Design for a bioreactor with sunlight supply and operations systems for use in the space environment.

An experiment was carried out to determine the characteristics of an operations system that can support fast cultivation of algae at high densities in the weightlessness of space. The experiment was conducted in glass bioreactor tanks, in which light was supplied by radiator rods connected to optical fiber cables. The illumination areas of the tanks were 2600 cm2, 6000 cm2, and 9200 cm2 per liter of solution. The characteristics of O2-CO2 gas exchange, concentration and separation of chlorella in the growth medium, dialysis of ionic salts in the growth medium, etc. were examined. Chloralla ellipsoidea was used in the experiment, yielding the following results: (1) By increasing the ratio of illumination area to volume, growth rates of up to approximately 0.6 g/L h could be obtained in a highly concentrated solution (one that contains 20 g/L or more of algae). (2) The most suitable proportions of carbon dioxide and oxygen gases for growing algae quickly at high concentrations were found to be 10% CO2 and 10% O2 (by volume). (3) There was a high optimum concentration for fast cultivation, and the data obtained resembled the theoretical curve postulated by P. Behrens et al. (4) It was possible to exchange carbon dioxide and oxygen using gas-permeable membrane modules. (5) It was possible to separate the chlorella from the growth medium and recycle the medium.     

Sunlight supply and gas exchange systems in the microalgal bioreactor.

The bioreactor with sunlight supply system and gas exchange systems presented here has proved feasible in ground tests and shows much promise for space use as a CELSS device. Our chief conclusions concerning the specification of total system needed for a life support system for a man in a space station are the following. (1) Sunlight supply system: compactness and low electrical consumption. (2) Bioreactor system: high density and growth rate of chlorella. (3) Gas exchange system: enough for O2 production and CO2 assimilation.     

A program to measure new energetic particle nuclear interaction cross sections.

The Transport Collaboration, consisting of researchers from institutions in France, Germany, Italy and the USA, has established a program to make new measurements of nuclear interaction cross sections for heavy projectiles (Z > or = 2) in targets of liquid H2, He and heavier materials. Such cross sections directly affect calculations of galactic and solar cosmic ray transport through matter and are needed for accurate radiation hazard assessment. To date, the collaboration has obtained data using the LBL Bevalac HISS facility with 20 projectiles from 4He to 58Ni in the energy range 393-910 MeV/nucleon. Preliminary results from the analysis of these data are presented here and compared to other measurements and to cross section prediction formulae.     

一种基于红外序列图像的弱小目标检测方法

针对天空背景下红外运动弱小目标的检测问题,提出一种结合小波变换和管道滤波的序列图像的检测算法。首先对红外序列图像采用小波变换,再采用全局门限法进行阈值分割提取出潜在目标,用形态开运算去除噪声点,以减少候选目标数目,最后再使用管道滤波的方法确定真实目标。实验结果表明,该方法能有效地检测运动红外弱小目标,显著提高红外弱小目标的检测概率,并易于硬件实现。     

The Electric Antennas for the STEREO/WAVES Experiment

The STEREO/WAVES experiment is designed to measure the electric component of radio emission from interplanetary radio bursts and in situ plasma waves and fluctuations in the solar wind. Interplanetary radio bursts are generated from electron beams at interplanetary shocks and solar flares and are observed from near the Sun to 1 AU, corresponding to frequencies of approximately 16 MHz to 10 kHz. In situ plasma waves occur in a range of wavelengths larger than the Debye length in the solar wind plasma λ _D ≈10 m and appear Doppler-shifted into the frequency regime down to a fraction of a Hertz. These phenomena are measured by STEREO/WAVES with a set of three orthogonal electric monopole antennas. This paper describes the electrical and mechanical design of the antenna system and discusses efforts to model the antenna pattern and response and methods for in-flight calibration.     

Significance of fluid dynamics aspects for material science experiments

Fluid dynamics aspects for material science experiments may be treated with respect to purely space experiments and preparatory experiments on the ground. Preparatory experiments are necessary because little experience of material science experiments in space is available. Preparatory experiments on earth are needed in the field of surface tension and viscosity, surface layers, forming and positioning of liquids. Concerning space experiments the following subjects may be treated: convection phenomena, capillarity and kinetics of liquids. Convection phenomena (Marangoni convection) can be studied without disturbance by gravitation which has a considerable technological relevance. Under space conditions the kinetics of fluids may be studied in large model structures with changing capillarity and wetting properties.     

基于不完备模糊规则库的信息融合故障诊断方法

在基于模糊推理的故障诊断专家系统中,规则库的不完备常常会引起系统的某些输入产生的输出不确定。针对此问题,将模糊推理与证据理论相结合提出了一种新的融合诊断方法。首先根据证据的随机集表示及随机集扩展准则将模糊输入映射到输出,并聚合生成故障命题的基本概率赋值(BPA),以度量由规则库不完备和输入模糊性引起的输出不确定。然后利用Dempster组合规则将多个不完备规则库提供的BPA融合,用融合结果判决故障,并以电机转子故障诊断为例,验证了所提方法可以有效地提高故障确诊率。     

Advances in non-linear apodization

Selected new methods and applications of non-linear apodization for irregularly-shaped and parse coherent apertures and arrays are presented. The benefits include unproved impulse response performance, i.e., reduced peak sidelobes and integrated sidelobe power, along with improved mainlobe resolution, compared to classic windowing techniques. Nonlinear apodization (NLA) techniques can also serve as powerful engines for effective superresolution and bandwidth extrapolation of coherent data for filling sparse apertures. The sparse aperture filling property of superresolution algorithms for radar data forms the basis for a new concept which is introduced here: synthetic multiple aperture radar technology (SMART). Increased swath and/or reduced antenna size are some of the benefits postulated for SMART applied to synthetic aperture radar (SAR) systems. The benefits of these new methods and applications for nonlinear apodization are then demonstrated for two specific applications: 1) sidelobe control for Y-type synthetic aperture radiometers, such as the European Soil Moisture and Ocean Salinity (SMOS) system (Kerr et al.) and JPL's proposed GeoSTAR (Lambrigsten) concept; and, 2) filling of sparse synthetic aperture radar data by exploiting the bandwidth extrapolation properties of nonlinear apodization based superresolution techniques. The methods that have been developed and demonstrated herein have potential application to a wide range of passive and active microwave remote sensing and radar systems.