Resonance in a coupled solar-climate model

The 11–year solar activity cycle is magnetic in origin and is responsible for small changes in solar luminosity and the modulation of the solar wind. The terrestrial climate exhibits much internal variability supporting oscillations with many frequencies. The direct effect of changing solar irradiance in driving climatic change is believed to be small, and amplification mechanisms are needed to enhance the role of solar variability. In this paper we demonstrate that resonance may play a crucial role in the dynamics of the climate system, by using the output from a nonlinear solar dynamo model as a weak input to a simplified climate model. The climate is modelled as oscillating about two fixed points (corresponding to a warm and cold state) with the weak chaotically modulated solar forcing on average pushing the solution towards the warm state. When a typical frequency of the input is similar to that of the chaotic climate system then a dramatic increase in the role of the solar forcing is apparent and complicated intermittent behaviour is observed. The nonlinear effects are subtle however, and forcing that on average pushes the solution towards the warm state may lead to increased intervals of oscillation about either state. Owing to the intermittent nature of the timeseries, analysis of the relevant timeseries is shown to be non-trivial.     

Climate Observations - The Instrumental Record

A survey is given of the available instrumental data for monitoring and analysis of climatic variations. We focus on temperature measurements, both over land and ocean, at the surface and aloft.Over land, the older observations were subject to exposure changes which may not have been fully compensated. The effects of urbanization have been largely avoided in studies of climatic change over the last 150 years. There are few records for pre-1850 outside Europe and eastern North America, and the global network shows a recent decline. Over the ocean, sea surface temperature (SST) has been measured using buckets, engine intakes, hull sensors, buoys, and satellites. Many of these data have been effectively homogenized, but new challenges arise as observing systems evolve. Available SST and marine air temperature datasets begin in the 1850s. The data are concentrated in shipping lanes especially before 1900, and very sparse during the world wars, but additional historical data are being digitized.The radiosonde record is short (40 years) and has major gaps over the oceans, tropics and Southern Hemisphere. Instrumental heterogeneities are beginning to be assessed and removed using physical and statistical techniques. The MSU record is complete but only began in 1979, and is not highly resolved in the vertical: major biases, mainly affecting the lower-tropospheric retrieval, have been reduced as a result of recent analyses.Advanced interpolation or data-assimilation techniques are being applied to these data, but the results must be interpreted with care.     

Amplification of the influence of solar flux variations on the winter stratosphere by planetary waves

Recent observational evidence has suggested that variations in solar activity may affect winter stratospheric polar ozone and temperature levels. The paucity of direct sunlight available during this season points strongly to a dynamical mechanism. We have carried out several large ensemble experiments within the middle atmosphere and the coupled middle atmosphere and lower thermosphere to simulate the radiative/dynamical coupling via planetary waves for a range of solar fluxes. In the former case, the model response in the winter stratosphere was linear and of the order of the summer stratopause forcing, whilst in the latter, the level of correlation in the winter stratosphere remained high, but was diluted over a wider volume. The inclusion of the upper atmosphere enhanced the winter polar stratospheric response by a factor of three.     

Dynamics of an Eddy-Current-Torqued Gyro-Stabilized Assembly

Prominent among the commonly encountered gyro-stabilized assemblies used in guidance and tracking are those which are eddy-current torqued. Although eddy-current-torquecd lead- computing gunsights, which use spinning mirrors, have been well known for thirty years, it has been difficult to find an analysis of the torques developed by the precession mechanism. In this paper a model configuration of the torquer is presented. The total gyro dynamics are then determined by including these torque terms in the model presented in the preceding paper.     

An Algorithm for Designing Burst Waveforms with Quantized Transmitter Weights

An algorithm is described which finds optimum transmitter and receiver weights to maximize clutter suppression in a predetermined clutter region when using burst waveforms. It is assumed that the transmitter weights can only take on values from a finite set. This optimization problem is solved using a branch and bound algorithm. An example is given which shows the improvement in clutter suppression when this new design procedure is used as compared to a simpler nonoptimal procedure.     

C/SiC复合材料超声振动钻孔评估

在分析碳纤维增强碳化硅复合材料的力学性能、密度、孔隙率和弯曲强度的基础上 ,进行了超声钻孔工艺试验 ,检测并研究了材料去除率、孔径差、孔边质量和工具损耗情况 ,得出了超声钻孔是一种好的加工方法的结论。     

扩压器-水泵内非稳定流动研究

水泵内部流动实质上是复杂的三维非稳定流动 ,它对水泵性能及结构振动有重要影响。本文介绍了一种求解这种复杂内流动的数值方法。三维雷诺数平均的纳维斯托克斯方程 ( 3-DReynolds-averaged Navier-Stokes,RANS)以及标准 k-ε的方程用于描述水泵内非定常紊流流场。系统特性方程与水泵的 CFD模型相结合以考虑流体在管道中的加速 ;采用任意滑移网格界面模拟叶轮和静止部件之间的相互干涉 ;将整个叶轮作为分析对象 ,以考虑失速情况下流动的周向非对称。这些技术的结合包括了水泵内非稳定流动的物理实质。一台实验数据比较齐全的离心式 -扩压器水泵被用于验证所提出的数值方法     

Tracking multiple objects with particle filtering

We address the problem of multitarget tracking (MTT) encountered in many situations in signal or image processing. We consider stochastic dynamic systems detected by observation processes. The difficulty lies in the fact that the estimation of the states requires the assignment of the observations to the multiple targets. We propose an extension of the classical particle filter where the stochastic vector of assignment is estimated by a Gibbs sampler. This algorithm is used to estimate the trajectories of multiple targets from their noisy bearings, thus showing its ability to solve the data association problem. Moreover this algorithm is easily extended to multireceiver observations where the receivers can produce measurements of various nature with different frequencies.