导航卫星有效载荷的仿真技术研究

文章针对GPS和Galileo导航卫星有效载荷,研究有效载荷仿真系统可变参数的在线更改实现技术,达到构建灵活参数设置,验证导航体制的目的;文章还对仿真过程中的信息流进行了分析,给出了可行的信息流程图。     

基于DDS的扫频干扰信号产生技术

传统的函数扫频压制干扰为避免温飘采用波形产生器调制锁相源的方法实现,但锁相源的低通滤波电路严重制约慢扫扫频模式下的频谱带宽,锁相源中VCO的非线性还影响带内幅频特性。采用FPGA直接控制DDS产生体现多种函数波形特性的中频扫频信号,克服了函数扫频干扰无法实现慢扫扫频干扰的瓶颈问题。     

自蔓延高温合成MgO-B4C微观组织研究

B2O3-Mg-C体系的SHS过程中,由于还原剂Mg的蒸气压较高,因此它与B2O3之间的反应不可避免地受到环境中惰性气体压力的影响,研究发现,不同气压下产物的晶粒尺寸与形貌不同,气压分别为101．3Kpa和10．1MPa时,产物B4C的粒径相应为0．4um和5um。     

预浸机织织物的本构关系

 预浸机织织物是一种未固化的织物复合材料,其性质既不同于纯织物材料也不同于固化后的织物复合材料,具有独特的力学性质。根据连续介质力学的理论,结合预浸织物的非线性的黏弹性特性,从代数不变量出发,推导了预浸织物的本构方程。同时对描述预浸织物性能的像框剪切试验的步骤及方法做了阐述。通过像框剪切试验的结果与本构方程的对比,验证了本构方程的正确性,该方程较好地描述了预浸积物的性质。本构方程的导出为研究空间充气结构的静态、动态及热分析奠定了一定的理论基础。     

飞行器红外隐身效能工程评价方法

 针对飞行器的红外隐身问题,推导出红外辐射对比度与作用距离的理论关系,采用指数拟合获得大气透过率与作用距离的近似关系表达式,简化了对作用距离的计算,并通过实际算例考察了目标表面温度、目标发射率和飞行速度对红外辐射对比度及作用距离的影响。结果表明：对比度和作用距离随目标表面温度、发射率及飞行速度的下降趋势基本一致;在一定条件下,对比度可代替作用距离作为评价目标红外隐身效果的简单、快速的参数,对比度越小目标的红外隐身效果越好。对比度的计算快速、准确、灵活性强和适用范围广,为今后进一步对飞行器的红外隐身研究提供一定的理论参考。     

联合太阳和行星际物理参数预测行星际激波能否到达地球

选取第23太阳活动周（1997—2006年）期间542例由太阳爆发活动驱动的行星际激波事件,分析确定了太阳源头和行星际空间中影响行星际激波能否到达地球轨道的关键物理参数;在此基础上,建立了预测行星际激波能否到达地球的新预报模型（EdEaSPM）. 回溯预报结果表明,EdEaSPM模型的预报成功率约为66%,略高于国际一流预报模型的预报成功率;EdEaSPM模型的虚报率未超过50%,改善了当前国际主流模型虚报率较大的情况;对于偏度指标,虽然当前所有模型的偏度值均大于1,但EdEaSPM模型的偏度值最接近于1且明显小于其他模型的偏度值;EdEaSPM模型的其他评价指标也都高于国际主流模型的相应指标. 此外,选取2012年期间的激波事件对EdEaSPM模型进行了预报检验,预测结果与实际情况吻合. EdEaSPM模型不仅能够提前约1～3天进行预报,而且预报效果与国际一流模型具有可比性,尤其是在提高预报成功率及降低虚报率方面具有一定优势.     

