Frequency fluctuations of coherent signals from spacecraft observed during dual-frequency radio sounding of the circumsolar plasma in 2004–2008

We have performed spectral processing of the data of experiments on radio sounding of circumsolar plasma by coherent S- and X-band signals from the spacecraft Ulysses, Mars Express, Rosetta, and Venus Express carried out from 1991 to 2009. The experiments were realized in the mode of coherent response, when a signal stabilized by the hydrogen standard is transmitted from the ground station to a spacecraft, received by the onboard systems, and retransmitted to the Earth with conserved coherence. Thus, the signal sounding the coronal plasma passes twice through the medium: on the propagation path ground station — spacecraft and on the same path in the opposite direction. The spectra of frequency fluctuations in both the bands are obtained and, using them, the radial dependences of fluctuation intensities are found, which can be approximated by a power law. It is shown that the ratio of intensities of frequency fluctuations in the S- and X-bands is comparable with the theoretical value and characterizes the degree of correlation of irregularities of the electron density along the propagation path ground station — spacecraft and back. Analysis of the correlation of frequency fluctuations on the two paths allows one to get a lower estimate of the outer scale of the circumsolar plasma turbulence. For heliocentric distances R = 10 solar radii (R _S ) the outer scale is larger than 0.25R _S .     

Mercury’s Weather-Beaten Surface: Understanding Mercury in the Context of Lunar and Asteroidal Space Weathering Studies

Mercury’s regolith, derived from the crustal bedrock, has been altered by a set of space weathering processes. Before we can interpret crustal composition, it is necessary to understand the nature of these surface alterations. The processes that space weather the surface are the same as those that form Mercury’s exosphere (micrometeoroid flux and solar wind interactions) and are moderated by the local space environment and the presence of a global magnetic field. To comprehend how space weathering acts on Mercury’s regolith, an understanding is needed of how contributing processes act as an interactive system. As no direct information (e.g., from returned samples) is available about how the system of space weathering affects Mercury’s regolith, we use as a basis for comparison the current understanding of these same processes on lunar and asteroidal regoliths as well as laboratory simulations. These comparisons suggest that Mercury’s regolith is overturned more frequently (though the characteristic surface time for a grain is unknown even relative to the lunar case), more than an order of magnitude more melt and vapor per unit time and unit area is produced by impact processes than on the Moon (creating a higher glass content via grain coatings and agglutinates), the degree of surface irradiation is comparable to or greater than that on the Moon, and photon irradiation is up to an order of magnitude greater (creating amorphous grain rims, chemically reducing the upper layers of grains to produce nanometer-scale particles of metallic iron, and depleting surface grains in volatile elements and alkali metals). The processes that chemically reduce the surface and produce nanometer-scale particles on Mercury are suggested to be more effective than similar processes on the Moon. Estimated abundances of nanometer-scale particles can account for Mercury’s dark surface relative to that of the Moon without requiring macroscopic grains of opaque minerals. The presence of nanometer-scale particles may also account for Mercury’s relatively featureless visible–near-infrared reflectance spectra. Characteristics of material returned from asteroid 25143 Itokawa demonstrate that this nanometer-scale material need not be pure iron, raising the possibility that the nanometer-scale material on Mercury may have a composition different from iron metal [such as (Fe,Mg)S]. The expected depletion of volatiles and particularly alkali metals from solar-wind interaction processes are inconsistent with the detection of sodium, potassium, and sulfur within the regolith. One plausible explanation invokes a larger fine fraction (grain size <45 μm) and more radiation-damaged grains than in the lunar surface material to create a regolith that is a more efficient reservoir for these volatiles. By this view the volatile elements detected are present not only within the grain structures, but also as adsorbates within the regolith and deposits on the surfaces of the regolith grains. The comparisons with findings from the Moon and asteroids provide a basis for predicting how compositional modifications induced by space weathering have affected Mercury’s surface composition.     

Advanced materials for next generation NiMH portable, HEV and EVbatteries

While Ovonic NiMH batteries are already in high volume commercial production for portable applications, advances in materials technology have enabled performance improvements in specific energy (100 Wh/kg), specific power (600-1000 W/kg), high temperature operation, charge retention, and voltage stability. Concurrent with technology advances, Ovonic NiMH batteries have established performance and commercial milestones in electric vehicles, hybrid electric vehicles, as well as scooter, motorcycle and bicycle applications. As important as these advances, significant manufacturing cost reductions have also occurred which allow continued growth of NiMH technology. In this paper, advances in performance, applications and cost reduction are discussed with particular emphasis on the improved proprietary metal hydride and nickel hydroxide materials that make such advances possible     

Influence of microgravity on mitogen binding and cytoskeleton in Jurkat cells.

The effects of microgravity on Jurkat cells--a T-lymphoid cell line--was studied on a sounding rocket flight. An automated pre-programmed instrument permitted the injection of fluorescent labelled concanavalin A (Con A), culture medium and/or fixative at given times. An in-flight 1 g centrifuge allowed the comparison of the data obtained in microgravity with a 1 g control having the same history related to launch and re-entry. After flight, the cells fixed either at the onset of microgravity or after a or 12 minute incubation time with fluorescent concanavalin A were labelled for vimentin and actin and analysed by fluorescence microscopy. Binding of Con A to Jurkat cells is not influenced by microgravity, whereas patching of the Con A receptors is significantly lower. A significant higher number of cells show changes in the structure of vimentin in microgravity. Most evident is the appearance of large bundles, significantly increased in the microgravity samples. No changes are found in the structure of actin and in the colocalisation of actin on the inner side of the cell membrane with the Con A receptors after binding of the mitogen.     

