VHF radio response of the near Earth space during solar activity growth in October, 2003

The analysis of observations of very high frequency radio noise intensity at the middle latitude on a frequency f = 500 MHz from 14th till 26th of October, 2003 is presented. These data are compared with the solar radio bursts in the range of frequencies 1–14 MHz registered by RAD2 receiver of the WAVES device installed on board the WIND spacecraft.     

Evaluation of upper body muscle activity during cardiopulmonary resuscitation performance in simulated microgravity

Performance of efficient single-person cardiopulmonary resuscitation (CPR) is vital to maintain cardiac and cerebral perfusion during the 2–4 min it takes for deployment of advanced life support during a space mission. The aim of the present study was to investigate potential differences in upper body muscle activity during CPR performance at terrestrial gravity (+1Gz) and in simulated microgravity (μG). Muscle activity of the triceps brachii, erector spinae, rectus abdominis and pectoralis major was measured via superficial electromyography in 20 healthy male volunteers. Four sets of 30 external chest compressions (ECCs) were performed on a mannequin. Microgravity was simulated using a body suspension device and harness; the Evetts–Russomano (ER) method was adopted for CPR performance in simulated microgravity. Heart rate and perceived exertion via Borg scores were also measured. While a significantly lower depth of ECCs was observed in simulated microgravity, compared with +1Gz, it was still within the target range of 40–50 mm. There was a 7.7% decrease of the mean (±SEM) ECC depth from 48 ± 0.3 mm at +1Gz, to 44.3 ± 0.5 mm during microgravity simulation (p < 0.001). No significant difference in number or rate of compressions was found between the two conditions. Heart rate displayed a significantly larger increase during CPR in simulated microgravity than at +1Gz, the former presenting a mean (±SEM) of 23.6 ± 2.91 bpm and the latter, 76.6 ± 3.8 bpm (p < 0.001). Borg scores were 70% higher post-microgravity compressions (17 ± 1) than post +1Gz compressions (10 ± 1) (p < 0.001). Intermuscular comparisons showed the triceps brachii to have significantly lower muscle activity than each of the other three tested muscles, in both +1Gz and microgravity. As shown by greater Borg scores and heart rate increases, CPR performance in simulated microgravity is more fatiguing than at +1Gz. Nevertheless, no significant difference in muscle activity between conditions was found, a result that is favourable for astronauts, given the inevitable muscular and cardiovascular deconditioning that occurs during space travel.     

Some issues of time-optimal control over a spacecraft programmed turn

The problem of optimal turn of a spacecraft from an arbitrary initial position to a final specified angular position in a minimum time is considered and solved. A case is investigated, when the constraint on spacecraft’s angular momentum during the turn is essential. Based on the quaternion method a solution to the posed problem has been found, and an optimal control program is constructed taking the constraints on controlling moment into account. The optimal control is found in the class of regular motions. A condition (calculation expression) is presented for determining the moment to begin braking with the use of measurements of current motion parameters, which considerably improves the accuracy of putting the spacecraft into a preset position. For a dynamically symmetrical spacecraft the solution to the problem of optimal control by the spacecraft spatial turn is presented in analytical form (expressions in elementary functions). An example of mathematical modeling of the spacecraft motion dynamics under optimal control over reorientation is given.     

The X/X/KA-band deep space transponder for the BepiColombo mission to mercury

This paper reports the main characteristics of the deep space transponder (DST) equipment that has been designed, developed and tested by Thales Alenia Space—Italy (TAS-I) for the European Space Agency (ESA) BepiColombo mission to Mercury.     

Lunar lander's three-dimensional translation and yaw rotation motion estimation during a descent phase using optical navigation

Optical navigation for a lunar lander consists of estimating a lander's 3-dimensional (3-D) relative dynamic motion with respect to a preselected landing site using a passive 2-dimensional (2-D) video image sequence. Lunar landing missions require a lander to perform an autonomous accurate landing with simple mechanical structure, easy operation and low cost. These requirements have motivated the need to develop an advanced navigation system. Existing navigation systems trade-off simplicity, accuracy and cost. High accuracy navigation systems typically imply complexity and high cost. In this paper, we consider a scenario where the descending phase starts from an initial altitude of 10 km with a time-of-descent of 100 s. The navigation camera is an off-the-shelf optical instrument used to take the video image sequence of the landing site during the landing phase. It is fed into the motion estimation algorithm to be processed. The continuous wavelet transform (CWT) is used to analyse each image frame of the input digital video image sequence. The output is a 2-D video image motion trajectory map, which represents the projection motion of the landing site. The 2-D video image motion is projected back to the 3-D lander's relative motion based on a geometric analysis. The outputs of this estimation algorithm are the 3-D attitude motion parameters of the lander at a time corresponding to an image being taken. The attitude determination and control system (ADCS) of the lander uses these data to perform the lander's attitude control task. In this article, we provide the motion modelling for a lunar lander during the descending phase. The projection of a 3-D planar to 2-D image plane is analysed which build the correspondence between the 3-D lander's motion and the 2-D image motion. This link provides the evidence for the geometry analysis. CWT is reviewed and CWT for video image sequence analysis is also introduced. Numerical simulation of the estimated 2-D video image sequence under the lander performing a 3-D translation and yaw rotation during the terminal descent are shown to verify the proposed concepts. The analysis of the results show that the proposed method achieves highly accurate 2-D video image motion estimation of less then 1% error with significant savings of cost, mass and volume. It leads to the accurate estimation of the lander's 3-D relative motion with respect to the landing site.     

