Identifications of some highly-ionized iron and nickel lines in the 200–400 Å region of the solar spectrum

A number of previously unclassified multiplets of Fexiv, xiii, xii, and xi produced by transitions of the type 3s ²3p ⁿ -3s3p ⁿ⁺¹ are identified in the XUV spectrum of the Sun. The iron lines account for most of the previously unidentified strong lines between 330 and 370 Å. Solar observations of especial value for the investigation of the 300–400 Å region were the slitless spectroheliograms of September 22, 1968 (Purcell and Tousey, 1969) and November 4, 1969 (Tousey, 1971) — on which the image of a flare was recorded. Other solar identifications in the same spectral region include the resonance lines of Nixvii and Nixviii, and one 3p-3d multiplet of Fexiii. The solar blend at 417 Å involving the Fexv inter-combination line and Sxiv is resolved.     

A Concept of Position Fixing by a Passive Mode Navigation Satellite System

A position fix in a passive mode using satellites usually necessitates an expensive computer or lengthy hand calculation. This is the largest drawback of passive navigation and it would be more desirable if the user could find his position by a mere glance at a chart and table, as one uses Loran. The first step toward this goal is to use a synchronous satellite because it simplifies the problem. The next step is to find the position of the user by a Loran type of chart, which is universal, and correct this apparent position by looking at a special table which is made according to the amount of perturbation of both the satellite and the user's position. An example of the position fix along the route between Yokohama to Hawaii is shown. The concept can be extended to orbiting satellites due to the rules which govern the motion of satellites, if the fix accuracy is in the order of 2 to 5 miles. This method should be more accurate than the common sextant and more practical due to the fact that the satellite can be used at any time and in any weather. As a total system, it will be better than Omega because it could provide additional navigation information such as communication or traffic control by using satellites.     

Solar Gamma-Ray Spectroscopy

Interactions of ions accelerated in solar flares produce gamma-ray lines and continuum and neutrons. These emissions contain a rich set of observables that provides information about both the accelerated ions and the environment where the ions are transported and interact. Ion interactions with the various nuclei present in the ambient medium produce gamma-ray lines at unique energies. How abundance information is extracted from the measurements is discussed and results from analyses of a number of solar flares are presented. The analyses indicate that the composition of the ambient gas where the ions interact (typically at chromospheric densities) is different from that of the photosphere and more like the composition of the corona, exhibiting low-FIP elemental enhancements that may vary from flare to flare. Evidence for increased Ne/O and the photospheric ³He abundance is also discussed.     

Remote data sensing using SAR and harmonic reradiators

In sensor networks distributed over large areas, communication by means of active transmitters on sensor nodes is inherently energy expensive and poses a significant bottleneck to achieve a long battery life. We propose modulated reradiation of radar illumination as a means to transmit information from a group of sensors to an airborne radar. This puts the communications energy burden on the radar transmitter rather than on the sensor nodes, thus increasing their battery lifetimes. To distinguish the sensor return from the clutter return, the modulation on the sensors is done by switching a nonlinear load on the sensor antenna and processing the harmonic reradiation. We present techniques to transmit information from the sensors, which use stripmap mode synthetic aperture radar (SAR) ideas to decode the information and to simultaneously obtain a geographic map of the sensor locations.     

Dissipation of magnetic fields in active galactic nuclei

A model for the emission processes causing rapid variability (less than one day) in active galactic nuclei is developed. Relativistic electron beams escape from reconnection sheets in coronae of accretion disks and excite plasma turbulence with a typical frequency , which depends on the electron number densityn (see also the contribution by R. van Oss). The finite lengths of different beams emerging from different reconnection sheets allows that the waves arecoherently scattered to frequencies ²_pe. For Lorentz factors 10³ and densities typical for disk coronaen10⁶ cm ^–3 (derived from iron line observations) one easily reaches the optical, frequency range. The time scale of the variability is then caused by the relaxation of the electron beams. Likewise, this model explains the very rapid variability in the X-ray (less than 10 minutes) by changing the parameters slightly. According to this scenario the higher the variable frequency is, the closer to the central black hole it should originate.     

Steady-state analysis of the constant-frequency clamped seriesresonant converter

A constant-frequency diode-clamped series resonant converter (CFCSRC) is proposed as a solution to problems associated with frequency-controlled resonant converters. This converter has two resonant frequencies, and control is achieved by varying the relative time spent at each switching frequency. Two zero-current-switching (ZCS) modes are examined and plotted in the output plane. An equation is given for the boundary between the two ZCS modes, as well as an expression for the boundary between ZCS and non-ZCS operation; both are plotted in the output plane. The output equation for the main mode is shown to be hyperbolic. Converter peak voltages limited to the input voltages, and peak currents are less than those of the frequency-controlled clamped series resonant converter over a large operating range. Data from a prototype converter are compared with theoretical data and are shown to be in good agreement with the theoretical model     

A recursive multiple model approach to noise identification

Correct knowledge of noise statistics is essential for an estimator or controller to have reliable performance. In practice, however, the noise statistics are unknown or not known perfectly and thus need to be identified. Previous work on noise identification is limited to stationary noise and noise with slowly varying statistics only. An approach is presented here that is valid for nonstationary noise with rapidly or slowly varying statistics as well as stationary noise. This approach is based on the estimation with multiple hybrid system models. As one of the most cost-effective estimation schemes for hybrid system, the interacting multiple model (IMM) algorithm is used in this approach. The IMM algorithm has two desirable properties: it is recursive and has fixed computational requirements per cycle. The proposed approach is evaluated via a number of representative examples by both Monte Carlo simulations and a nonsimulation technique of performance prediction developed by the authors recently. The application of the proposed approach to failure detection is also illustrated     

A localizer design to improve missed approach guidance

A novel VHF localizer system has been designed, built and successfully tested to provide increased reliability and safety of commercial and general aviation air transportation. Additional benefits are more precise tracks for aircraft executing a missed approach, reduced volume of the airspace needed for missed approaches, and reduced sizes of areas affected by noise. The design uses contemporary instrument landing system (ILS) hardware to provide dual independent front and back course directional localizer operation with two carriers in the receiver passband offset 4 kHz from the nominal carrier frequency. An example is given of an application and solution to an ILS problem at Reno, NV. Relevant data are presented     

Multiple target tracking using products of position measurements

The continued development of the symmetric measurement equation (SME) filter for track maintenance in multiple target tracking (MTT) is considered, focusing on the case in which the SMEs are generated by forming sums of products of the original position measurements. The SME filter is developed for the case of N targets whose motions consist of random perturbations about constant-velocity trajectories. It is assumed that measurements of x-coordinate positions are available, and that the number of measurements is equal to the number of targets. Various analytical properties of the SME filter are studied. It is shown that under a very weak condition, the estimation error equation is locally exponentially stable. The performance of the SME filter is investigated by comparing it with an optimal (minimum-variance) estimator and by generating a computer simulation in the six-target case