A Fast Beamforming Algorithm for Large Arrays

This beamforming algorithm is written specifically for array radars in which the number of array elements K is very large compared with the number of jammers L the radar is designed to suppress. It uses a set of M noise vectors to construct a basis for the jammer component of the antenna output vectors. The component of the quiescent weight vector orthogonal to each basis vector is calculated, renormalized to unit length, and identified as the adapted weight vector. This algorithm is effective in the suppression of many types of jammers. The number of noise samples M required in the construction of the adapted weight vector is approximately equal to L. In the special case of L narrowband noise jammers, for example, a choice of M = L usually reduces the receiver output jammer power to a few dBs above the white noise background. It is permissible to have M相似文献   

An Adaptive Array Signal Processing Algorithm for Communications

An algorithm is described for initial synchronization in a communication system with a digital adaptive array. This algorithm can also be used for message extraction. A set of consecutive complex video samples of the array output is processed to obtain optimum adaptive array weights, based on a least mean square (LMS) error criterion. This computation is performed for each of the possible alternative signals which may be present during an observation interval. The correct synchronization time or message symbol is selected as the one which yields the minimum LMS error. Assuming orthogonality of the alternative codes, a probability distribution for the output of this processor has been derived.     

Analysis and Design of Series Resonant Converter by State-Plane Diagram

Analysis based on the state-plane diagram is given for series resonant converters operating in the frequency range 0.5 ? fs/fo ? 1.0. When the voltages and currents in the converter are normalized, design parameters take on special geometric meanings in the normalized state diagram. Examples of converter design using graphical methods are given for the cases of ? and ? control. Control characteristics of the converter operating in the continuous conduction mode are derived. The concept of the energy reflection coefficient is introduced as a measure of power transfer efficiency in the converter design.     

Ultraviolet spectrometer experiment for the Voyager mission

The Voyager Ultraviolet Spectrometer (UVS) is an objective grating spectrometer covering the wavelength range of 500–1700 Å with 10 Å resolution. Its primary goal is the determination of the composition and structure of the atmospheres of Jupiter, Saturn, Uranus and several of their satellites. The capability for two very different observational modes have been combined in a single instrument. Observations in the airglow mode measure radiation from the atmosphere due to resonant scattering of the solar flux or energetic particle bombardment, and the occultation mode provides measurements of the atmospheric extinction of solar or stellar radiation as the spacecraft enters the shadow zone behind the target. In addition to the primary goal of the solar system atmospheric measurements, the UVS is expected to make valuable contributions to stellar astronomy at wavelengths below 1000 Å.     

ATC Beacon Interference Characteristics in the New York Area

An experimental program is described that had the objective of measuring the effects of the time-dependent structure of downlink (air craft to ground) interference generated by the Air Traffic Control Radar Beacon System (ATCRBS) in an active air traffic terminal area that are relevant to system and ground controller response time. The results of this program indicate a number of interesting details concerning the correlation of the level of the downlink interference with changes in the arrival and departure rates of aircraft at the local terminal sites.     

Identifications of some highly-ionized iron and nickel lines in the 200–400 Å region of the solar spectrum

A number of previously unclassified multiplets of Fexiv, xiii, xii, and xi produced by transitions of the type 3s ²3p ⁿ -3s3p ⁿ⁺¹ are identified in the XUV spectrum of the Sun. The iron lines account for most of the previously unidentified strong lines between 330 and 370 Å. Solar observations of especial value for the investigation of the 300–400 Å region were the slitless spectroheliograms of September 22, 1968 (Purcell and Tousey, 1969) and November 4, 1969 (Tousey, 1971) — on which the image of a flare was recorded. Other solar identifications in the same spectral region include the resonance lines of Nixvii and Nixviii, and one 3p-3d multiplet of Fexiii. The solar blend at 417 Å involving the Fexv inter-combination line and Sxiv is resolved.     

Electronically Tracking Antenna System for Satellite Reception

This correspondence describes a novel electronically tracking antenna system for satellite reception in the VHF range. The "hedgehog" antenna consists of several antennas directed in different directions to cover the whole sky. An electronic switch, controlled by the satellite receiver, connects the receiver to the antenna from which the desired satellite signal is obtained. This system is especially suitable for unmanned reliable receiving stations if an antenna gain of the order of 10 dB is enough.     

On the relation between the mass loss rate and the stellar parameters of OB-type stars

We discuss mass loss relations for OB-type stars as a function of luminosity, effective temperature, and mass. We conclude that a simple first order linear regression relation is as good as any other more sophisticated relation, with the advantage that the simple form consumes much less computer time when used in evolutionary codes.