Results from a Four-Element Adaptive Antenna Experiment

Experimental results from a four-element, linear, half-wavelength spacing, adaptive-array antenna under the control of the least mean square (LMS) algorithm are presented. The array is found to be capable of nulling a 70-MHz signal to -35 dB below a desired signal over a 5-MHz bandwidth. The antenna processing gain is constant over a desired signal-to-jammer signal power ratio range from -20 dB to 5 dB. A sharp reduction in processing gain is observed for angular separations between jammer and desired signal of less than 10°. Antenna patterns taken with weights set in 300 iterations of the LMS algorithm show that the one strong, one weak jammer combination has a longer weight convergence time and reduced processing gain compared with a two strong jammers combination. Contours of constant desired signal-to-jammer signal power ratio, after adaptive antenna processing, reveal a complex shape for communication between air and ground due to the finite angular resolution of the adaptive antenna.     

Prediction of Adaptive Array Performance

A direct relationship between the conventional properties of an array and the array performance in an adaptive mode is given. Expressions are provided to obtain the output signal-to-interference-plus-noise ratio (SINR) of an adaptive array in terms of its conventinal pattern and the locations of the desired signal and jammers. These expressions permit one to evaluate the performance of an adaptive array without an exhaustive search for all possible scenarios and parametric values to ascertain that the required performance levels be met. In fact, one can predict the jammer locations for which the array will provide its best and worst performance by observing the conventional pattern. Several examples are provided to demonstrate the relationship between the conventional pattern and the adaptive array performance. The examples include both linear and planar arrays.     

The Steady-State Antenna Patterns of Adaptive Arrays

The antenna pattern of a receiving adaptive array of arbitrary three-dimensional geometry operating in an environment of K sources, one desired signal and (K - 1) jammers, is considered. It is shown that the adapted (voltage) antenna pattern of the array is a linear combination of K (or less) basis patterns, each of which is a function of one source only. We find that these basis patterns have a simple physical meaning, namely, the kth basis pattern is the pattern realized by the array when the transmission of source k is considered a desired signal and all other sources are turned off. When the array elements are isotropic, these basis patterns are retrodirective (that is, the mainlobe of the kth basis pattern points at source k). It had been shown that this property is also exhibited by a different decomposition of the adapted pattern in the special case of a single jammer (K = 2). In contrast, our decomposition which is simpler than the earlier one, yields retrodirective beams for all K. The simple, physically meaningful, pattern decomposition developed here is quite significant in the insight it provides regarding the basic underlying principles of adaptive arrays. It is also instrumental in elucidating their capabilities and limitations.     

Equivalent transformation for a partially adaptive array

A partially adaptive array is one in which elements of a phased array are controlled or adaptively weighted in groups or in which certain elements, called auxiliary elements, are made controllable. Mathematically, this type of array is formed by transforming all of the elements of an array by a nonsquare matrix such that the resulting output vector has a length less than the number of array elements. It is shown that there is an equivalent matrix transform that can effectively be utilized in analyzing the partially adaptive array's performance when a small number of external jammers are present. Processor implementation and convergence rate considerations lead to the desirability of reducing the dimensionality of the cancellation processor while maintaining good sidelobe interference protection. A meaningful measure of canceller performance is to compute the optimal output signal-to-noise ratio. This expression is a function of the jammer, direction-of-arrival vectors (DOAVs), jammer powers, the array steering vector, and internal noise. It is shown that if this expression is computed for the fully adaptive array then it is easily computed for the partially adaptive array by transforming the jammer DOAVs and the steering vector by the orthogonal projection matrix defined by the rows of the subarray transformation matrix and substituting these vectors back into the original expression for the fully adaptive array     

Adaptive processing at the subarray level

This paper describes a class of partially adaptive arrays with adaptive processing applied to the outputs of steered subarrays. The problem is to detect a signal or estimate its direction of arrival in the presence of jammers. The advantage of applying adaptive processing to subarrays is that it requires much less CPU time than the corresponding fully adaptive processing. The subarray processing equations for the two kinds of problem are described. In this paper, we compare partially adaptive processing performance with fully adaptive processing performance in the case of the following antenna and signal sources:

• •- array with regularly spaced sensors ;
• •- between 20 and 100 elements ;
• •- between 3 and 20 subarrays ;
• •- a single jammer ;
• •- desired signal from the antenna zenith.

We suggest a method for determining the optimal subarray configurations in this case. An example is given to show that the performance of an antenna with five subarrays is comparable to that of a fully adaptive thirty-element array for eliminating a single jammer with a target at the zenith.     

