 m/s² in the range ±10^–1 m/s². The results of calibration of the sensor by the method of inclinations are presented.     

Ground and on-orbit command and data handling architectures for the Active Rack Isolation System microgravity flight experiment

The Active Rack Isolation System [ARIS] International Space Station [ISS] Characterization Experiment, or ARIS-ICE for short, is a long duration microgravity characterization experiment aboard the ISS. The objective of the experiment is to fully characterize active microgravity performance of the first ARIS rack deployed on the ISS. Efficient ground and on-orbit command and data handling [C&DH] segments are the crux in achieving the challenging objectives of the mission. The objective of the paper is to provide an overview of the C&DH architectures developed for ARIS-ICE, with the view that these architectures may serve as a model for future ISS microgravity payloads. Both ground and on-orbit segments, and their interaction with corresponding ISS C&DH systems are presented. The heart of the on-orbit segment is the ARIS-ICE Payload On-orbit Processor, ARIS-ICE POP for short. The POP manages communication with the ISS C&DH system and other ISS subsystems and payloads, enables automation of test/data collection sequences, and provides a wide range of utilities such as efficient file downlinks/uplinks, data post-processing, data compression and data storage. The hardware and software architecture of the POP is presented and it is shown that the built-in functionality helps to dramatically streamline the efficiency of on-orbit operations. The ground segment has at its heart special ARIS-ICE Ground Support Equipment [GSE] software developed for the experiment. The software enables efficient command and file uplinks, and reconstruction and display of science telemetry packets. The GSE software architecture is discussed along with its interactions with ISS ground C&DH elements. A test sequence example is used to demonstrate the interplay between the ground and on-orbit segments.     

Collision Risk Mitigation in Geostationary Orbit

The short- and long-term effects of spacecraft explosions, as a function of the end-of-life re-orbit altitude above the geostationary orbit (GEO), were analyzed in terms of their additional contribution to the debris flux in the GEO ring. The simulated debris clouds were propagated for 72yrs, taking into account all the relevant orbital perturbations.The results obtained show that 6–7 additional explosions in GEO would be sufficient, in the long term, to double the current collision risk with sizable objects in GEO. Unfortunately, even if spacecraft were to re-orbit between 300 and 500km above GEO, this would not significantly improve the situation. In fact, an altitude increase of at least 2000km would have to be adopted to reduce by one order of magnitude the long-term risk of collision among geostationary satellites and explosion fragments. The optimal debris mitigation strategy should be a compromise between the reliability and effectiveness of spacecraft end-of-life passivation, the re-orbit altitude and the acceptable debris background in the GEO ring. However, for as long as the re-orbit altitudes currently used are less than 500km above GEO, new spacecraft explosions must be avoided in order to preserve the geostationary environment over the long term.