Analysis of a Class of Nonlinear Sampled-Data Systems with a Gaussian Input Signal

The problem treated here is the analysis of a class of nonlinear sampled-data systems with a Gaussian input signal. The nonlinear element is a symmetrical limiter (memoryless device) that feeds the linear element. Preceding the limiter is a sampler and zero-order hold unit for data reconstruction. The analysis is predicated on finding an equivalent gain for the nonlinear element such that the mean-square error is a minimum. The nonlinearity is thus replaced by a linear component and the system is then analyzed by conventional techniques. It is also shown that for appropriate sampling rates the sampled-data system is equivalent to a continuous system due to the action of the sampler-hold combination. All calculations pertaining to the limiter input signal require the use of a transfer function that is interior to the feedback loop. However, in developing this transfer function, the overall system is considered so that the system output may be evaluated after the value of equivalent gain has been found.     

Error Analysis of Space-Stable Inertial Navigation Systems

The error equations for a space-stable inertial navigation system are derived. This is done by directly perturbing the mechanization equations in the inertial frame and then transforming in open-loop fashion to the local-level frame. A rotating inertial platform and velocity and altitude damping are considered. The relations between errors in space-stable and local-level systems are noted. Numerical results are presented for certain random error sources.     

The Detection Performance of the Siebert and Dicke-Fix CFAR Radar Detectors

The Siebert and the Dicke-fix CFAR radar detectors, used to maintain a constant false alarm rate (CFAR) in radar receivers under very similar circumstances, are considered. The Siebert detector represents the maximum-likelihood detection procedure for a signal in Gaussian noise of unknown power level, whereas the Dicke-fix makes use of a bandpass limiter to normalize the input and thus ensure a constant false alarm rate. The detection performance of the two detectors is determined and a comparison shows that over a wide range of parameters, the Dicke-fix introduces a loss which is approximately 1 B larger than for the Siebert detector.     

Comments on "Optimum Bandwidth of a Low-Pass Filter for Detection of a Pulse in Nonstationary Noise"

In a recent correspondence1 a calculation of the optimum bandwidth of a low-pass RC filter for the detection of a pulse signal in nonstationary noise was presented. The purpose of this correspondence is: 1) to point out additional references to the work which has been conducted in the stationary noise case, and 2) to present an interesting alternate derivation of the expected output noise power for the nonstationary noise case.     

A Closely Regulated TWT Converter

The design concept for the traveling wave tube amplifier converter for possible use in the Thermoelectric Outer Planet Spacecraft (TOPS) is presented. An unusual combination of semiconductors and magnetics were utilized to achieve very stable voltage regulation on a number of separate outputs to satisfy the requirements of a high-power traveling wave tube (TWT), and at the same time operate at an efficiency of better than 90 percent from a 30-volt source. The circuitry consists of an output filter, an auxiliary Jensen oscillator driving a high-reactance transformer to provide current limiting to the heater, a variable time delay, a main Jensen oscillator driving the power transformer with a maximum step-up ratio of 120 to 1, and series transistorized post regulators to provide precise voltage adjustment and low output impedance. This paper discusses the design of the high-reactance transformer and the high step-up ratio transformer, as well as the high-voltage series regulators that are limited in range and operate at the top of the unregulated output voltage. Test data is presented, and details of current transients caused by charging the filter circuits, input current ripple, and output voltage ripples are considered. The circuit provides better than 0.5 percent regulation against load change, input voltage change, and over-operating temperature range of from -20 to + 80°C, with output ripple voltage of less than 2 volts peak-to-peak on top of the 3600-Vdc output. The measured efficiency was typically 87 percent. and recommendations are included to improve this to in excess of 90 percent.     

A Major Step in Series Regulators

Power hybrid microelectronic design techniques have been developed to satisfy the requirements of 10-ampere 100-watt series voltage regulators. Application of these new techniques has resulted in a package occupying roughly the same volume as a TO-63 power transistor, yet containing two 30-ampere power transistors, selectable external components, and associated control circuitry.     

Some early results of the keV plasma experiment on GEOS-1

Some preliminary new results are presented of the keV plasma experiment on GEOS-1. Electrons and ions have been observed to stream along the magnetic field lines in the dayside magnetosphere from the ionospheric side of the satellite towards the equatorial plane during magnetic storms, with streaming velocities corresponding to a kinetic energy of the order of a keV. The opposite streaming velocity has also been seen, but primarily in the ions only and with a smaller flux ratio for the two opposite directions along the field lines. The transition between the two opposite streaming directions, as seen by the satellite, has been found to occur even in a fraction of a second.In magnetic storm conditions azimuthal asymmetries in ion fluxes corresponding to electric field intensities of several tens of millivolts per meter have been observed.     

Adaptive Tracking Filter for Maneuvering Targets

A general method of continually restructuring an optimum Bayes-Kalman tracking filter is proposed by conceptualizing a growing tree of filters to maintain optimality on a target exhibiting maneuver variables. This tree concept is then constrained from growth by quantizing the continuously sensed maneuver variables and restricting these to a small value from which an average maneuver is calculated. Kalman filters are calculated and carried in parallel for each quantized variable. This constrained tree of several parallel Kalman filters demands only modest om; puter time, yet provides very good performance. This concept is implemented for a Doppler tracking system and the performance is compared to an extended Kalman filter. Simulation results are presented which show dramatic tracking improvement when using the adaptive tracking filter.