Concept of monitoring for thermostressed state and service life of aircraft gas turbine engine blades

A concept of monitoring for material properties with residual life estimation of rotor blades for gas turbine engines is proposed. The structure of on-board control and conditionmonitoring system based on the intelligent pyrometer module with the algorithm for calculating the residual life of turbine rotor blades is described.     

Composite model of a research flight simulator for a helicopter with the hingeless main rotor

This paper presents a composite model of a flight simulator. This simulator is intended for carrying out investigative tests of flight dynamics imitation models of a hingeless rotor helicopter. A schematic diagram, composition and operation channels of the flight simulator software are presented. A possibility of applying the control lag is estimated.     

Analysis of a beam with a crack under irregular cyclic load

This paper considers a beam with a technological longitudinal section on the level of the gravity center of the cross section that is loaded by a vertical concentrated force. We study the structure durability depending on the load amplitude and the initial crack length.     

Improvement of gas-dynamic efficiency of GTE gas turbine stages at the design stage

Methods to control flow have been considered in order to reduce end losses in blade rows of GTE gas turbines by means of measures taken at the design stage.     

Investigation of the role of aziridine bonding agents on the aging of the composite solid rocket propellant(CSRP)

The role of bonding agents on the aging characteristics is one of the important research topics.Aging program of the prepared propellant samples was conducting as follows:Five samples,two free of bonding agents,and three containing an aziridine based bonding agents(MAPO,HX-752,MAT4),four samples based on different bonding and curing agents all were aged at 70 ℃.The prepared bonding agent "MAT4" gave remarkable improvements and resulted in highly stable mechanical properties comparing with HX-752 or MAPO.The selected bonding agents family inhibited the rate of decomposition of the propellants during the aging periods and supported the propellant matrix against decomposition at the elevated temperatures.      

The Electric Antennas for the STEREO/WAVES Experiment

The STEREO/WAVES experiment is designed to measure the electric component of radio emission from interplanetary radio bursts and in situ plasma waves and fluctuations in the solar wind. Interplanetary radio bursts are generated from electron beams at interplanetary shocks and solar flares and are observed from near the Sun to 1 AU, corresponding to frequencies of approximately 16 MHz to 10 kHz. In situ plasma waves occur in a range of wavelengths larger than the Debye length in the solar wind plasma λ _D ≈10 m and appear Doppler-shifted into the frequency regime down to a fraction of a Hertz. These phenomena are measured by STEREO/WAVES with a set of three orthogonal electric monopole antennas. This paper describes the electrical and mechanical design of the antenna system and discusses efforts to model the antenna pattern and response and methods for in-flight calibration.     

The Plasma and Suprathermal Ion Composition (PLASTIC) Investigation on the STEREO Observatories

The Plasma and Suprathermal Ion Composition (PLASTIC) investigation provides the in situ solar wind and low energy heliospheric ion measurements for the NASA Solar Terrestrial Relations Observatory Mission, which consists of two spacecraft (STEREO-A, STEREO-B). PLASTIC-A and PLASTIC-B are identical. Each PLASTIC is a time-of-flight/energy mass spectrometer designed to determine the elemental composition, ionic charge states, and bulk flow parameters of major solar wind ions in the mass range from hydrogen to iron. PLASTIC has nearly complete angular coverage in the ecliptic plane and an energy range from ～0.3 to 80 keV/e, from which the distribution functions of suprathermal ions, including those ions created in pick-up and local shock acceleration processes, are also provided.