Reducing Undesirable Effects in the Human Centrifuge

The human centrifuge is used to train pilots and astronauts for flights where they are subject to large accelerations. This paper deals with the problems of simulating such linear accelerations with a rotating device and presents suitable means of reducing undesirable simulation error. The advantages of using three gimbals rather than the usual two are considered. Numerical results illustrate the problems of simulation and the improvement achieved by the use of a third gimbal.     

Controlled Flight Into Terrain and the enhanced Ground ProximityWarning system

The leading cause of worldwide aviation fatalities comes from inadvertently flying a perfectly operating aircraft into the ground or water. This type of accident is referred to as Controlled Flight Into Terrain (CFIT). Statistics show that introduction of the Ground Proximity Warning System (GPWS) into the scheduled air carrier turbojet fleet has been accompanied by a dramatic drop in the frequency of CFIT accidents. Training aids, videos, checklists, and procedural recommendations have also been produced to aid in CFIT risk reduction. Despite these actions, CFIT worldwide losses continue. Common characteristics of these continued accidents are a lack of installed GPWS or shortcomings of the current GPWS detection algorithms. The Enhanced Ground Proximity Warning Systems have been developed to address these shortcomings, and to provide enhanced situational awareness to the pilots such that CFIT accidents can become a thing of the past     

Signal transduction in T lymphocytes--a comparison of the data from space, the free fall machine and the random positioning machine.

In this paper we discuss the effect of microgravity on T cells and we present the data of studies with two new machines for 0 g simulations. Several experiments in space show that mitogenic T cell activation is lost at 0 g. Immunocytochemistry indicates that such effect is associated with changes of the cytoskeleton. Biochemical studies suggest that the lack of expression of the interleukin-2 receptor is one of the major causes of the loss of activity. In fact, interleukin-2 is the third signal required for full activation. In order to deepen our investigations we are now working with the free-fall machine, FFM, invented by D. Mesland, and with the random positioning machine, RPM, or three-dimensional clinostat, developed by T. Hoson. The FFM produces periods of free-fall lasting approximately 800 ms followed by bounces of 15-30 g lasting 45-60 ms. The RPM eliminates the effect of gravity by rotating biological specimen randomly around two orthogonal axes. While the FFM failed to reproduce the results obtained with T lymphocytes in space, the data from the RPM are in good agreement with those in real microgravity. In fact, the inhibition of the mitotic index in the RPM is 89% compared to static controls. The RPM (as the FFM) can carry markedly larger specimen than the fast rotating clinostat and thus allows to conduct comprehensive studies to select suitable biological objects for further investigations in space.     

Ultra-reliable real-time control systems-future trends

Today's aircraft use ultra-reliable real-time controls for demanding functions such as Fly-By-Wire (FBW) flight control. Future aircraft, spacecraft and other vehicles will require greater use of these types of controls for functions that currently are allowed to fail, fail to degraded operation, or require human intervention in response to failure. Fully automated and autonomous functions will require ultra-reliable control. But ultra-reliable systems are very expensive to design and require large amounts of on-board equipment. This paper will discuss how the use of low-cost sensors with digital outputs, digitally commanded fault-tolerant actuation devices and interconnecting networks of low-cost data buses offer the promise of more affordable ultra-reliable systems. Specific technologies and concepts to be discussed include low-cost automotive and industrial data buses, “smart” actuation devices with integral fault masking capabilities, management of redundant sensors, and the fault detection and diagnosis of the data network. The advantages of integrating the control and distribution of electrical power with the control system will be illustrated. The design, installation, and upgrade flexibility benefits provided by an all-digital and shared network approach will be presented. The economic benefits of systems that can operate following failure and without immediate repair will be reviewed. The inherent ability of these redundant systems to provide effective built-in test and self-diagnostics capabilities will be described. The challenges associated with developing ultra-reliable software for these systems and the difficulties associated with exhaustive verification testing will be presented as will additional development hurdles that must be overcome     

Protein crystal growth--microgravity aspects.

Protein crystals, grown under reduced gravity conditions, are either superior or inferior in their structural perfection than their Earth-grown counterparts. A reduction of the crystals' quality due to low-gravity effects on the growth processes cannot be understood from existing models. In this paper we put forth a rationale which predicts either advantages or disadvantages of microgravity growth. This rationale is based on the changes in the effective solute and impurity supply rates in microgravity and their effects on the intrinsic growth rate fluctuations that arise from the coupling of bulk transport to nonlinear interfacial kinetics and cause severe inhomogeneities. Depending on the specific diffusivity and kinetic coefficient of a protein and the impurities in the solution, either transport enhancement through forced flow or transport suppression under reduced gravity can result in a reduction of the kinetic fluctuations and, thus, growth with higher structural perfection. Investigating this mechanism of microgravity effects, we first demonstrate a one-to-one correspondence between these fluctuations, that are due to the bunching of growth steps, and the formation of defects in the crystals. We have confirmed the forced flow aspects of this rationale in ground-based experiments with lysozyme utilizing flowing solutions with varying, well characterized impurity contents.