Ultraviolet spectrometer experiment for the Voyager mission

The Voyager Ultraviolet Spectrometer (UVS) is an objective grating spectrometer covering the wavelength range of 500–1700 Å with 10 Å resolution. Its primary goal is the determination of the composition and structure of the atmospheres of Jupiter, Saturn, Uranus and several of their satellites. The capability for two very different observational modes have been combined in a single instrument. Observations in the airglow mode measure radiation from the atmosphere due to resonant scattering of the solar flux or energetic particle bombardment, and the occultation mode provides measurements of the atmospheric extinction of solar or stellar radiation as the spacecraft enters the shadow zone behind the target. In addition to the primary goal of the solar system atmospheric measurements, the UVS is expected to make valuable contributions to stellar astronomy at wavelengths below 1000 Å.     

Design of the HEAO Main Bus Shunt Regulator

The High Energy Astronomy Observatory (HEAO) main bus regulator contains a redundant error amplifier (REA) and a 12-section sequenced shunt transconductance amplifier (STA) in which not more than three and not less than one shunt section are in an active control mode regardless of a failure in any one of the twelve sections. The part of the work concerned with the shaping of the frequency response of the REA and STA minor feedback loops and of the teolator major feedback loop is described. Emphasis is on the application of a general design technique embodying a "design-analyze-measure iteration loop," in which a first-cut design and analysis is corrected ard improved after experimental observation of discrepancies and deficiencies. In particular, an incipient high-frequency oscillation was thereby reliably eliminated. It is demonstrated that analysis techniques involving a minimum of algebra can provide full quantitative information on an efficient and reliable system design.     

ATC Beacon Interference Characteristics in the New York Area

An experimental program is described that had the objective of measuring the effects of the time-dependent structure of downlink (air craft to ground) interference generated by the Air Traffic Control Radar Beacon System (ATCRBS) in an active air traffic terminal area that are relevant to system and ground controller response time. The results of this program indicate a number of interesting details concerning the correlation of the level of the downlink interference with changes in the arrival and departure rates of aircraft at the local terminal sites.     

The Local Bubble and Interstellar Material Near the Sun

The properties of interstellar matter at the Sun are regulated by our location with respect to a void in the local matter distribution, known as the Local Bubble. The Local Bubble (LB) is bounded by associations of massive stars and fossil supernovae that have disrupted dense interstellar matter (ISM), driving low density intermediate velocity ISM into the void. The Sun appears to be located in one of these flows of low density material. This nearby interstellar matter, dubbed the Local Fluff, has a bulk velocity of ∼19 km s⁻¹ in the local standard of rest. The flow is coming from the direction of the gas and dust ring formed where the Loop I supernova remnant merges into the LB. Optical polarization data suggest that the local interstellar magnetic field lines are draped over the heliosphere. A longstanding discrepancy between the high thermal pressure of plasma filling the LB and low thermal pressures in the embedded Local Fluff cloudlets is partially mitigated when the ram pressure component parallel to the cloudlet flow direction is included.     

Exploiting GNSS signal structure to enhance observability

There are a number of different error sources, such as multipath and thermal noise, which corrupt satellite navigation waveforms from their theoretical structure. However, even under ideal conditions the broadcast signals have some degree of deformation as a result of the practical individual hardware implementation. For the most demanding users of satellite navigation, such as aircraft navigation and landing systems, it is important to characterize the nominal signal structure in order to detect minimal variations resulting from hardware-based errors. Thus far such precorrelation Global Navigation Satellite System (GNSS) signal quality monitoring has been performed through high gain antennas, which allow for raising the GNSS spectrum above the thermal noise floor and observing the structure of the signal directly at the front end output. This paper describes a new approach to achieve such observability based on signal processing techniques, such as dithering and averaging, which leverage the repetitive nature of the GNSS signal. The paper presents how these techniques can drastically improve the signal-to-noise ratio (SNR) in postprocessing, allowing for the direct analysis of GNSS signals using traditional front end designs and conventional antennas. Results are predicted using the appropriate theory and validated using data collected from the Global Positioning System (GPS).     

Search radar detection and track with the Hough transform. II.detection statistics

For pt.I see ibid., vol.30, no.1, (Jan.1994). This paper describes the calculation of P_F and P_D for the Hough transform technique when the primary threshold crossings are weighted by their power before transforming (i.e., noncoherent integration). After expressions for P_F and P_D are derived, we examine the question of optimal granularity of the Hough accumulator space. We also investigate the relationship between primary and secondary thresholds and its effect on detectability     

Investigation of corona initiation voltage at reduced pressures

The results of an experimental study of the 60 Hz ac corona inception voltage at reduced pressures for a cylindrical conductor and a parallel ground plane are presented. Several spacings and bare and insulated conductors of several diameters are considered. Empirical expressions from which a reasonably accurate prediction of the corona inception voltage (CIV) may be made have been inferred from experimental data     

On the relation between the mass loss rate and the stellar parameters of OB-type stars

We discuss mass loss relations for OB-type stars as a function of luminosity, effective temperature, and mass. We conclude that a simple first order linear regression relation is as good as any other more sophisticated relation, with the advantage that the simple form consumes much less computer time when used in evolutionary codes.     

Multiple target tracking using products of position measurements

The continued development of the symmetric measurement equation (SME) filter for track maintenance in multiple target tracking (MTT) is considered, focusing on the case in which the SMEs are generated by forming sums of products of the original position measurements. The SME filter is developed for the case of N targets whose motions consist of random perturbations about constant-velocity trajectories. It is assumed that measurements of x-coordinate positions are available, and that the number of measurements is equal to the number of targets. Various analytical properties of the SME filter are studied. It is shown that under a very weak condition, the estimation error equation is locally exponentially stable. The performance of the SME filter is investigated by comparing it with an optimal (minimum-variance) estimator and by generating a computer simulation in the six-target case     

Light scattering in planetary atmospheres

This paper reviews scattering theory required for analysis of light reflected by planetary atmospheres. Section 1 defines the radiative quantities which are observed. Section 2 demonstrates the dependence of single-scattered radiation on the physical properties of the scatterers. Section 3 describes several methods to compute the effects of multiple scattering on the reflected light.