The Segmented Aperture Synthetic Aperture Radar (SASAR)

A new concept in synthetic aperture radar, called SASAR, which uses a segmented aperture, is described. Use of the segmented aperture allows appreciable extra receiving antenna gain to be realized. Each subarray of the receive antenna is equal in length to the transmit antenna; the system performance is increased approximately by a factor equal to the number of subarrays. To allow array combination of the subarray signal outputs requires a phase-shift factor (varying with azimuth) to be applied to each subarray signal. A digital implementation of this preprocessor is sketched out; it uses a push-down storage stack to store the range histories for a synthetic aperture from each subarray. Appropriate phase shifts are added to the stacks and a sum of stack values then provides the combined output range history sequence. Possibilities of using analog delay lines for preprocessing are also discussed. Pattern errors due to subarray size and receive array near field are examined and constraints are given.     

Software replacement of test module adapters for depot instrumentation due to obsolescence

Depot-level automatic test equipment has been used over the years by various facets of both the government and commercial industry. Over time, the instrumentation used in the depot will need to be repaired or replaced and, oftentimes, the older instruments are no longer serviceable or manufactured. This paper discusses how to replace the obsolete instrument and its associated hardware. Test module adapter with a software module and driver that allows compatibility between the original test executive and the modern instrument without re-hosting existing test program sets. Systems & Electronics, Inc. has implemented this procedure for a digitizer and precision DC power supply on a depot that utilizes the IEEE-488 general purpose interface bus (GPIB) for communication between the control computer and instrumentation.     

On the fundamental acoustic mode in variable area,low Mach number nozzles

We consider the propagation of sound in nozzles of substantially varying cross-section, taking into account reflections from the tapering walls and non-uniform convection by the axially accelerated or decelerated mean flow. Exact solutions of the acoustic equations are obtained for the simplest case of the fundamental longitudinal mode in quasi-one-dimensional, low Mach number nozzle flow. The effects of non-uniform mean flow on sound are demonstrated by comparing horns with nozzles, and 15 properties (stated in italics and labelled P1, P2 ... P15 in the text) are proved and discussed, viz. concerning (1) relations between acoustic pressure and velocity; (2) equipartition or biasing of kinetic and compression energies; (3) conservation or evolution of wave action; (4) existence of elementary or special solutions and (5) cut-off frequencies, and amplitude and phase laws. We conclude with a simple formula for the approximate calculation of the acoustic fields; the formula can be made more accurate by using a correction factor for amplitude and phase, which is plotted against area ratio for propagation upstream or downstream in diffusers and convergent nozzles.     

Cloudiness over the Eastern Equatorial Pacific for summer 1983 from geostationary satellite data

The extraordinary El-Nino event of 1982–83 started to fade out in the late spring of 1983. However the sea surface temperature of the Eastern Equatorial Pacific still remained warmer than normal in the following summer. To investigate the characteristics of this late transition phase of the 1982–83 El-Nino, the GOES-West satellite data of July and August of 1983 are analyzed. The outgoing longwave radiation field and the distribution of cloudiness, which was derived by using a new threshold technique, are obtained. The longwave radiation field is compared to monthly average climatic indices commonly used at the Climatic Analysis Center. The results of cloud analysis showed some interesting features during the decaying phase of the 1982–83 El-Nino. The diurnal variation of cloudiness indicates that total cloud amounts decrease from 8 GMT to 20 GMT over most of the area. This overall study demonstrates preliminary results of the International Satellite Cloud Climatology Project of the World Climate Research Program.     

Identification Techniques for SARSAT Signals

A process for the identification of emergency locator transmitter (ELT) signals related to search and rescue satellite-aided tracking (SARSAT) is presented. The ELT identification process is particularly important in order to increase the probability of detection and eliminate sources of interference from the data set. A set of ELT signal parameters is introduced and methods for estimating these parameters are developed. A theoretical analysis and performance evaluation of these methods is provided.     

Utilization of white potatoes in CELSS.

