Periodic ambiguity function of CW signals with perfect periodicautocorrelation

A periodic ambiguity function (PAF) is discussed which describes the response of a correlation receiver to a CW signal modulated by a periodic waveform, when the reference signal in the receiver is constructed from an integral number N, of periods T, of the transmitted signal. The PAF is a generalization of the periodic autocorrelation function, to the case of non-zero Doppler shift. It is shown that the PAF of N periods is obtained by multiplying the PAF of a single period by the universal function sin(Nπν T)/N sin(πνT), where ν is the Doppler shift, to phase-modulated signals which exhibit perfect periodic autocorrelation when there is no Doppler shift. The PAF of these signals exhibits universal cuts along the delay and Doppler axes. These cuts are functions only of t, N and the number M, the modulation bits in one period     

The autocorrelation of m-sequences over nonprime finitefields

Nonbinary m-sequences (maximal length sequences) for spread-spectrum communication systems that have a two-level autocorrelation are presented. The autocorrelation function of an m -sequence over the Galois field of q elements GF(q), where q=p^k, for p a prime and k an integer greater than 1, is developed and shown to be bilevel when the elements of GF(q) are expressed as elements of a vector space over the pth roots of unity     

Optimum gain control for A/D conversion using digitized I/Q data inquadrature sampling

Calculation of optimum gain for minimum distortion due to A/D (analog-to-digital) conversion requires the estimation of the input signal strength. To use a common AGC (automatic gain control) for both the I/Q (in-phase and quadrature) signals, it is efficient to estimate the input signal strength using the quantized A/D output from both channels. Assuming a Gaussian input, the relationship between σ of the input of the A/D converter and E(|x|+|y|) and E(max(|x|,|y|)+1/2 min (|x|,|y|)) for t quantized I/Q output x and y is derived. Numerical results obtained using the derived expression and the statistical data obtained through simulation show excellent agreement. It is concluded that, because of its simplicity, the cubic equation obtained by fitting the numerical results should be useful     

Identification of rational transfer function from frequencyresponse sample

A method for identifying a transfer function, H(z)=A(z)/B(z), from its frequency response values is presented. Identifying the transfer function involves determining the unknown degrees and coefficients of the polynomials A(z) and B( z), given the frequency response samples. The method for finding the parameters of the transfer function involves solving linear simultaneous equations only. An important aspect of the method is the decoupled manner in which the polynomials A(z) and B(z) are determined. The author presents two slightly different derivations of the linear equations involved, one based on the properties of divided differences and the other using Vandermonde matrices or, equivalently, Lagrange interpolation. A matrix synthesized from the given frequency response samples is shown to have a rank equal to the number of poles in the system     

CW alternatives to the coherent pulse train-signals and processors

Continuous wave (CW) signals phase modulated by a periodic waveform, and their corresponding receivers, are discussed. The combined response in delay and Doppler is almost identical to the (ideal) response of the coherent pulse train. The receivers are matched to an integral number N of modulation periods of the transmitted signal. CW implies a duty cycle of 100%. However, the signal duration need not be longer than N+2 periods. The CW signals have the advantage that their peak power is equal to the average power. Their disadvantages are more complicated receiver processing and the need for two antennas     

A parallel square-root algorithm for modified extended Kalmanfilter

A parallel square-root algorithm and its systolic array implementation are proposed for performing modified extended Kalman filtering (MEKF). The proposed parallel square-root algorithm is designed based on the singular value decomposition (SVD) and the Faddeev algorithm, and a very large scale integration (VLSI) systolic array architecture is developed for its implementation. Compared to other square root Kalman filtering algorithms, the proposed method is more numerically stable. The VLSI architecture described has good parallel and pipelining characteristics in applying to the MEKF and achieves higher efficiency. For n-dimensional state vector estimations, the proposed architecture consists of O(2n²) processing elements and uses O ((s+17)n) time-steps for a complete iteration at each instant, in contrast to the complexity of O((s+6) n³) time-steps for a sequential implementation, where s≈log n     

Distribution of general noncentral positive definite quadratic formin K-dimensions

The authors present a series solution using Hermite polynomials to the long-standing problem of computing the probability P that positive definite noncentral quadratic form d(x) of a Gaussian random vector x∈R satisfies d( x)⩽r² for any given r∈R. This problem has wide applications in radar, tracking, air traffic control, etc. The fast-converging series solution presented is very accurate and can be performed rapidly using the recursion relations for Hermite polynomials     

