共查询到20条相似文献,搜索用时 62 毫秒
1.
2.
角度随机游走是光纤陀螺的一个重要技术指标,也是高精度光纤惯导系统的一项重要误差源。为了深入了解角度随机游走误差对系统精度的影响,从统计角度研究了该误差在导航过程中的传播特性。通过将角度随机游走对系统的影响等效为不相关的随机脉冲序列激励下的系统输出,推导了角度随机游走作用下导航误差的理论公式并进行了仿真验证。结果表明,所给出的理论表达式能够很好地描述角度随机游走误差的传播规律。通过解析表达式,可以在任意时间段对任何一只陀螺角度随机游走造成的系统误差进行定量分析,这对于系统性能评估、误差分析和设计工作都具有重要意义。 相似文献
3.
各种随机噪声是激光陀螺误差的主要来源。为了减小激光陀螺的随机误差,建立了激光陀螺随机漂移数据的时间序列模型,设计了基于激光陀螺随机漂移数据时间序列模型的经典卡尔曼滤波器,对激光陀螺随机漂移数据进行了卡尔曼滤波,并针对经典卡尔曼滤波的不足,利用简化Sage—Husa自适应滤波算法对激光陀螺漂移数据进行处理,取得了较好的结果。滤波结果表明,简化的Sage—Husa自适应滤波优于经典卡尔曼滤波,并验证了简化的合理性。 相似文献
4.
5.
6.
7.
介绍了国外常用于评估环形激光陀螺和其它精密测量仪器性能的Allan方差法,讨论了环形激光陀螺的随机噪声特性,应用Allan方差法对激光陀螺输出数据进行了分析,分离出各项误差的系数,结果表明Allan方差法是一种有效的误差特性分析方法。 相似文献
8.
为了选取合适的调制深度以提高星载光纤陀螺在空间辐射环境下的工作性能,通过对闭环光纤陀螺输出信号的信噪比分析建立了光纤陀螺随机游走系数与调制深度的关系的模型。根据该模型对光纤辐射致衰减、光纤长度、光源光功率对最优调制深度的影响进行了仿真研究。结果表明:光纤辐射致衰减越小、光源光功率越大,则光纤陀螺的最优调制深度越大,且相应的随机游走系数越小。增加光纤长度将降低光纤陀螺的最优调制深度,当光纤衰减较大且光纤较长时,过调制技术可能会使光纤陀螺性能恶化。因此,在星载光纤陀螺的设计过程中应根据实际情况对调制深度进行优化,以保证陀螺获得最优的工作性能。理论分析和仿真结果为星载光纤陀螺最优调制深度的选取提供了依据。 相似文献
9.
10.
11.
介绍了一种新的刚体转动的四元数模型。这些模型可以提高再定向控制的对边界条件的适应能力,在此基础上还介绍了这些模型的一些实际应用。 相似文献
12.
A. A. Davydov 《Cosmic Research》2011,49(4):335-344
A communication satellite (small spacecraft) injected into a geosynchronous orbit is considered. Flywheel engines are used
to control the rotational spacecraft motion. The spacecraft after the emergency situation has passed into a state of uncontrolled
rotation. In this case, no direct telemetric information about parameters of its rotational motion was accessible. As a result,
the problem arose to determine the rotational satellite motion according to the available indirect information: current taken
from the solar panels. Telemetric measurements of solar panel current obtained on the time interval of a few hours were simultaneously
processed by the least squares method integrating the equations of rotational satellite motion. We present the results of
processing 10 intervals of the measurement data allowing one to determine the real rotational spacecraft motion and to estimate
the total angular momentum of flywheel engines. 相似文献
13.
The problem of optimal control over many-revolution spacecraft orbit transfers between circular coplanar orbits of satellites is considered. The spacecraft flight is controlled by a thrust vector of a jet engine with restricted thrust (JERT). The mass expenditure is minimized at a limited time of flight. The optimal control problem is solved based on the maximum principle. The boundary value problem of the maximum principle is solved numerically using the shooting method. A modified computation scheme of the shooting method is suggested (multi-point shooting), as well as a method (correlated with the scheme) of choosing the initial approximation with the use of a solution to the optimization problem in the impulse formulation. The scheme and method allow one to construct many-revolution spacecraft orbit transfers. 相似文献
14.
热变形对天线指向机构的指向精度具有重要影响,但利用传统的设计方法很难实现对指向精度的准确计算,尤其是热变形对指向精度影响的研究工作更是少见。为此建立了机构的三维实体热-结构耦合有限元分析模型,根据有限元分析结果并结合机构的运动链关系,构建了各关键运动副运动误差的计算方法;在此基础上实现了机构指向误差的计算,研究了运动副名义、最大以及最小配合间隙条件下,温度载荷对各关键运动副运动误差和指向精度的影响。研究结果表明,温度载荷对关键运动副的运动误差以及机构的指向精度具有重要影响,随着温度载荷偏离常温数值的增加,指向误差不断增大,名义配合间隙条件下的指向误差最大。 相似文献
15.
16.
为满足航天器微振动环境模拟的需要,开展了多自由度微振动时域波形复现控制方法研究。首先,介绍了基于时域波形复现的多自由度微振动环境模拟控制理论方法。其次,针对六自由度微振动激励系统,应用MATLAB软件建立了基于实测传递函数矩阵的多输入多输出微振动激励仿真系统,针对微振动时域波形复现闭环控制过程进行了算法编程,并给出了仿真的闭环控制流程图。最后,通过算例对多自由度微振动时域波形复现进行了数值仿真,以给定的白噪声为输入,模拟对实际存在的系统非线性、测量误差等影响因素的控制效果。仿真结果验证了多自由度微振动时域波形复现控制方法的可行性及有效性,所得结论可以为研究多自由度微振动时域波形复现控制系统提供参考。 相似文献
17.
18.
10月14日,国际空间大学董事会主席拉姆·哈迪姆访问中国航天科技集团公司,就集团公司承办国际空间大学2007年暑期进修项目的筹备情况与集团公司人力资源部部长陈学钏、副部长白燕强交换了意见。陈学钏部长向哈迪姆通报了集团公司筹备这次活动的工作进展情况。据陈部长介绍,中国 相似文献
19.
The problem of determining an estimation of current spacecraft motion parameters on the stage of its descent is solved on the basis of readings of an optoelectronic navigation system and additional information from the self-contained inertial navigation system at the most general assumptions on the nature of motion of the object and the statistical properties of the noise of the measuring devices. 相似文献