A new universal equation for the time of transfer between two points of the central gravitational field

The paper presents the derivation of two new equations for calculating the time of transfer between two points of the central gravitational field: for hyperbolic orbits and the universal equation for elliptical and hyperbolic orbits. In the paper we have used as an independent variable, instead of the linear elements (semimajor axis, focal parameter of orbit or a chord connecting the ends of boundary radii of transfer), the angular parameter—the angle between the radius vector of an initial point of transfer and the vector of initial velocity of transfer. Paper’s material is a continuation of that presented in the “Space research“ Journal, vol. 2, March–April, 2009.     

Identification of failures in a set of sensors of a spacecraft

A method to find and identify failures in a spacecraft’s set of sensitive elements that measure vector quantities of different nature is discussed.     

The microbial habitability of weathered volcanic glass inferred from continuous sensing techniques

Basaltic glasses (hyaloclastite) are a widespread habitat for life in volcanic environments, yet their interior physical conditions are poorly characterized. We investigated the characteristics of exposed weathered basaltic glass from a surface outcrop in Iceland, using microprobes capable of continuous sensing, to determine whether the physical conditions in the rock interior are hospitable to microbial life. The material provided thermal protection from freeze-thaw and rapid temperature fluctuations, similar to data reported for other rock types. Water activity experiments showed that at moisture contents less than 13% wet weight, the glass and its weathering product, palagonite, had a water activity below levels suitable for bacterial growth. In pore spaces, however, these higher moisture conditions might be maintained for many days after a precipitation event. Gas exchange between the rock interior and exterior was rapid (< 10 min) when the rocks were dry, but when saturated with water, equilibration took many hours. During this period, we demonstrated the potential for low oxygen conditions within the rock caused by respiratory stimulation of the heterotrophic community within. These conditions might exist within subglacial environments during the formation of the rocks or in micro-environments in the interior of exposed rocks. The experiments showed that microbial communities at the site studied here could potentially be active for 39% of the year, if the depth of the community within the outcrop maintains a balance between access to liquid water and adequate protection from freezing. In the absence of precipitation, the interior of weathered basaltic glass is an extreme and life-limiting environment for microorganisms on Earth and other planets.     

Potential fossil endoliths in vesicular pillow basalt, Coral Patch Seamount, eastern North Atlantic Ocean

The chilled rinds of pillow basalt from the Ampère-Coral Patch Seamounts in the eastern North Atlantic were studied as a potential habitat of microbial life. A variety of putative biogenic structures, which include filamentous and spherical microfossil-like structures, were detected in K-phillipsite-filled amygdules within the chilled rinds. The filamentous structures (～2.5 μm in diameter) occur as K-phillipsite tubules surrounded by an Fe-oxyhydroxide (lepidocrocite) rich membranous structure, whereas the spherical structures (from 4 to 2 μm in diameter) are associated with Ti oxide (anatase) and carbonaceous matter. Several lines of evidence indicate that the microfossil-like structures in the pillow basalt are the fossilized remains of microorganisms. Possible biosignatures include the carbonaceous nature of the spherical structures, their size distributions and morphology, the presence and distribution of native fluorescence, mineralogical and chemical composition, and environmental context. When taken together, the suite of possible biosignatures supports the hypothesis that the fossil-like structures are of biological origin. The vesicular microhabitat of the rock matrix is likely to have hosted a cryptoendolithic microbial community. This study documents a variety of evidence for past microbial life in a hitherto poorly investigated and underestimated microenvironment, as represented by the amygdules in the chilled pillow basalt rinds. This kind of endolithic volcanic habitat would have been common on the early rocky planets in our Solar System, such as Earth and Mars. This study provides a framework for evaluating traces of past life in vesicular pillow basalts, regardless of whether they occur on early Earth or Mars.