Detection probabilities for correlated Rayleigh fading signals

Both the method of saddlepoint integration and its associated saddlepoint approximation are applied to calculating the probability of detecting correlated Rayleigh-fading signals in Gaussian noise by means of a detector that integrates M samples of the output of a quadratic rectifier. The quadrature components of the signal samples are modeled as an autoregressive moving-average process, and specific results are exhibited for a first-order Markov process. By these methods the fluctuation loss can be computed for much larger values of M and for larger values of the detection probability than previously. Values calculated by the saddlepoint approximation prove to be close enough to the exact values to be useful over a broad range of signal parameters     

Tracking multitarget in cluttered environment

A method for multitarget tracking and initiating tracking in a cluttered environment is proposed. The algorithm uses a sliding window of length uT (T is the sampling time) to keep the measurement sequence at time k. Instead of solving a large problem, the entire set of targets and measurements is divided into several clusters so that a number of smaller problems are solved independently. When a set of measurements is received, a new set of data-association hypotheses is formed for all the measurements lying in the validation gates within each cluster from time K-u+1 to K. The probability of each track history is computed, and, choosing the largest of these histories, the target measurement is updated with an adaptive state estimator. A covariance-matching technique is used to improve the accuracy of the adaptive state estimator. In several examples, the algorithm successfully tracks targets over a wide range of conditions     

Performance of receivers with linear detectors

The false-alarm and detection probabilities of a receiver summing M independent outputs of a linear detector are calculated by numerical saddlepoint integration. The saddlepoint approximation is also considered. Both constant-amplitude and Rayleigh-fading signals are treated, and the relative efficiency of the quadratic and the linear detectors for these is calculated for a broad range of values of M . The numerical integration method is the more efficient, the smaller the false-alarm probability or the false-dismissal probability, that is, under just those conditions for which the terms in the Gram-Charlier series oscillate most violently and the series becomes least reliable. The simpler saddlepoint approximation yields values that in those same regions have been found close enough to the exact probabilities to be adequate for most engineering purposes. The larger the number M of samples, the more efficient methods are     

Nonparametric rank detectors on quantized radar video signals

Uniform randomization of ties is required for defining distribution-free ranks of independent and identically distributed quantized samples. Formulas of rank probabilities are given and applied to radar detection under quantized video samples. For some detectors, and assuming Gaussian noise, the asymptotic loss L_∞(q) is calculated versus the normalized quantization step q, and the loss L(q) is estimated by Monte Carlo simulations. Both of these resulted in monotonic functions of q (0<q<1.1) that are independent of the other parameters. Furthermore, L(q)≈L_∞(q )⩽0.45 dB, as q<0.8. The quantization step q is normalized with respect to the noise standard deviation     

On the uniform sampling of a sinusoidal signal

It is generally accepted that a monochromatic signal such as sin 2πWt (W>0) must be sampled at a uniform rate greater than the ostensible Nyquist rate of 2W samples per to effect a reconstruction of the signal. It is shown that a sinusoid of frequency W Hz is completely determined by its samples taken at the uniform rate of 2r samples per second, where r>0 is arbitrary subject only to the restriction that W ≠kr for any positive integer k. In particular, a pure sinusoid may be sampled uniformly without loss of information at arbitrarily small rates     

Finding the best set of K paths through a trellis withapplication to multitarget tracking

A solution is presented to the problem of finding the best set of K completely unmerged paths through a trellis with M _i⩾K states at depth i in the trellis, i=0, 1, 2, . . ., N. Here, `best set' means that the sum of the metrics of all K paths in the set is minimized, and `completely unmerged' means that no two paths pass through a common state. The solution involves using the Viterbi algorithm on an expanded trellis. This result is then used to separate the tracks of K targets optimally in a simplified model of a multitarget radar system. The model includes measurement errors and false alarms, but it does not include the effects of missing detections or merged measurements     

Design of high-efficiency series-resonant converters aboveresonance

Power losses in series-resonant converters (SRCs) operated above resonance are examined for the purpose of developing design guidelines leading to SRC designs with the highest possible operating efficiencies. Loss expressions are formulated and analyzed as functions of normalized voltage conversion ratio M and normalized output current J for the controlled transistor switches, antiparallel diodes, bridge diodes, and resonant capacitor. Overall losses range from a low of nearly 9% to a maximum of about 17%. Operating efficiencies corresponding to these losses range from a high of 92% to a low of 85%. Operation at the maximum efficiency of 92% occurs at values of M close to unity and is not highly dependent on J. However, in a practical closed-loop regulated SRC, operation with M too close to unity could provide an insufficient design margin, given component tolerances or other variations     

