空-空导弹全向攻击最优制导规律研究

 将发射瞬时所确定的平行接近弹道作为基准弹道,由于各种干拢所引起的相对于基准弹道的偏离作为偏差来处理;用最优控制理论导出空-空导弹进行全向攻击的最优制导律,此制导律包含目标加速度反馈。当目标作非机动飞行时,最优制导律是一种变比例系数的比例制导。数字仿真结果表明:在相同条件下,最优制导弹道需用过载、终端脱靶量均小于比例制导,特别是从目标前方攻击时,其制导精度大大优于比例制导。     

环向圈连带冠叶片的动态分析

 本文将动态子结构方法中链式加载技术与群论算法相结合,提出环向固连带冠叶片动力特性分析的一种新方法。文中列出了分析步骤与具体公式,并有实例的计算结果。该方方法适用于研究具有带冠叶片的单级转子中,“冠”的整体效应。     

GH4169高温合金惯性摩擦焊接头动态再结晶过程

当温度、应变、应变速率达到一定条件时 ,GH4 16 9镍基高温合金在惯性摩擦焊接过程中易发生动态再结晶。本文研究结果表明 ,由于GH4 16 9合金惯性摩擦焊接时间很短 ,动态再结晶进行得相当充分 ,而动态回复不足 ,在动态再结晶的过程中还可以看到有些结晶过程还处于形核阶段 ,这是惯性摩擦焊接头产生细晶乃至超细晶的根本原因     

RFI用环氧树脂固化动力学研究

用DSC研究了RFI工艺用环氧树脂的固化过程,研究表明：该固化反应较复杂,其反应动力学方程为dα/dt=2.27×10^4exp（-4764.65/T）（1-α）^0.861.为RFI用环氧树脂固化工艺的确定提供了理论依据.     

金属图象分割的研究

结合金属图象的特点,利用传统阚值分割技术和基于最大熵原则的图象分割技术对金属图象分割进行了分析;并根据金属图象分析要求,提出了先二值化金属图象再进行边缘提取的方法.对比实验结果表明,基于最大熵原则的图象分割技术可以获得较好的分割效果,所提出的方法能够获得连续闭合的晶粒边缘,为下一步的金属图象分析提供了可靠的依据.     

多径衰落条件下两种常规测向方法的误差问题

讨论了莱斯多径衰落信道模型在两类常规测向技术中的应用。利用常规测向技术对信噪比的特定要求,分析了具有莱斯分布特性衰落信道对比相、比幅测向误差抖动的影响,给出了其分布函数,并通过仿真指出其应用限制。最后就工程应用中所关心的模型参数获取和采样点数确定等问题作一论述。     

Investigation of corona initiation voltage at reduced pressures

The results of an experimental study of the 60 Hz ac corona inception voltage at reduced pressures for a cylindrical conductor and a parallel ground plane are presented. Several spacings and bare and insulated conductors of several diameters are considered. Empirical expressions from which a reasonably accurate prediction of the corona inception voltage (CIV) may be made have been inferred from experimental data     

A recursive multiple model approach to noise identification

Correct knowledge of noise statistics is essential for an estimator or controller to have reliable performance. In practice, however, the noise statistics are unknown or not known perfectly and thus need to be identified. Previous work on noise identification is limited to stationary noise and noise with slowly varying statistics only. An approach is presented here that is valid for nonstationary noise with rapidly or slowly varying statistics as well as stationary noise. This approach is based on the estimation with multiple hybrid system models. As one of the most cost-effective estimation schemes for hybrid system, the interacting multiple model (IMM) algorithm is used in this approach. The IMM algorithm has two desirable properties: it is recursive and has fixed computational requirements per cycle. The proposed approach is evaluated via a number of representative examples by both Monte Carlo simulations and a nonsimulation technique of performance prediction developed by the authors recently. The application of the proposed approach to failure detection is also illustrated     

一种新颖的瞬时浮点放大器

介绍了瞬时浮点放大器的原理及构成，并给出一种结构新的具有２５６阶的瞬时浮点放大器，可有效地提高数据采集系统的测量范围。     

六喷管超音速引射器性能的理论分析和实验研究

对某一定尺寸的六喷管超音速引射器进行气动性能的实验研究。结果表明：随着主次流压比Ｐ＊ｐ／Ｐ＊ｓ增加，引射系数及修正引射系数下降；当引射系数增加时，混合管动量修正系数Ｋｍ下降，但主喷管流量系数μ变化不大。对上述工况进行理论计算的结果与实验数据符合良好。