相控阵雷达长时跟踪波束调度与波形优化策略

针对相控阵雷达多目标跟踪波束调度和波形参数优化控制的问题，本文提出了一种基于马尔可夫决策过程（MDP）的相控阵雷达跟踪波束调度与波形参数优化策略，该方法以无迹卡尔曼滤波（UKF）算法为基础来估计目标的状态。首先将本文的序列决策问题建模为马尔可夫决策过程，定义了资源的效费比和长期回报率，然后与当前实际跟踪误差综合考虑作为MDP的回报函数，进而给出了调度的优化模型，最后将长时决策问题转化为动态规划算法结构进行求解，并且提出了一种并行混合遗传粒子群优化算法来求解各决策时刻的最优策略。仿真结果表明了长时策略的先进性以及寻优算法的优越性，与传统的短时策略相比，跟踪精度可提高11.17%。     

An improved real-time cycle slip correction algorithm based on Doppler-aided signals for BDS triple-frequency measurements

Doppler, which is an instantaneous GNSS observable signal, has been proven effective in determining velocity and acceleration due to its high availability and accuracy. We propose a real-time triple-frequency cycle slip correction (CSC) method based on Doppler-aided signals because Doppler shift is time-independent and immune to cycle slips. When the sampling interval is less than 1 s, cycle slips on triple-frequency can be detected and repaired using pure Doppler data with high reliability; however, this method cannot be used when the sampling interval exceeds 1 s because the integral cumulative error of Doppler increases significantly. For such cases, a modified triple-frequency CSC approach has been developed based on the raw phase and smoothed code data that was refined using the Doppler signal. To suppress the effect of the integral Doppler error, a balance factor is introduced to adjust the contributions of the raw code and Doppler observables. After the refinement of the GNSS data, three independent combinations need be selected to detect and repair cycle slips with triple-frequency observations. Four constrained criteria have been proposed to select optimal combinations that can reduce the residual ionospheric delay (RID) and measurement noise to a low level. Finally, experiments were carried out to test the performance of the new method using real triple-frequency BDS observations (GPST: 3:15:00–5:55:00, March 23, 2018). The results show that pure Doppler can detect and repair cycle slips effectively with small intervals, and modified Hatch-Melbourne-Wübbena (HMW) method based on Doppler-aided signals can achieve 99.7% success rate in cycle slip correction with large intervals (up to 30 s).     

Comparison of RO tropopause height based on different tropopause determination methods

The tropopause is an important boundary in the Earth’s atmosphere, and has been the subject of close attention from atmosphere and climate researchers. To monitor the global tropopause using radio occultation (RO) data, there are two primary methods, one is the widely used temperature lapse rate method, and the other is the bending angle covariance transform method which is unique to RO data. We use FengYun3-C (FY3C) and Meteorological Operational Satellite Program (MetOp) RO data and European Centre for Medium-Range Weather Forecasts (ECMWF) operational analysis data to determine differences in RO tropopause height calculated by these two methods. We compute biases of the RO lapse rate tropopause height (LRTH) and the RO bending angle tropopause height (BATH) relative to the ECMWF LRTH. The dependences of the tropopause height biases on tropopause height (TPH) retrieval method, latitude, season and RO mission are investigated. The results indicate that BATH show a consistent 0.8–1.2 km positive bias over the tropics and high latitude regions compared with LRTH, however, over 25° to 40° latitude in both hemisphere, BATH results are less stable. Furthermore, the mean bias between BATH and LRTH displayed a different symmetrical characteristic from 2017.12 to 2018.2 (DJF) compared to 2018.6–2018.8 (JJA). However, except for some bias over Antarctica, the mean value of both LRTH and BATH show a similar tropopause variation, indicating the consistency of both methods.     

The attitude inversion method of geostationary satellites based on unscented particle filter

The attitude information of geostationary satellites is difficult to be obtained since they are presented in non-resolved images on the ground observation equipment in space object surveillance. In this paper, an attitude inversion method for geostationary satellite based on Unscented Particle Filter (UPF) and ground photometric data is presented. The inversion algorithm based on UPF is proposed aiming at the strong non-linear feature in the photometric data inversion for satellite attitude, which combines the advantage of Unscented Kalman Filter (UKF) and Particle Filter (PF). This update method improves the particle selection based on the idea of UKF to redesign the importance density function. Moreover, it uses the RMS-UKF to partially correct the prediction covariance matrix, which improves the applicability of the attitude inversion method in view of UKF and the particle degradation and dilution of the attitude inversion method based on PF. This paper describes the main principles and steps of algorithm in detail, correctness, accuracy, stability and applicability of the method are verified by simulation experiment and scaling experiment in the end. The results show that the proposed method can effectively solve the problem of particle degradation and depletion in the attitude inversion method on account of PF, and the problem that UKF is not suitable for the strong non-linear attitude inversion. However, the inversion accuracy is obviously superior to UKF and PF, in addition, in the case of the inversion with large attitude error that can inverse the attitude with small particles and high precision.