Cancellation of specular and diffuse jammer multipath using ahybrid adaptive array

It has been demonstrated that specular or diffuse jammer multipath can be canceled to a desired level by using an adaptive array that combines bandwidth partitioning with tapped delay lines. Such hybrid systems are studied. In particular, the author studies an ideal two-element array that uses bandwidth partitioning in both the main and auxiliary channels, with an Mth-order adaptive finite impulse response filter in each subband of the auxiliary. The ability of this system to cancel specular moderately diffuse and diffuse multipath is studied. The combinations of bandwidth partitioning and filter order that can achieve a specified jammer cancellation level are discussed     

Cancellation of jammers and jammer multipath in a GPS receiver

It is demonstrated by simulation that jammers and jammer multipath can be cancelled using an adaptive space-time array, leading to nearly ideal GPS performance     

Experimental phased array radar ELRA with extended flexibility

An update of a phased array radar project with the experimental system ELRA (electronic steerable radar) is given with respect to the extended and improved possibilities for performing measurements and evaluations for different types of radar operation. The variability of waveforms for solid-state transmitters is described. Flexible control of multifunction operation with various search and localization tasks is achieved with a network of microcomputers. Different means of signal processing are used for target detection and estimation. The active receiving array is divided into subarrays, and offers digital beamforming for pattern shaping and adaptive jammer suppression. Experimental results are presented     

Performance of a Modified Applebaum Adaptive Array

The performance of a modified Applebaum adaptive array is studied. The new array is obtained by removing the desired signal component from the output signal fed back to the correlator of an Applebaum type adaptive array. Various signal scenarios, including single desired signals or multiple simultaneous desired signals are examined. The new array is less sensitive to beam pointing errors and does not cause power inversion of desired signals. In the case of multiple simultaneous desired signals, the new array does not degrade the SNRs of strong desired signals.     

An Lms Adaptive Array Using a Pilot Signal

A least mean square (LMS) adaptive array requires a reference signal. When the desired signal contains a pilot signal, it may be used as the reference signal. In this paper the steady-state performance of an LMS adaptive array in which the pilot signal is used as the reference signal is examined. It is shown that the LMS adaptive array occasionally suppresses the desired signal. The loop gain, which is an important parameter, is also considered.     

Blind GPS receiver with a modified despreader for interference suppression

The global positioning system (GPS) was designed to provide location estimates for various civilian and military applications using at least four satellites. Since GPS signals have a low signal-to-noise ratio (SNR), they also have a low signal-to-jammer ratio so that the accuracy of location estimates is influenced by cochannel interference and intentional jammers. We propose a low-complexity blind adaptive receiver that is based on a novel modified despreader and the constant modulus (CM) array. This system is capable of ing directional interference and capturing the GPS signal of interest without requiring explicit angle-of-arrival (AOA) information. We also consider the multiple satellite problem and extend the proposed receiver to capture several GPS signals of interest. Representative computer simulation examples are presented to illustrate the performance of the multicomponent system for the suppression of different jammer types.     

Adaptive digital beamforming for angle estimation in jamming

A radar digital beamforming (DBF) architecture and processing algorithm is described for nulling the signal from a mainlobe electronic jammer and multiple sidelobe electronic jammers while maintaining monopulse angle estimation accuracy on the target. The architecture consists of a sidelobe jamming (SLJ) cancelling adaptive array (AA) followed by a mainlobe jamming (MLJ) canceller. A mainlobe maintenance (MLM) technique or constrained adaptation during the sidelobe cancellation process is imposed so that the results of the SLJ cancellation process do not distort the subsequent mainlobe cancellation process. The SLJ signals and the MLJ signals are thus cancelled sequentially in separate processes. This technique was developed for improving radar processing in determining the angular location of a target, and specifically for improving the monopulse technique by maintaining the accuracy of the target echo monopulse ratio in the presence of electronic jamming by adaptive suppression of the jamming signals before forming the monopulse sum and difference beams     

The Performance of an LMS Adaptive Array with Frequency Hopped Signals

The performance of an LMS adaptive array with a frequency hopped, spread spectrum desired signal and a CW interference signal is examined. It is shown that frequency hopping has several effects on an adaptive array. It causes the array to modulate both the amplitude and the phase of the received signal. Also, it causes the array output SINR (signal-to-interference-plus-noise ratio) to vary with time and thus increases the bit error probability for the received signal. Typical curves of the desired signal modulation and the time-varying SINR at the array output are presented. It is shown how the array performance depends on hopping frequency, frequency jump size, interference frequency, signal arrival angles, and signal powers.     

An LMS Adaptive Array for Multipath Fading Reduction

Multipath fading often poses a serious hindrance in radiocommunication. The application of a least-mean-square (LMS)adaptive array to the problem of multipath fading reduction is discussed. However, it is known that multipath components are in general correlated with one another. We examine the effect of the correlation on the performance of the LMS adaptive array. When the correlation coefficient does not equal or approximate 1, the LMS adaptive array suppresses the multipath signals significantly by nulling. On the other hand, when the correlation coefficient nearly equals 1, the LMS adaptive array prevents the output signalpower from decreasing. Therefore, the LMS adaptive array mayreduce the multipath fading effectively for any correlation coefficient value. A reference signal in the LMS adaptive array is also discussed. It is shown that synchronization in the referencesignal generation must be extremely accurate. Moreover, aprocessor configuration is proposed which may generate thereference signal with the required accuracy.     