Potatoes (Solanum tuberosum) have a strong potential as a useful crop species in a functioning CELSS. The cultivar Denali has produced 37.5 g m-2 d-1 when grown for 132 days with the first 40 days under a 12-h photoperiod and a light:dark temperature cycle of 20 degrees C:16 degrees C, and then 92 days under continuous irradiance and a temperature of 16 degrees C. Irradiance was at 725 micromoles m-2 s-1 PPF and carbon dioxide at 1000 micromoles mol-1. The dried tubers had 82% carbohydrates, 9% protein and 0.6% fat. Other studies have shown that carbon dioxide supplementation (1000 micromoles mol-1) is of significant benefit under 12-h irradiance but less benefit under 24 h irradiance. Irradiance cycles of 60 minutes light and 30 minutes dark caused a reduction of more than 50% in tuber weight compared to cycles of 16 h light and 8 h dark. A diurnal temperature change of 22 degrees C for the 12-h light period to 14 degrees C during the 12-h dark period gave increased yields of 30% and 10% for two separate cultivars, compared with plants grown under a constant 18 degrees C temperature. Cultivar screening under continuous irradiance and elevated temperatures (28 degrees C) for 8 weeks of growth indicated that the cvs Haig, Denali, Atlantic, Desiree and Rutt had the best potential for tolerance to these conditions. Harvesting of tubers from plants at weekly intervals, beginning at 8 weeks after planting, did not increase yield over a single final harvest. Spacing of plants on 0.055 centers produced greater yield per m2 than spacing at 0.11 or 0.22 m2. Plants maintained 0.33 meters apart (0.111 m2 per plant) in beds produced the same yields when separated by dividers in the root matrix as when no separation was made.     

Subcritical and supercritical water oxidation of CELSS model wastes.

Controlled-Ecological-Life-Support-System (CELSS) model wastes were wet-oxidized at temperatures from 250 to 500 degrees C, i.e., below and above the critical point of water (374 degrees C and 218 kg/cm2 or 21.4 MPa). A solution of ammonium hydroxide and acetic acid and a slurry of human urine, feces, and wipes were used as model wastes. Almost all of the organic matter in the model wastes was oxidized in the temperature range from 400 to 500 degrees C, i.e., above the critical conditions for water. In contrast, only a small portion of the organic matter was oxidized at subcritical conditions. Although the extent of nitrogen oxidation to nitrous oxide (N2O) and/or nitrogen gas (N2) increased with reaction temperature, most of the nitrogen was retained in solution as ammonia near 400 degrees C. This important finding suggests that most of the nitrogen in the waste feed can be retained in solution as ammonia during oxidation at low supercritical temperatures and be subsequently used as a nitrogen source for plants in a CELSS while at the same time organic matter is almost completely oxidized to carbon dioxide and water. It was also found in this study the Hastelloy C-276 alloy reactor corroded during waste oxidation. The rate of corrosion was lower above than below the critical temperature for water.     

Testing the Stability of the Fine Structure Constant in the Laboratory

In this review we discuss the progress of the past decade in testing for a possible temporal variation of the fine structure constant α. Advances in atomic sample preparation, laser spectroscopy and optical frequency measurements led to rapid reduction of measurement uncertainties. Eventually laboratory tests became the most sensitive tool to detect a possible variation of α at the present epoch. We explain the methods and technologies that helped to make this possible.     

Improved Accuracy Metallic Resonator CVG

Metallic resonator Q-factor is very sensitive to the resonator's material, its thermal and chemical treatment, design, and environment; i.e., pressure and temperature. In order to obtain higher accuracy for CVG it is necessary to use resonator evacuation. Resonator mass plays a very important role in sensitivity to angle rate, in stability of vibration, in response to environmental condition changes, and also to external vibration and shock resistance. tnnalabs Holding Inc. uses a cylindrical resonator with increased rim thickness of up to 2 mmn and more. This concerns resonator material and design parameters selection, material thermal treatment to increase resonator Q-factor, and improved control algorithms in order to increase metallic CVG accuracy. As a result, CVG bias instability of 0.025 degth and random walk of 0.008 degvh for the resonator diameter 43 mmn, and 0.2 deg/h for the resonator diameter 25 mm were obtained. Future opportunities for Innalabs CVG is also discussed herein. Test results are presented for CVG43 and CVG25. Three-axis CVG unit under control of one DSP "Sharc" and IMU parameters are forecasted.     

Biogenerated Rock Structures

Earth as a planet under firm control of life processes since more than 3 Ga has evolved global biogeochemical cycles, biogeomorphogenetic processes and structures also called plates or global tectonics including global climate and movement of water masses. These processes have deep impact on the shape and thickness of continental land masses as well as the chemistry and mineralogy of the crust and upper mantle. Biogenerated rock structures in this sense can be visualised through the analysis of sedimentary rock structures exhibiting e.g., biogenerated stromatolites, onkolites, oolites or cementing structures of sandstones which clearly preserve biochemical processes and biophysical structures. Further the chemical composition including the segregation of mineral layers, ore deposits, sedimentary and metamorphic rocks and granites hint to sun powered energy storage (gas, gas hydrates, hydrocarbons, coal) and tectonic processes initiated or at least modified through the enormous input of external energy through reduced carbon and iron compounds. One can state with considerable reliability that a planet under control of life must exhibit rock chemistry, mineralogy and structures typical for the impact of life on the geodynamic cycles. This includes the idea of top-down geotectonics instead of bottom-up processes.