导航卫星中断频次的分析方法

面向导航卫星中断频次的定量分析需求,该文分析导航卫星中断产生的主要原因,给出中断频次分析的流程,并针对分析过程中的三个关键问题,研究提出具体实施方法,包括通过相关性分析快速定位底层中断事件,通过中断树建立指标分析模型,并融合在轨数据、地面试验数据快速预估得到底层功能异常率等。最后通过示例进一步说明中断频次分析过程。该文方法已应用于北斗导航卫星工程。     

Fault mode probability factor based fault-tolerant control for dissimilar redundant actuation system

This paper presents a Fault Mode Probability Factor (FMPF) based Fault-Tolerant Control (FTC) strategy for multiple faults of Dissimilar Redundant Actuation System (DRAS) composed of Hydraulic Actuator (HA) and Electro-Hydrostatic Actuator (EHA). The long-term service and severe working conditions can result in multiple gradual faults which can ultimately degrade the system performance, resulting in the system model drift into the fault state characterized with parameter uncertainty. The paper proposes to address this problem by using the historical statistics of the multiple gradual faults and the proposed FMPF to amend the system model with parameter uncertainty. To balance the system model precision and computation time, a Moving Window (MW) method is used to determine the applied historical statistics. The FMPF based FTC strategy is developed for the amended system model where the system estimation and Linear Quadratic Regulator (LQR) are updated at the end of system sampling period. The simulations of DRAS system subjected to multiple faults have been performed and the results indicate the effectiveness of the proposed approach.     

Impact of rain on wave retrieval from Sentinel-1 synthetic aperture radar images in tropical cyclones

The main objective of our work was to investigate the impact of rain on wave observations from C-band (~5.3 GHz) synthetic aperture radar (SAR) in tropical cyclones. In this study, 10 Sentinel-1 SAR images were available from the Satellite Hurricane Observation Campaign, which were taken under cyclonic conditions during the 2016 hurricane season. The third-generation wave model, known as Simulating WAves Nearshore (SWAN) (version 41.31), was used to simulate the wave fields corresponding to these Sentinel-1 SAR images. In addition, rainfall data from the Tropical Rainfall Measuring Mission satellite passing over the spatial coverage of the Sentinel-1 SAR images were collected. The simulated results were validated against significant wave heights (SWHs) from the Jason-2 altimeter and European Centre for Medium-Range Weather Forecasts data, revealing a root mean square error (RMSE) of ~0.5 m with a 0.25 scatter index. Winds retrieved from the VH-polarized Sentinel-1 SAR images using the Sentinel-1 Extra Wide-swath Mode Wind Speed Retrieval Model after Noise Removal were taken as prior information for wave retrieval. It was discovered that rain did indeed affect the SAR wave retrieval, as evidenced by the 3.21-m RMSE of SWHs between the SAR images and the SWAN model, which was obtained for the ~1000 match-ups with raindrops. The raindrops dampened the wave retrieval when the rain rate was < ~5 mm/hr; however, they enhanced wave retrieval for higher rain rates. It was also found that the portion of the rain-induced ring wave with a wave number > 0.05 rad/m (~125 m wavelength) was clearly observed in the SAR-derived wave spectra.     

中华世纪坛旋转噪音测试方法的研究

着重阐述了中华世纪坛在实际工作中为解决噪音问题所采用的测试方法，寻求一种解决长时间、多数据测试分析的途径。     

备件配置方法研究

针对电路板件故障数据记录的实际,运用可靠性理论,提出了没有故障数据板件的备件数量计算方法;对有故障统计数据的板件引用了经验模型来确定备件配置。     

一种新的六端口测量系统自校准方法

提出了一种新的六端口自校准方法.本方法从六端口相对功率理论出发,导出了六端口系统常数的自校准方程,给出了求解系统常数初值的方法,并利用梯度法对方程组求解,仿真结果表明用一个匹配负载、四个失配负载就可以解出系统常数.     

CBERS-1卫星红外多光谱扫描仪扫描子系统

文章介绍了CBERS -1卫星红外多光谱扫描仪(IRMSS)关键部件扫描子系统研制与应用情况。     

基于PCI总线的石英晶体元件电参数测试仪

首先介绍PCI总线控制专用芯片S5920的组成,Mailboxs、FIFO、Pass-Thru的基本概念、性能和使用方法。其次介绍测量石英晶体元件参数的阻抗计法和π网络法。对基于PCI总线控制器S5920为核心的π网络法石英晶体元件电参数测试仪的设计和实现作了说明。该方法测量的频率可达2005MHz。利用GPs高精度的授时信号作为频率校准信号校准信号源的精度。     

利用秩统计方法确定不完全S-N数据的p-S-N曲线

本文依据结构不同可靠度下的S—N曲线形状参数相同的观点，利用复合材料结构的不完全S—N数据，得到一组不完全疲劳极限数据，并采用秩统计方法，求得结构的p—S—N曲线，最后，给出了两个应用实例，通过对比分析了本文方法与假定完全寿命法的处理结果，发现本文方法充分利用了数据信息，能给出更好的疲劳性能。