Adaptive Array Behavior with Periodic Envelope Modulated Interference

A method is presented for determining the effects of envelope modulated interference on a least mean square (LMS) adaptive array. The interference is assumed to have periodic envelope modulation with a bandwidth that is small compared with the carrier frequency. For such interference, the method allows one to calculate the periodic steady-state behavior of the array weights and the resulting array performance. As an example, we compute the effects of an ordinary amplitude modulated (AM) interference signal on the array. It is shown that such interference causes the array to modulate the desired signal envelope but not its phase. With a differential phase-shift-keyed (DPSK) desired signal, AM interference is found to have about the same effect on bit error probability as CW interference.     

圆台阵列杂波模型及空时二维自适应处理

针对圆台共形阵列,建立了空时二维自适应处理(STAP)的杂波模型,给出了圆台阵列杂波抑制最优权值的计算方法。在此基础之上,为了实现可应用到实际环境中的自适应处理方法,进一步讨论了将局部联合域(JDL)降维算法推广至圆台阵列中的问题。得出了圆台阵列JDL算法降维变换矩阵的表达形式,研究了参考波束的数目选取、波束指向等因素对降维损失的影响。理论分析以及仿真结果表明,通过合理选择通道数、波束方位向指向间隔等参数,该算法能够减少自适应波束形成的计算量,而且可以用较少的训练样本获得较好的处理性能。     

Adaptive Array Behavior with Periodic Phase Modulated Interference

We consider a least mean square (LMS) adaptive array [1] receiving a phase modulated interference signal. The phase modulation is assumed to be periodic and to have finite bandwidth. Under these assumptions, we determine the time-varying array weights, the modulation on the array output desired signal, and the time-varying output interference-to-noise ratio (INR) and SINR (signal-to-interference-plus-noise ratio). We present numerical results describing the behavior of a 2-element adaptive array that receives an interference signal with sinusoidal phase modulation. We show how each signal parameter (arrival angle, power, modulation index, and modulation frequency) affects the performance of the array.     

基于约束最小冗余线阵与干扰对消的测向方法

针对有源干扰背景下信号源和干扰源的个数超过线阵的自由度而产生线阵饱和现象,提出一种将约束最小冗余线阵与干扰对消技术相结合的测向方法。通过将无源状态和有源状态下线阵输出数据的协方差矩阵进行对消运算去除有源干扰和噪声分量,并对约束最小冗余线阵的波达方向(DOA)估计算法进行改进,构造了新的协方差Toeplitz矩阵,有效抑制了由阵列非均匀性导致的伪峰,提高了阵列的DOA估计性能。仿真结果表明:该算法在低信噪比背景下具有抗有源干扰能力,扩展了阵列孔径,并具有较高的测向精度和鲁棒性。     

Analysis of a Signal Processor for an Antenna Array

A signal processor that provides ratio-squared predetection combining, has been investigated for application in an adaptive antenna array. The analysis and experimental data presented here pertain to the signal processing gain when the antenna array is illuminated by a coherent signal source and a partially coherent noise source. For a noise source which is coherent, the processing gain depends on relative strength of the signal and noise, relative directions of arrival, and the usual "array factor." The array exhibits capturing effects much as in an FM receiver. The effective antenna pattern is a superposition of two beams of different magnitudes, one directed to the signal source and the other to the noise source. When the noise is partially coherent, the behavior of the signal processor is quite complex. Analytical prediction and experimental simulation measurement on a four-channel system indicate that the partially coherent noise may be regarded as the source of an incoherent noise component plus a coherent noise component with the magnitude of the latter determined by the coherence coefficient for the noise source.     

2-D spatial smoothing for multipath coherent signal separation

The use of two-dimensional spatial smoothing (SS) to increase channel capacity of wireless communications system is discussed, The necessary and sufficient conditions on array configuration for applying SS to multiple signal classification (MUSIC), and adaptive beamforming algorithms are defined and proved, This array must have an orientational invariance structure with an ambiguity free center array, and the number of subarrays must be larger than or equal to the size of the largest group of coherent signals. We also studied the cause of ambiguities in a multipath environment. We found the necessary and sufficient conditions for a three-sensor array manifold to be ambiguity free and identified several higher order ambiguity situations, If an array is also central symmetric, the forward/backward SS (FBSS) can be used to improve the resolution. Finally, we extended our results to the estimation of signal parameters via rotational invariance techniques (ESPRIT). All the predicted results are verified by simulations