Multiple target angle tracking using sensor array outputs

The use of the output of an array of sensors to track multiple independently moving targets is reported. The output of each sensor in the array is the sum of signals received from each of the targets. The results of direction-of-arrival estimation by eigenvalue analysis are extended to derive a recursive procedure based on a matrix quadratic equation. The solution of this matrix quadratic equation is used to provide updated target positions. A linear approximation method for estimating the solution of the matrix equation is presented. The algorithm is demonstrated by the simulated tracking of two targets. The main advantage of the algorithm is that a closed-form solution for updating the target angle estimates has been obtained. Also, its application is straightforward, and the data association problem due to uncertainty in the origin of the measurements is avoided. However, it requires the inversion of an N×N as well as other linear operations, so that the computational burden becomes substantial as N becomes very large     

SAR resolution in the presence of phase errors

The author analyzes the effects of phase errors on synthetic aperture radar (SAR). The theory is applied to the following question: how does the achievable resolution vary with the carrier frequency when optimum quadratic focus and/or optimum processing interval (synthetic aperture length) are used? Numerous related results are given, so that much of the material is tutorial. For phase errors corresponding to uncompensated motion, the best achievable RMS resolution with any phase error spectrum satisfies the derived equation. For motion-induced phase errors it is seen that resolution improves with increasing carrier frequency when the first term in the expression applies (e.g. for phase errors concentrated at low frequencies) and resolution is independent of carrier frequency when R δ/v/v is the smaller term (e.g. with broad band or high frequency phase errors)     

Detectability of signals in Laplace noise

Closed-form expressions for the false-alarm and detection probabilities attained by the optimum and the linear detectors of a positive signal in n independent samples of noise having a bilateral exponential or Laplace distribution require lengthy computation when n is large, and those for the optimum detector suffer from round-off error because their terms alternate in sign. It is shown how the method of saddlepoint integration can be conveniently applied to compute these probabilities, and numerical comparisons of the accuracies of the methods are presented. The relative efficiency of the two detectors is calculated as a function of n and found to approach the asymptotic value of 2 very slowly     

Systolic array implementation of second-order Kalman filter

The approach for design of parallel implementation of the second-order Kalman filter using systolic array processors is proposed. The original time complexity of more than 27n³ for sequential processing can be reduced to only 21n+10r-4 in the proposed parallel implementation. The improvement is gained from the utilization of interarray pipelining, concurrent processing and substitution forwarding techniques. The approach is especially suitable for real-time application of the Kalman filter in solving second-order linear system     

CCRS C/X-airborne synthetic aperture radar: An Rand D tool for the ERS-1 time frame

The airborne synthetic-aperture radar (SAR) system developed for the Canada Centre for Remote Sensing (CCRS) is described. It consists of two radars, at C-band and X-band. Each radar incorporates the following features: dual-channel receivers and dual-polarized antennas; a high quality, 7-look, real-time processor; a sensitivity time control for range-dependent gain control; a motion-compensation system for antenna steering in azimuth and elevation; and baseband I and Q signal phase rotation. The system also uses a high-power transmitter with a low-power back-up. The SAR maps to either side of the aircraft, at high or low resolution, at incidence angles which in high resolution span 0° to 80°. Radar operating parameters, data products, key specifications and the motion compensation scheme used are presented. Properties of the real-time imagery are discussed and examples of C-band SAR data in the three operating modes are given     

Adaptive canceler and pulse compressor interactions

Performance results for the sidelobe level of a compressed pulse that has been preprocessed through an adaptive canceler are obtained. The adaptive canceler is implemented using the sampled matrix inversion algorithm. Because of finite sampling, the quiescent compressed pulse sidelobe levels are degraded due to the preprocessing of the main channel input data stream (the uncompressed pulse) through an adaptive canceler. It is shown that if N is the number of input canceler channels (main and auxiliaries) and K is the number of independent samples per channel, then K/N can be significantly greater than one in order to retain sidelobes that are close to the original quiescent sidelobe level (with no adaptive canceler). Also it is shown that the maximum level of degradation is independent of whether pulse compression occurs before or after the adaptive canceler if the uncompressed pulse is completely contained within the K samples that are used to calculate the canceler weights. This same analysis can be used to predict the canceler noise power level that is induced by having the desired signal present in the canceler weight calculation