多等级区域侦察弹性星座设计方法

针对传统侦察星座目标单一、弹性低的问题，提出了多等级区域侦察弹性星座的设计方法。该方法将星座设计过程按区域等级信息分为多个子星座逐步设计，直到整体星座对所有的区域性能满足设计要求。以区域被划分为3个等级为例，首先对星座设计需求、设计指标及设计步骤进行了分析。其次推导了地面最低分辨率和轨道高度的关系并确定了不同子星座的轨道高度。最后考虑轨道倾角、一箭多星发射、光照和升交点漂移同步约束，构建基础星座、子星座1和子星座2的优化模型。最终设计星座为3层混合星座，共8个轨道面和70颗卫星，星座对各等级区域的最大重访时间分别为10937s，12241s和17437s，弹性指数为2213%，2420%和6361%。结果表明该方法设计的星座可实现对区域覆盖和弹性分级的设计要求，证明了方法的有效性。对比Walker星座设计方法，在同等设计要求下，Walker星座所需卫星数为156颗，多等级区域侦察弹性星座所需卫星数远低于Walker星座，结果进一步证明了该星座设计方法的优越性。     

针栓式推力室冷却特性试验研究

针栓式发动机具有推力调节简单、声学燃烧稳定性好和成本低廉等一系列优点,但目前对针栓式推力室的冷却特性掌握还不够深入,研制过程中曾多次出现因推力室冷却组织不好而烧蚀的问题。采用针栓式推力室试验件,对身部的冷却特性进行了深入研究,结果表明:推力室圆柱段前端的温度较低,无需采用专门的冷却措施;末端内侧气壁温度会达到约1650℃,局部存在明显的烧蚀现象,必须采取有效的热防护措施;下游冷却液膜量的变化对圆柱段的冷却特性影响较小。     

Numerical investigation of flow mechanisms of tandem impeller inside a centrifugal compressor

This study numerically investigated a single stage centrifugal compressor ‘‘Radiver’’ with a wedge diffuser and several tandem-designed impellers to explore the flow phenomena within the tandem impeller and the potential to enhance compressor performance. The results demonstrate that tandem design and clocking fraction (λ_s) significantly affects the compressor performance. The compressor stage with tandem impellers of Series A of boundary layer growth interruption alone are observed to have a widely operating range but efficiency and total pressure ratio penalty compared with that of conventional impeller. The tandem impeller with at least the same impeller efficiency as the conventional design is considered as a critical design criteria so that further modification process based on the flow characteristic of tandem impeller is necessary. In order to restrain the inducer wake and exducer shock losses, parameters modification of blade angle and thickness distributions are necessary and the modified tandem impeller of Series B is obtained. The modified tandem impeller with 25% clocking arrangement shows an 8.45% stall margin increase and maintains the total pressure ratio and efficiency as the conventional design, which proves the potential of tandem impeller to improve compressor stage performance. It is noteworthy that the tandem impellers of Radiver have not shown obviously balanced exit flow field and the fundamental mechanism of stall margin extending of tandem impeller lies on the improved impeller/diffuser matching performance resulting from the incidence angle variation at diffuser inlet.     

Distributed intelligent self-organized mission planning of multi-UAV for dynamic targets cooperative search-attack

This article studies the cooperative search-attack mission problem with dynamic targets and threats, and presents a Distributed Intelligent Self-Organized Mission Planning (DISOMP) algorithm for multiple Unmanned Aerial Vehicles (multi-UAV). The DISOMP algorithm can be divided into four modules: a search module designed based on the distributed Ant Colony Optimization (ACO) algorithm, an attack module designed based on the Parallel Approach (PA) scheme, a threat avoidance module designed based on the Dubins Curve (DC) and a communication module designed for information exchange among the multi-UAV system and the dynamic environment. A series of simulations of multi-UAV searching and attacking the moving targets are carried out, in which the search-attack mission completeness, execution efficiency and system suitability of the DISOMP algorithm are analyzed. The simulation results exhibit that the DISOMP algorithm based on online distributed down-top strategy is characterized by good flexibility, scalability and adaptability, in the dynamic targets searching and attacking problem.     

二维变厚板的J积分分析

本文将J.R.Rice提出的J积分公式扩充应用到二维变厚板。本文把变厚度的影响以修正项形式引入J积分公式,从而推导出二维变厚板的J积分扩充表达式。      

发动机喘振-爆燃故障的信号分析

本文着重介绍某双轴发动机喘振—爆燃故障用 FFT信号处理机进行诊断和信号分析的方法。文章结合发动机在湍流动态畸变流场下的喘振—爆燃试验研究,介绍了试验设备、测量系统和对发动机“故障”信号分析的结论。湍流型动态畸变流场下的压气机喘振多为“漂移型”喘振,表现有随机性。发动机对动态畸变流场的敏感度远高于稳态畸变。利用 FFT信号分析技术进行故障诊断,有广泛应用价值。它较其它方法精确、迅速、简便。      

轴流风扇旋转失速时的流场测量与分析

针对渐近型旋转失速在一轴流风扇上进行了一些测量工作,包括失速时的激光平均流场测量和热丝动态测量两大类。激光平均流场研究表明失速团主要活动在风扇转子前缘,而转子叶片通道中的流场则主要表现为叶尖间隙流的横向堵塞流动。      

辨识传递函数模型的应用程序及技术问题探讨

我们用BASIC语言设计了根据频响数据辨识传递函数模型（以下简称模型）的应用程序。在计算机上对八个模型的频响数据进行了辨识,结果较吻合。 一、原理和误差判定准则 1.原理 应用最小二乘原理,使试验结果C（jω₁）和辨识结果G_a（jω₁）的误差平方和为最小。      

智能诊断的定量推理机制和最优推理环境

描述和分析了一种新的基于智能信息处理的故障检诊方法,可以处理复杂动态系统故障检诊面临的复杂故障组合模式和时间特性。从推理机制的量化和推理环境的优选两方面完善了该理论,使其诊断能力、实时性和适用范围都得到提高。推理机制的量化是通过引入概率信息实现的。考虑到诊断过程中可能出现新的故障。又进一步引入了候选项集合扩张机制描述该现象,并提供了相关的概率计算公式。推理机制定量化使得诊断结果可以精确度量,检诊过程也可精确控制。推理环境优选则是通过引入熵信息实现的,由此提高了诊断效率。     

鱼鳞纹叶栅试验研究

鱼鳞纹叶栅临界马赫数比原型提高了９．５％,减少了４６．９％,比直纹叶栅也减少了１０．７％。最大二元静压比比原型高２．７％,比直纹叶栅高１．１７％。在原型叶栅不能达到的Ｍａ１＝０．８处,两种花纹叶栅均未堵塞。