Measurement of middle atmospheric ozone density profile by rocket-borne radiometer onboard KSR-II

KSR-II, a two-stage sounding rocket of KARI was launched successfully at the Korean Peninsula on June 11, 1998. The apogee of the rocket was 137 km. For the ozone measurement, 8-channel UV and visible radiometers were onboard the rocket. The rocket measured an in situ stratospheric and mesospheric ozone density profile over Korea during its ascending phase using the radiometer and transmitted the data to ground station in real time. The maximum ozone density occurs near 25 km. Retrieved profile has a random error (1σ) of approximately 15% for altitude below 20km, 7% between 20-50 km and 10% greater than 50 km. The retrieved data were compared with Dobson spectrophotometer, ozonesonde, and HALOE onboard the UARS. Our results are in reasonable agreements with others.     

“自准”赝像及识别

置平面镜于凸透镜后,则凸透镜前焦平面上的物成像于该物平面上,即“自准”成像.满足其它条件也能成像于物平面.分析不同条件下像的形成及其特点,并给出识别自准成像的判据.     

Optimal load distribution for tree network processors

A tree network consisting of communicating processors is considered. The objective is to minimize the processing time by distributing the processing load to other nodes. The effect of the order of load distribution on the processing time is addressed. An algorithm which optimally determines the order of load distribution is developed. It is shown that the order depends only on the channel capacity between nodes but not on the computing capability of each node     

某型客车噪声源的测试与研究

本文通过对某型客车的噪声测试分析，识别出该型客车的主要噪声源，为进一步采取有效的降噪措施提供了必要依据。     

Analysis of solar degradation to TDRS S-band phased array antenna

A study of the distribution of gain-to-noise-temperature (G/T) values for the Tracking and Data Relay Satellite (TDRS) satellite is described. The statistics of the G/T values are determined by a Monte Carlo simulation of the orbital geometry of the Sun and Moon, and the gain and noise temperature calculations is included. The results and their underlying assumptions are described     

基于容差分配的直升机多约束运动系统的应用与研究

本文以某民用直升机动力舱多约束运动系统的容差分配设计为例,阐述和分析了多约束运动系统容差基准的选取、分配以及设计补偿等。可以为多约束运动系统设计提供方法和参考。     

Performance characteristics of silver catalyst bed for hydrogen peroxide

Hydrogen peroxide as a monopropellant and an oxidizer has been used for well over 60 years. Although much public information has been known on the silver catalyst and its characteristics there is a dearth of specific information on the design of catalyst bed based on silver screen. In this paper activation method that can be adopted easily on silver catalyst is contrived. The experiment data and evaluation results from the fire tests with five catalyst beds are presented including the efficiency of characteristic exhaust velocity, pressure drop at catalyst. A scheme of catalyst arrangement is presented for high concentrated hydrogen peroxide.     

基于环形切割器的串联战斗部隔爆结构的优选

硬质聚氨酯具有刚度小、材质松散、易于吸收爆炸能量的特点,是一种很好的隔爆材料。为了设计环形切割器与后级随进战斗部之间的隔爆装置,利用LS-DYNA分别进行了圆柱型、圆锥型、球缺型3种聚氨酯隔爆体的数值模拟研究。通过研究得出结论:球缺型结构既节省材料,又可以更有效地降低前级产生的冲击波对后级战斗部的影响。该结论有助于带环形切割器串联战斗部的隔爆设计。     

民用飞机不同商载配置对机身着陆载荷的影响分析

重量分布和重心位置是影响起落架和机体地面载荷的重要因素,其中商载是影响全机重心、惯量的最活跃因素。飞机实际运营中,有无穷多种商载分布及装载方案。为了确保机身载荷分析时,不遗漏严重设计情况,同时能大大减少载荷人员的工作量,本文对不同商载配置下的机身着陆载荷进行了研究分析,分析结果表明最大商载情况将构成机身垂直剪力和垂直弯矩的严重情况。因此,在进行机身载荷分析时,必须考虑最大商载情况,而最大燃油情况可以不必考虑。这一结论为今后有针对性的开展民机机身载荷分析提供了数据支持。     

对K8飞机外贸出口工作的几点思考

简要论述了K8飞机外贸出口所处的内、外部环境,在此基础上进行SWOT分析,并据此提出该飞机外贸出口工作中应采取的几项措施。