复合材料三角形层板稳定性分析与实验研究

 给出了正交异性三角形简支板和固支板临界载荷的计算方法。对5种不同铺层的14块碳/环氧层板进行了稳定性实验研究。理论预测与实验结果基本一致。     

用光散射效应分析激波管内膨胀率对水蒸气成核与凝结的影响

用多重光散射法对水蒸气在激波管中的自发成核凝结过程进行了实验研究，分析了膨胀率对成核率和凝结过程的影响。根据理论计算和实测数据结果，所得结论是：膨胀率增大。会造成过饱和度、成核率、凝结质量份额和液滴生长率相应地增大。     

TC4钛合金紧固件孔E-I强化研究

 介绍TC4(Ti-6Al-4V)钛合金螺栓孔无衬套冷胀孔干涉配合综合强化的研究结果。实验证明,在给定的条件下,冷胀孔强化的TC4板状空孔试件的疲劳寿命增益系数(LIF)为13,干涉配合螺栓连接的LIF=3,而E-l强化件的疲劳寿命比单纯干涉配合又有成倍提高。电镜断口分析表明TC4合金强化件的疲劳裂纹的形成和扩展与LY12CZ及30CrMnSiA相似,它们不表现为典型的角裂纹,即沿板平面和厚向扩展速率有明显差异。对于TC4合金,在改善疲劳品质上,带衬套冷胀孔强化比无衬套冷胀孔强化好得多。     

再入飞行器高超声速绕流的一步和二步有限元计算

本文针对再入飞行器的空气动力问题，采用一步和二步有限元格式求解可缩守恒型Ｅｕｌｅｒ方程，并结合不同的人工粘性模型来捕捉激波，给出了高超声速二维钝头绕流的结果。     

关于大行星（或月球）轨道器的冻结轨道

关于人造地球卫星的冻结轨道问题早已为人们所熟知，而且已有相应的卫星在轨运行。在考虑该冻结轨道形成时，主要依据地球扁率J3项与J2项的相对关系，这是由地球非球形引力场的特征所决定的，原理十分清楚，但其原理和结论不能随意地用于其他大行星(或月球)的轨道器。在一般情况下，对于低轨卫星形成冻结轨道的条件，非球形引力位中的奇次带谐项(J21 1，l≥1)将起重要作用。不仅仅是一个J3项，例如月球轨道器，J3，J5，J7和J9均有不可忽视的影响，而且与轨道倾角有一定的关系。为此，本文根据轨道理论对冻结轨道的存在性及其有关问题作进一步的分析，给将来的深空探测提供轨道设计的有关信息和依据。     

一种新颖的瞬时浮点放大器

介绍了瞬时浮点放大器的原理及构成，并给出一种结构新的具有２５６阶的瞬时浮点放大器，可有效地提高数据采集系统的测量范围。     

A three-dimensional plasma and energetic particle investigation for the wind spacecraft

This instrument is designed to make measurements of the full three-dimensional distribution of suprathermal electrons and ions from solar wind plasma to low energy cosmic rays, with high sensitivity, wide dynamic range, good energy and angular resolution, and high time resolution. The primary scientific goals are to explore the suprathermal particle population between the solar wind and low energy cosmic rays, to study particle accleration and transport and wave-particle interactions, and to monitor particle input to and output from the Earth's magnetosphere.Three arrays, each consisting of a pair of double-ended semi-conductor telescopes each with two or three closely sandwiched passivated ion implanted silicon detectors, measure electrons and ions above 20 keV. One side of each telescope is covered with a thin foil which absorbs ions below 400 keV, while on the other side the incoming <400 keV electrons are swept away by a magnet so electrons and ions are cleanly separated. Higher energy electrons (up to 1 MeV) and ions (up to 11 MeV) are identified by the two double-ended telescopes which have a third detector. The telescopes provide energy resolution of E/E0.3 and angular resolution of 22.5°×36°, and full 4 steradian coverage in one spin (3 s).Top-hat symmetrical spherical section electrostatic analyzers with microchannel plate detectors are used to measure ions and electrons from 3 eV to 30 keV. All these analyzers have either 180° or 360° fields of view in a plane, E/E0.2, and angular resolution varying from 5.6° (near the ecliptic) to 22.5°. Full 4 steradian coverage can be obtained in one-half or one spin. A large and a small geometric factor analyzer measure ions over the wide flux range from quiet-time suprathermal levels to intense solar wind fluxes. Similarly two analyzers are used to cover the wide range of electron fluxes. Moments of the electron and ion distributions are computed on board.In addition, a Fast Particle Correlator combines electron data from the high sensitivity electron analyzer with plasma wave data from the WAVE experiment (Bougeretet al., in this volume) to study wave-particle interactions on fast time scales. The large geometric factor electron analyzer has electrostatic deflectors to steer the field of view and follow the magnetic field to enhance the correlation measurements.     

超长大直径钻孔灌注桩桩端承载力研究

阐述了超长大直径钻孔灌注桩桩端承载力的影响因素,包括施工工艺、深度效应和尺寸效应等。分析和对比了目前国内常用的各规范所采用的计算方法。文中算例的计算结果表明,对于同等条件的桩,各规范的计算结果相差较大。采用自平衡试桩法获得了几个重大工程的超长大直径钻孔灌注桩的桩端承载力的实测值。将工程实例的测试结果与各规范的计算结果进行对比,证实了目前规范的计算方法不尽合理。目前各规范中桩端承载力的计算方法是在针对小直径的中短桩的研究基础上建立的。如今,大型桥梁工程中普遍采用超长大直径钻孔灌注桩的情况下,对其桩端承载力的计算应当进行相应的调整,使设计更为合理。     

铸造SiCp／ZL101复合材料的组织与性能

本文利用半固态搅拌铸造法制备了ＳｉＣｐ／ＺＬ１０１复合材料，对其组织和某些性能进行了研究，结果表明：ＳｉＣｐ在基体中分布均匀，无严重团聚现象，与基体结合良好，与基体合金相比，耐磨性，硬度有显著提高。