Periodic components in Cyg X-3

Hard X-ray observations of Cyg X-3 in the energy range 20–100 keV were made with a Balloon-borne telescope using two large area proportional counters. The source was seen with a total significance of 20.

A 121 s periodicity was seen during Fourier analysis of the data. The phenomenon can be interpreted as due to transient pulsation since no other peak was seen in our data. Quasi-periodic oscillation in the range 0.06–20 mHz have been observed from Cyg X-3 at lower energies. Interestingly, most of the reported periods are multiple of the present measurements. The observed pulsation at high energies indicate the occasional unstable behaviour of the inner parts of the accretion disk connected with the basic rotation period of the compact object.

The 4.8^h modulation, characteristic of the orbital period of the binary system was seen in the data, with a broad maximum between the phase 0.3 to 0.7.     

SPOT-2 and TOPEX/Poseidon precise orbit determination from DORIS doppler tracking

The French earth observation satellite SPOT-2 has served as a testbed for precise orbit determination from DORIS doppler tracking in anticipation of the TOPEX/Poseidon mission. Using the most up-to-data gravity field model, JGM-2, a radial orbit accuracy of about 2–9 cm was achieved, with an rms of fit of the tracking data of about 0.64 mm/s. Furthermore, it was found that the coordinates of the ground stations can be determined with an accuracy of the order of 2–5 cm after removal of common rotations, and translations.

Using a slightly different model for atmospheric drag, but the same gravity model, precise orbits of TOPEX/Poseidon from DORIS tracking data were determined with a radial orbit accuracy of the order of 4–5 cm, which is far within the 13 cm mission requirement. This conclusion is based on the analysis of 1-day overlap of successive 11-day orbits, and the comparisons with orbits computed from satellite laser tracking (SLR) and from the combination of SLR and DORIS tracking. Results indicate a consistency between the different orbits of 1–4 cm, 4–20 cm, and 6–13 cm in the radial, cross-track, and along-track directions, respectively. The residual rms is about 4–5 cm for SLR data and 0.56 mm/s for DORIS tracking. These numbers are roughly twice as large as the system noise levels, reflecting the fact that there are still some modeling errors left.     

空间群Pn3mPn3P23子群链耦合系数的计算

本文利用陈金全教授的本征函数法计算了Pn3m Pn3 P2 3空间群的母分系数。最后的计算结果表明 ,用陈金全教授的本征函数法所求得的母分系数确实满足幺正、归一性 ,同时也证明了本征函数法对于求母分系数同样适用     

Solar-proton polar-cap intensity structures as a test of magnetic field models

The entry of energetic solar protons to the polar caps offers an interesting way to test models of the geomagnetic field. In this brief report, we present a comparison between SAMPEX observations of solar-particle intensity structure during a polar cap traversal with numerical trajectory calculations using the IGRF + T96 field model.     

地球同步轨道高压太阳电池阵充放电效应研究

地球同步轨道(GEO)高压太阳电池阵表面静电放电(ESD)引起二次放电可能导致太阳电池阵永久性短路损坏。文章主要针对GEO高压太阳电池阵充放电效应问题,重点分析了高压太阳电池阵表面ESD和二次放电产生的物理过程,并利用负高压偏置方法开展了GEO高压太阳电池阵表面ESD和二次放电地面模拟试验。试验验证了反转电位梯度电场是导致GEO高压太阳电池阵表面产生ESD的触发因素之一,同时得到了GaAs高压太阳电池阵样品表面产生ESD和二次放电的电压阈值。     

肋开孔高度对大宽高比矩形通道流动传热的影响

为了获得大宽高比矩形通道内开孔肋的流动与传热特性,采用数值模拟的方法在开孔肋的肋高e/Dh=0.188、开孔率β=0.131时研究了通道的摩擦系数、努塞尔数等参数随孔排高度和雷诺数的变化规律。结果表明:与实体肋相比,开孔肋能够减小通道的摩擦系数并提高其壁面温度分布的均匀性,但是传热增强因子有所减小;随着孔排高度的提升,通道的摩擦系数单调减小,壁面温度分布的不均匀度增大,而传热增强因子则先增大后减小,因此存在一最优孔排高度(h/e)opt=0.65使开孔肋的强化传热综合指标达到最大值;随着雷诺数的增大,开孔肋通道的摩擦系数缓慢减小、换热逐渐增强,这与实体肋的变化规律是类似的。     

基于PLIF技术的航空煤油横向射流穿透深度研究

为了研究动量比、韦伯数对射流穿透深度的影响,利用激光诱导荧光(PLIF)技术对航空煤油的穿透特性进行了试验。液态航空煤油通过直径为0.5mm的直射式喷嘴喷射入横向气流,Nd:YAG激光器产生266nm激光用于激发煤油诱导荧光。试验空气压力范围为0.3~0.6MPa,温度358K,动量比范围为10~40,韦伯数范围为170~340。试验结果表明:不同压力下,穿透深度随动量比增加而增加;在本文的工况范围下,韦伯数对射流穿透深度无显著影响。通过对试验数据的分析处理,获得了射流穿透深度关于动量比、韦伯数和轴向距离的经验关系式。     

超音速燃烧室燃烧效率数学模型及气流状态参数的计算

本文分析及提出了超音速燃烧冲压发动机燃烧室燃烧效率的数学模型.该模型综合了氢气喷射方式、燃烧室进口气流参数以及燃烧室结构的影响因素.用这一数学模型求解一组一元流方程.计算出通过燃烧室的气流状态参数,计算结果与试验数据对比,证明这个模型是适用的.     

非定常尾迹对叶栅气膜冷却效率的影响

通过实验的方法研究了非定常尾迹对气膜冷却效率的影响,在平面叶栅实验台上安装了尾迹发生器,用来产生非定常尾迹。用热电偶测量了雷诺数5 04×104,1 08×105,斯托劳哈儿数0 04～0 18时气膜的绝热冷却效率,通过实验数据分析了非定常尾迹的宽度和扫过频率对气膜绝热冷却效率的影响。发现非定常尾迹通过两方面来影响气膜冷却效率,一方面是通过对气膜层的扰动来降低气膜冷却效率,另一方面是通过改变局部吹风比来影响气膜冷却效率。     

以可用度为目标的民用飞机不完全预防性维修间隔优化

民用飞机制造商推荐的初始预防性维修间隔通常不考虑运营环境和维修能力的差异,在满足飞机安全性要求的同时,难以达到可用性的最优状态。基于不完全维修理论,采用役龄回退因子修正部件的可靠性模型,以反映维修工作对于部件性能的影响;结合航空公司运行实际情况,以部件可用度为目标函数,可靠度阈值为约束条件,提出不完全维修策略下的预防性维修间隔优化模型,并以某型飞机的空气起动机航线故障数据进行实例验证。结果表明：在满足可靠度阈值的约束条件下,所建立的维修间隔优化模型得出的最优维修间隔与实际相符,该模型合理可行。