组合催化剂MT在丁羟推进剂中的应用

研究试验了组合催化剂MT在丁羟推进剂中提高燃速和降低燃透压强指数的作用。结果表明，MT与不同含量和粒度小于10μm的AP匹配使用，燃速可在9mm／s～30mm／s范围内调节；压强指数均小于0．2（压强范围3MPa～9MPa），出现“平台”燃烧效应；发动机实测的压强指数与试验结果基本一致；选用合理的M与T组合比，可不影响推进剂制造工艺性能和药柱力学性能。对结果的理论分析认为，M与T对改善AP低压下热分解具有协同效应。     

激光喷丸成形多尺度有限元模拟技术

激光喷丸技术是一种先进的金属塑性成形和表面强化技术,相比于弹丸喷丸,激光喷丸能量密度更大,因而成形能力更强,可以用于成形刚度更大的钣金件,如飞机整体壁板,在航空航天领域有广泛的应用前景。构建一种多尺度激光喷丸成形模拟方法,包括激光喷丸诱导应力场的计算方法和基于直接应力法的工件成形曲率的预测方法。预测结果通过2024–T351铝合金块状试件和典型截面单筋件激光喷丸试验得到了验证,试验结果与模拟结果吻合较好,表明此模拟方法有效可行。     

基于VXI总线的检测软件设计

基于VXI总线和虚拟仪器技术，研制开发了用于外场的模拟式电子控制器检测软件，并对软件开发的过程和要求进行了分析，重点解决了程序设计中的需求分析和模块化设计问题。     

压铸机压射速度的闭环控制设计

为了提高压射速度的控制精度,对压铸机的压射速度提出了闭环控制,设计一个有限拍无纹波调节器,使压射速度跟踪理想的速度曲线,并通过MATLAB的SIMULINK进行仿真,得到仿真曲线,验证了该方法的有效性.     

上摆式客车行李舱门的设计

主要介绍了客车行李舱门的工作原理．对比了传统的与新式的行李舱门的结构，并提出了新式客车行李舱门的设计方案。根据运动要求确定出机构的主要尺寸参数，对AD杆进行受力情况分析，通过强度计算证实这种机构工作的可靠性．     

有限元素法在变截面钢板弹簧设计中的应用

钢板弹簧作为汽车的重要部件，它的强度与刚度对汽车的性能影响很大。本文探讨了采用间隙元法对钢板弹簧进行了有限元分析的可能性，并且对变截面钢板弹簧设计计算所采用的公式进行了分析与讨论。     

Application of small-size antennas for estimation of angles of arrival of HF signals scattered by ionospheric irregularities

A modification of the Doppler Interferometry Technique is suggested to enable estimating angles of arrival of comparatively broadband HF signals scattered by random irregularities of the ionospheric plasma with the use of small-size weakly directional antennas. The technique is based on the measurements of cross-spectra phases of the probe radiation recorded at least in three spatially separated points. The developed algorithm has been used to investigate the angular and frequency-time characteristics of HF signals propagating at frequencies above the maximum usable one (MUF) for the direct radio path Moscow-Kharkiv. The received signal spectra show presence of three families of spatial components attributed, respectively, to scattering by plasma irregularities near the middle point of the radio path, ground backscatter signals and scattering of the sounding signals by the intense plasma turbulence associated with auroral activations. It has been shown that the regions responsible for the formation of the third family components are located well inside the auroral oval. The drift velocity and direction of the auroral ionosphere plasma have been determined. The obtained estimates are consistent with the classical conception of the ionospheric plasma convection at high latitudes and do not contradict the results of investigations of the auroral ionosphere dynamics using the SuperDARN network.     

Avoid online radiation risk: Theoretical simulation of chromosome breaks in cells exposed to heavy ions

In this study, we report an easy and quick method on simulating chromosome breaks in cells exposed to heavy charged particles. The theoretical value of chromosome break was calculated, and validated comparison with experimental value by using premature chromosome condensation technique. A good consistency was found between theoretical and experimental value. This suggested that higher relative biological effectiveness of heavy ions was closely correlated with its physical characteristics. Also, a safe approach on predicting chromosome breaks in cells exposed to heavy ions at off-line environment can be considered. Furthermore, three key factors influencing the theoretical simulation was investigated and discussed.     

低轨卫星月影事件预报优化

针对卫星月影问题,提出了一种低轨卫星优化的月影预报策略,可以有效提高目前低轨卫星在轨管理时对月影事件预报的效率.结合仿真对产生月影事件的太阳、地球、月球的三体关系进行了分析,首先给出了月影产生的解析分析方法,并通过对一个三维月影影响模型的分析,得到了月影影响区间的判定要素——月影临界角;然后进一步通过对月影临界角的分析,提出了基于太阳与白道面的位置关系和月影临界角对低轨卫星月影事件的优化预报方法;最后基于大量的随机低轨卫星场景对本方法的正确性进行了验证.研究结果表明,此方法能够较大地提高月影预报效率,可以将月影预报频率从每月1次降低到每年2次,从而简化了低轨卫星在轨运行管理的任务复杂度,为卫星的在轨可靠运行提供支持.     

测控中的星载计算机快速切换

针对低轨卫星长期管理与测控中的星载计算机所需要的切换、维护的测控时间相对较长的问题,在分析原有主、备星载计算机的时间比对方法的基础上,直接针对备机建立新的时间同步模型,并进行公式推导和理论误差分析;然后建立新的测控事件调度模型,实现时间同步数据与主备机一致性数据的同时注入,优化工作流程,并有效缩短测控时间;最后编写新的遥控作业,在测控中进行实践.应用结果表明,采用新方法可以在一个测控圈次内完成在轨星载计算机的切换与维护,MTTR(Mean Time To Repair,平均恢复时间)小于8 min,时间同步精度优于1 ms,所需测控圈次相对于原方法减少83％以上,适用于在轨卫星长期管理与测控.