SIGMA observations of hard X-ray and soft gamma-ray emission from X-ray binaries

After more than two years of operation, the imaging γ-ray SIGMA telescope has accumulated several days of observation toward well known X-ray binaries. Four bright sources falling in this category have been detected so far: The pulsar GX 1+4 near the center of our galaxy, the stellar wind accreting system 4U 1700-377, and the black hole candidates Cygnus X-1 and GX 339-4. Moreover, SIGMA have observed three transients sources, which turned out to be also hard X-ray sources : The burster KS 1731-260, Tra X-1, and the Musca Nova. The properties of these systems in the SIGMA domain will be reviewed and a spectral distinction between black holes and neutron stars will be sketched.     

Observations of diffuse galactic positron annihilation radiation

The Galactic plane was scanned nearly three times by the UCSD/MIT Hard X-Ray and Low Energy Gamma-Ray Experiment on HEAO-1 from August 1977 through September 1978. Its Medium Energy Detectors were of the NaI/CsI phoswich type and operated over the 100 keV to 2 MeV range, with a 17° FWHM field of view and a 9% energy resolution at 511 keV. Sky maps for each epoch of observation were constructed in several energy bands. After subtraction of known point sources, a component associated with the galactic plane remains, whose spectrum is consistent with a power law and a positron annihilation spectrum. In the 333 to 583 keV energy band the flux is concentrated within ±35° of the galactic center, and the ratio of flux/radian (anticenter) is high, with a 2σ lower limit of 13. The parameters of the galactic center region's annihilation spectrum are positronium fraction of 0.9±0.1 and 511 keV flux of (2.0±0.7)×10⁻³ photons/cm²-sec-rad.     

褶皱结构成形时的形状偏差计算

解决了褶皱结构成形时相邻的平行四边形平面元素之间连接区棱的修圆半径值预测问题。把毛坯模拟成薄板，定义了平行四边形平面元素的边界条件，采用能量法导出挠度和力函数的非线性微分方程组，利用积分－差分法实现其数值解，并提供计算结果和分析应力－应变场。采用的计算方法可用于研究毛坯的刚度参数和工艺参数对褶皱结构的形状影响。     

Fractal Structure of the Heliospheric Plasma Sheet at the Earth''''s Orbit

An analysis of the data from the Wind and IMP-8 spacecraft revealed that a slow solar wind, flowing in the heliospheric plasma sheet, represents a set of magnetic tubes with plasma of increased density (N > 10cm-3 at the Earth's orbit). They have a fine structure at several spatial scales (fractality), from 2°-3°(at the Earth's orbit, it is equivalent to 3.6-5.4h, or (5.4-8.0)×106km) to the minimum about 0.025°, i.e. the angular size of the nested tubes is changed nearly by two orders of magnitude. The magnetic tubes at each observed spatial scale are diamagnetic, i.e. their surface sustains a flow of diamagnetic (or drift) current that decreases the magnetic field within the tube itself and increases it outside the tube. Furthermore, the value of β= 8π[N(Te + Tp)]/B2 within the tube exceeds the value of βoutside the tube. In many cases total pressure P = N(Te + Tp) + B2/8πis almost constant within and outside the tubes at any one of the aforementioned scales.     

Research on a complex CME event including Hα, LASCO, radio and MDI observations

We present our research on a fast and decelerating partial halo coronal mass ejection (CME) event detected in multi-wavelengths in the chromosphere and the corona on 14 October, 1999. The event involved a whole complex active area which spanned more than 40° of heliolongitude. It included a strong solar flare (XI/1N) and a complex eruptive filament within an active region of the entire complex. Especially, several radio sources were detected in the decimetric range prior to the CME by the Nançay Radioheliograph (NRH). A linear force-free field extrapolation of the Michelson Doppler Imager (MDI) magnetogram was performed to calculate the magnetic topology of the complex prior to the triggering of the event. The presence of a coronal null point combined with the occurrence of two distant and nearly simultaneous radio sources put strong arguments in favor of the generalized breakout model for the triggering of the eruption. The analysis of the subsequent development of the event suggests that large interconnecting loops were ejected together with the CME.     

Non-Thermal Processes in Cosmological Simulations

Non-thermal components are key ingredients for understanding clusters of galaxies. In the hierarchical model of structure formation, shocks and large-scale turbulence are unavoidable in the cluster formation processes. Understanding the amplification and evolution of the magnetic field in galaxy clusters is necessary for modelling both the heat transport and the dissipative processes in the hot intra-cluster plasma. The acceleration, transport and interactions of non-thermal energetic particles are essential for modelling the observed emissions. Therefore, the inclusion of the non-thermal components will be mandatory for simulating accurately the global dynamical processes in clusters. In this review, we summarise the results obtained with the simulations of the formation of galaxy clusters which address the issues of shocks, magnetic field, cosmic ray particles and turbulence.     

Great solar bursts of October 19, 22 and 23, 1989

Itapetinga measurements at 48 GHz with the multibeam technique are used to determine the relative position of solar burst centroid of emission with high spatial accuracy and time resolution. For the Great Bursts of October 19,22, 1989, with a large production of relativistic particles, and October 23, it is suggested that, at 48 GHz, the bursts might have originated in more then one source in space and time. Additionally the October 19 and 22 Ground Level Events exhibited very unusual intensity-time profiles including double component structures for the onset phase. The Bern observatory spectral radio emission data show a strong spectral flattening typical for large source inhomogeneties. The interpretation for this is that large solar flares are a superposition of a few strong bursts (separated both in space and time) in the same flaring region.     

Cyclic variations in the solar lower atmosphere

The Ca K line has been measured regularly nearly every month since 1974 at Kitt Peak. It is well known that the K₁ component of the Ca K line is formed in the temperature minimum region (TMR) of the solar atmosphere. Our study of the data of CaII K profiles over two solar cycles indicates that both in full disc integrated spectra and in center disc spectra, the distance between the red K₁ and the blue K₁ of the profiles and its average intensity show periodic variations. But the variation for the full disc integrated spectra fluctuates in the same way as the sunspot number does, while that for the center disc spectra has a time delay with respect to sunspot number. Non-LTE computations yield a cyclic temperature variation of about 17 K of the TMR in the quiet-Sun atmosphere and a cyclic variation of about 15–20 km in the height position of the TMR.     

Models of P/Borrelly: Activity and dust mantle formation

Comet 19P/Borrelly was observed by Deep Space One spacecraft on September 22, 2001 (Soderblom et al., 2002).The DS1 images show a very dark and elongate nucleus with a complex topography; the IR spectra show a strong red-ward slope consistent with a very hot and dry surface (345K to 300K). During DS1 encounter the comet coma was dominated by a prominent jet but most of the comet was inactive, confirming the Earth-based observations that <10% of the surface is actively sublimating. We have developed a thermal evolution model of comet PBorrelly, using a numerical code that is able to solve the heat conduction and gas diffusion equations at the same time across an idealized spherical nucleus ( De Sanctis et al., 1999, 2000; Capria et al., 2000; Coradini et al., 1997a,b). The comet nucleus is composed by water, volatiles ices and dust in different proportions. The refractory component is made by grains that are embedded in the icy matrix. The code is able to account for the dust release, contributing to the dust flux, and the formation of dust mantles on the comet surface. The model was applied to a cometary nucleus with the estimated physical and dynamical characteristics of P/Borrelly in order to infer the status and activity level of a body on such an orbit during the DS1 observation. The comet gas flux, differentiation and thermal behavior were simulated and reproduced. The model results are in good agreement with the DS1 flyby results and the ground based observations, in terms of activity, dust coverage and temperatures of the surface.