Self-Cohering an Airborne e Radio Camera

By distributing antenna elements or small subarrays throughout the skin of an aircraft, a large portion of the airframe can act as an electromagnetic transducer. The basic problem associated with such a design is that uncertainties in element locations due to the nonrigidness of the airframe induce phase errors. Self-cohering techniques are required to compensate for those errors. Four such techniques are presented here.     

Detection in correlated Gaussian plus impulsive noise

A detector which is designed to operate in a correlated Gaussian-plus-impulsive-noise environment is presented. The detector whitens the data robustly and then uses a two-sided threshold test to determine the presence of impulsive samples. The impulsive samples are discarded, and the remaining samples are used to detect the presence or absence of a signal using a matched filter. An approximate analysis is presented, and simulations are used to demonstrate the effectiveness of this approach     

Neutral points on the boundary of the closed magnetosphere

Theoretical studies of a field-free plasma incident upon a magnetic dipole lead to a closed magnetosphere with two neutral points in the noon magnetic meridian, at a latitude of ± 70°–75° and a geocentric distance of approximately 10 R_E. The position of the neutral points with respect to the dipole axis is not greatly affected by the angle of incidence of the solar wind. Although the field magnitude near the neutral points is only a fraction of the dipole field, the direction is seen to reverse on opposite sides of the neutral point. Near the boundary the field direction is parallel to the boundary and tends to point towards the neutral point in the Northern hemisphere.     

Theory of Scalloping Amplitude Errors in Standard VOR Bearing Indications

A rigorous theory is developed for the course scalloping amplitudes observed in the bearing indications of an airborne standard VOR receiver in the presence of multipath signals. The VOR transmitting antenna pattern characteristics, the scattering properties of the multipath source, and the effects of ground reflection are all built into the theory so that their combined effects on the scalloping may be quantitatively investigated. The analysis assumes that the VOR receiver characteristics are ideal.     

Boresight Corection Using Unlocated Targets

Boresight correction on detected but unlocated targets may be made if a bearing (whose error is unknown) is repeated on two seeker headings and another bearing is repeated on two seeker headings, or if bearing is repeated on three seeker headings. The assumption is made that seeker position and heading are known. The procedure is effective either with the above or with the combination of restricted seeker travel and intermittent target detection.     

Magnetospheric Models and Trajectory Computations

The calculation of particle trajectories in the Earth's magnetic field has been a subject of interest since the time of Störmer. The fundamental problem is that the trajectory-tracing process involves using mathematical equations that have `no solution in closed form'. This difficulty has forced researchers to use the `brute force' technique of numerical integration of many individual trajectories to ascertain the behavior of trajectory families or groups. As the power of computers has improved over the decades, the numerical integration procedure has grown more tractable and while the problem is still formidable, thousands of trajectories can be computed without the expenditure of excessive resources. As particle trajectories are computed and the characteristics analyzed we can determine the cutoff rigidity of a specific location and viewing direction and direction and deduce the direction in space of various cosmic ray anisotropies. Unfortunately, cutoff rigidities are not simple parameters due to the chaotic behavior of the cosmic-ray trajectories in the cosmic ray penumbral region. As the computational problem becomes more manageable, there is still the issue of the accuracy of the magnetic field models. Over the decades, magnetic field models of increasing complexity have been developed and utilized. The accuracy of trajectory calculations employing contemporary magnetic field models is sufficient that cosmic ray experiments can be designed on the basis of trajectory calculations. However, the Earth's magnetosphere is dynamic and the most widely used magnetospheric models currently available are static. This means that the greatest uncertainly in the application of charged particle trajectories occurs at low energies.     

The Calculation of Frequency-Modulation Distortion in Linear Networks

A numerical method is developed for the calculation of steady-state FM distortion in a linear passive network from the character of the FM signal input and the steady-state transfer characteristics of the network. The method of calculating FM distortion requires the solution of a finite set of linear equations which is accomplished readily by a digital computer. To illustrate the use of the method, the FM distortion introduced by a Chebyshev-response bandpass filter is calculated for a range of network and input signal parameters.     

A Closely Regulated TWT Converter

The design concept for the traveling wave tube amplifier converter for possible use in the Thermoelectric Outer Planet Spacecraft (TOPS) is presented. An unusual combination of semiconductors and magnetics were utilized to achieve very stable voltage regulation on a number of separate outputs to satisfy the requirements of a high-power traveling wave tube (TWT), and at the same time operate at an efficiency of better than 90 percent from a 30-volt source. The circuitry consists of an output filter, an auxiliary Jensen oscillator driving a high-reactance transformer to provide current limiting to the heater, a variable time delay, a main Jensen oscillator driving the power transformer with a maximum step-up ratio of 120 to 1, and series transistorized post regulators to provide precise voltage adjustment and low output impedance. This paper discusses the design of the high-reactance transformer and the high step-up ratio transformer, as well as the high-voltage series regulators that are limited in range and operate at the top of the unregulated output voltage. Test data is presented, and details of current transients caused by charging the filter circuits, input current ripple, and output voltage ripples are considered. The circuit provides better than 0.5 percent regulation against load change, input voltage change, and over-operating temperature range of from -20 to + 80°C, with output ripple voltage of less than 2 volts peak-to-peak on top of the 3600-Vdc output. The measured efficiency was typically 87 percent. and recommendations are included to improve this to in excess of 90 percent.     

On-Line Computer for Transient Turbine Cascade Instrumentation

A 32-channel computer based data acquisition and processing system em has been developed for use with the new type of transient cascade facility at Oxford. This is used for testing turbine blades and nozzle guide vanes at full-scale engine Reynolds and Mach numbers ers with correct wallto-flow temperature ratios. A novel technique for processing transient heat transfer data from thin film surface resistance thermometers has been developed. Measurements of surface ace pressure around blades, and of the upstream turbulence level have been made. The cascade and instrumentation are shown to have advantages both in cost and effectiveness over continuous running cascades.