Heavy ion observations by MARIE in cruise phase and Mars orbit

The charged particle spectrum for nuclei from protons to neon, (charge Z=10) was observed during the cruise phase and orbit around Mars by the MARIE charged particle spectrometer on the Odyssey spacecraft. The cruise data were taken between April 23, 2001 and mid-August 2001. The Mars orbit data were taken March 5, 2002 through May 2002 and are scheduled to continue until August 2004. Charge peaks are clearly separated for charges up to Z=10. Especially prominent are the carbon and oxygen peaks, with boron and nitrogen also clearly visible. Although heavy ions are much less abundant than protons in the cosmic ray environment, it is important to determine their abundances because their ionization energy losses (proportional to Z²) are far more dangerous to humans and to instruments. Thus the higher charged nuclei make a significant contribution to dose and dose equivalent received in space. Results of the charged particle spectrum measurements will be reported.     

Frequency-hopping signal detection using partial band coverage

The performance of a channelized radiometer in detecting a frequency-hopping signal is analyzed for a variable number of parallel radiometers not necessarily covering the entire hopping band. The full band may not be covered because of an attempt to avoid interfering signals, limited radiometer resources, lack of knowledge of the band frequency location, or combinations of these factors. The analysis provides for calculation of the value of the signal-to-noise ratio (SNR) required to achieve a given probability of detection for a specified false-alarm rate, assuming an observation interval equivalent to N hops using either a fixed or a moving observation window. The dependence of the probability of detection on a misalignment of the detector observation intervals with the hop transitions is also analyzed. Numerical results are presented and discussed. Applied to a typical slow-hopping VHF radio, the results imply that a 150-hop transmission can be detected by a channelized radiometer covering half the hopping band when the SNR is about 2 dB     

Statistical description of low-latitude plasma blobs as observed by DMSP F15 and KOMPSAT-1

The global distribution of low-latitude plasma blobs was investigated by in-situ plasma density measurements from the Korea Multi-Purpose Satellite-1 (KOMPSAT-1) and Defense Meteorological Satellite Program (DMSP) F15. In the observations, blobs occurred in the longitude sector where the activity of the equatorial plasma bubble (EPB) was appreciable, and additional blobs were found at the lower (KOMPSAT-1) altitude as in the EPBs. However, several notable differences exist between the distributions of EPBs and blobs. First, KOMPSAT-1 found few blobs around 0°E in March and June, as did DMSP F15 from 30°W to 120°E for every season. Second, the overall occurrences in December and March at the DMSP F15 (840 km) altitude were somewhat lower than expected from those of the EBPs. Third, at the DMSP F15 altitude, the occurrence probability of plasma blobs was less controlled by yearly variations in the solar activity. These results imply that topside ionospheric conditions as well as the existence of EPBs control further development of blobs. Additionally, it was found that the blob latitudes became higher as the yearly solar activity increased. Moreover, most of the blobs were encountered in the winter hemisphere, possibly due to the low ambient density.     

Current distribution control for parallel connected converters. II

For pt.I, see ibid., vol.28, no.3, p.829-840 (1992). In the central-limit control (CLC), the multiloop controls are employed to regulate the output voltage and track the central weighted current, thus equalizing the output current of each converter module (CM). The current distribution error (CDE) between the output current of each CM is used as a criterion in judging system performance. The prediction and simulation results of this control scheme are illustrated. When incorporated with the maximum current limit, the proposed control method can determine the number of required converters in the active state for each load condition. As a result, the efficiency of a system can be increased significantly. A comparison between the performances of the system under master-slave control (MSC) and CLC is given     

Nonlinear Analysis of a Family of LC Tuned Inverters

four widely used self-oscillating dc-to-square-wave parallel inverters which employ an inductor-capacitor tuned network to determine the oscillation frequency are reduced to a common equivalent RLC network. The techniques of singular-point analysis and state-plane interpretations are employed to describe the steady-state and transient ient behavior of these circuits and to elucidate the three possible modes of operation: quasi-harmonic, relaxation, and discontinuous. Design guidelines are provided through a study of the influence of circuit parameter variations on the characteristics of oscillation and on frequency stability. Several examples are provided to illustrate the usefulness of this analysis when studying such problems as transistor emitter-to-base junction breakdown during oscillations and the design of starting circuits to insure self-excited oscillations in these inverters.     

Analysis of Limit Cycles in a Two-Transistor Saturable-Core Parallel Inverter

A familiar two-transistor saturable-core parallel inverter is modeled as a nonlinear negative resistance in parallel with energy-storage elements. The techniques of singular-point analysis are combined with piecewise linear techniques to permit determination of solution trajectories on the phase plane. Clear insight is provided, not only into steady-state oscillation, but also into transient behavior of the circuit. Experimental results confirming the analytical model are included.     

Process of establishing design requirements and selecting alternative configurations for conceptual design of a VLA

In this study, a process for establishing design requirements and selecting alternative con-figurations for the conceptual phase of aircraft design has been proposed. The proposed process uses system-engineering-based requirement-analysis techniques such as objective tree, analytic hier-archy process, and quality function deployment to establish logical and quantitative standards. Moreover, in order to perform a logical selection of alternative aircraft configurations, it uses advanced decision-making methods such as morphological matrix and technique for order prefer-ence by similarity to the ideal solution. In addition, a preliminary sizing tool has been developed to check the feasibility of the established performance requirements and to evaluate the flight perfor-mance of the selected configurations. The present process has been applied for a two-seater very light aircraft (VLA), resulting in a set of tentative design requirements and two families of VLA configurations: a high-wing configuration and a low-wing configuration. The resulting set of design requirements consists of three categories: customer requirements, certification requirements, and performance requirements. The performance requirements include two mission requirements for the flight range and the endurance by reflecting the customer requirements. The flight performances of the two configuration families were evaluated using the sizing tool developed and the low-wing configuration with conventional tails was selected as the best baseline configuration for the VLA.     

System test results from the GNC experiments on the PRISMA in-orbit test bed

The PRISMA in-orbit test bed will demonstrate guidance, navigation, and control strategies for spacecraft formation flying and rendezvous. The project is funded by the Swedish National Space Board and the prime contractor is the Swedish Space Corporation. The project is further supported by the German Aerospace Center, the Technical University of Denmark, and the French Space Agency. PRISMA was launched on June 15, 2010 and after three weeks of operations, all on-board systems and units have passed an initial commissioning phase. Separation of the two PRISMA satellites from each other is expected by mid-August 2010.PRISMA consists of two spacecraft: MAIN and TARGET. The MAIN spacecraft has full orbit control capability while TARGET is attitude controlled only.The Swedish Space Corporation is responsible for three groups of guidance, navigation, and control experiments. These experiments include GPS- and vision-based formation flying during which the spacecraft will fly in passive as well as forced motion. The three experiments are: autonomous formation flying, proximity operations with final approach/recede maneuvers, and autonomous rendezvous. This paper presents system test results from two of these experiments as obtained with the flight-ready system. The system tests consist of a series of simulations performed on the flight model spacecraft with a large amount of hardware in the loop.